| 3 | 1/1 | 返回列表 |
| 查看: 571 | 回復: 2 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
haizhoubuer新蟲 (初入文壇)
|
[求助]
親們,江湖告急,求翻譯!有關高吸水性樹脂的合成與溶脹性能
|
|
| The selection of the initiator and the dosage directly affects the reaction process and its results. Dosage determines the number of active sites in a system, which affects the reaction rate. The reaction rate is a very important factor for controlling experiments (Ma et al., 2011). Fig. 1(e) shows the effect of the initiator dosage on the resin absorption rate in distilled water and salt solutions. Furthermore, as the initiator concentration was increased, the absorbency of the resin, both in distilled water and salt solutions, initially increased, and decreased thereafter. When the initiator dosage accounted for 0.3% of the total monomer, the water absorbency of the resin for both distilled water and 0.9 wt.% NaCl was the highest at 1183 g/g and 117.6 g/g, respectively. Lower dosages result in a very few active sites in the reaction system, which do not allow the resin to form an effective three-dimensional cross-linked structure. |
至尊木蟲 (知名作家)
Translator and Proofreader
| 引發劑和劑量的選擇直接影響的反應過程及其結果。劑量決定了系統中活性位點的數目,進而影響反應速率。對控制實驗而言,反應速度是一個非常重要的因素(Ma等,2011)。圖1(e)顯示了引發劑的劑量對樹脂在蒸餾水和鹽溶液中的吸收率的影響。另外,隨著引發劑濃度的增加,樹脂無論在蒸餾水或鹽溶液中的吸水性先增加后降低。當引發劑用量占總單體的0.3%時,樹脂在蒸餾水和0.9%NaCl(重量百分比)的吸水率是最高的,分別為1183克/克和117.6克/克分別。較低劑量在反應體系中只引起非常少的活性位點,使樹脂不能形成有效的三維交聯結構。 |
新蟲 (初入文壇)
| 3 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 085600材料與化工306 +4 | z1z2z3879 2026-03-21 | 4/200 |
|
|---|---|---|---|---|
|
[考研] 269專碩求調劑 +5 | 金恩貝 2026-03-21 | 5/250 |
|
|
[考研] 廣西大學材料導師推薦 +3 | 夏夏夏小正 2026-03-17 | 5/250 |
|
|
[考研] 求調劑 +5 | 十三加油 2026-03-21 | 5/250 |
|
|
[考研] 22 350 本科985求調劑,求老登收留 +3 | 李軼男003 2026-03-20 | 3/150 |
|
|
[考研] 332求調劑 +3 | 鳳凰院丁真 2026-03-20 | 3/150 |
|
|
[考研] 0856材料專碩353求調劑 +3 | NIFFFfff 2026-03-20 | 3/150 |
|
|
[考研] 332求調劑 +4 | ydfyh 2026-03-17 | 4/200 |
|
|
[考研] 304求調劑 +6 | 曼殊2266 2026-03-18 | 6/300 |
|
|
[考研] 304求調劑 +7 | 司空. 2026-03-18 | 7/350 |
|
|
[考研] 一志愿武漢理工材料工程專碩調劑 +9 | Doleres 2026-03-19 | 9/450 |
|
|
[考研] A區線材料學調劑 +5 | 周周無極 2026-03-20 | 5/250 |
|
|
[考研] 261求B區調劑,科研經歷豐富 +3 | 牛奶很忙 2026-03-20 | 4/200 |
|
|
[考研] 344求調劑 +6 | knight344 2026-03-16 | 7/350 |
|
|
[考研] 312求調劑 +8 | 陌宸希 2026-03-16 | 9/450 |
|
|
[考研] 0703化學調劑 +3 | 妮妮ninicgb 2026-03-17 | 3/150 |
|
|
[考研] 材料工程專碩274一志愿211求調劑 +6 | 薛云鵬 2026-03-15 | 6/300 |
|
|
[考研] 一志愿,福州大學材料專碩339分求調劑 +3 | 木子momo青爭 2026-03-15 | 3/150 |
|
|
[考研] 一志愿211 0703方向310分求調劑 +3 | 努力奮斗112 2026-03-15 | 3/150 |
|
|
[考研] 085601材料工程315分求調劑 +3 | yang_0104 2026-03-15 | 3/150 |
|