 |
 |
 |
 |
 |
 |
||
 |
 |
 |
 |
 |
| 5 | 1/1 | 返回列表 |
| 查看: 810 | 回復: 8 | |||
| 本帖產生 1 個 翻譯EPI ，點擊這里進行查看 | |||
| 當前只顯示滿足指定條件的回帖，點擊這里查看本話題的所有回帖 | |||
[求助]
金屬材料類，漢譯英， 一段話，求潤色，麻煩英語好的幫我看一下。謝謝。
|
|||
|
表1可知，不同溫度下樣品KS和LS的模量差值的大小順序?yàn)?#8710;E500<∆E200<∆E20,塑性差值的大小順序?yàn)?#8710;S500<∆S200<∆S20，即在20°C時，樣品KS和LS的模量差值和塑性差值最大，200°C時次之，500°C時最小。這種在不同溫度的模量差值和塑性差值的不同可能與兩個樣品不同的微觀結構有關。 在200°C時，樣品KS的綜合效能要大于樣品LS，而在20°C和500°C時，樣品LS的綜合效能要大于樣品KS。說明在20°C時，樣品LS的綜合效能發揮到最佳，而樣品KS在高于200°C時，其綜合效能發揮到最佳。 對于樣品KS和LS而言，結構的強度提高時其塑性則會減小，這表明結構的強度和塑性是難以兼顧的，結構高強度的獲得是以犧牲其部分塑性為代價的，因此，今后應考慮在保證結構的強度的前提下來提高其塑性。 As shown in table 1, the order of modulus difference value for samples LS and KS was ΔE500 <ΔE200 <ΔE20 in different temperatures, and the order of plastic difference value for samples LS and KS was ΔS500 <ΔS200 <ΔS20. The modulus difference value of the sample KS and LS is the most at 20°C, the second at 200°C, and the smallest at 500°C. The difference between the modulus and plastic difference value may be due to the distinct microstructures of two samples. At 200 °C, the comprehensive efficiency of the sample KS was greater than the sample LS, while at 20 °C and 500 °C, the comprehensive efficiency of the sample LS is greater than the sample KS, Which indicated that at 20 ° C, the comprehensive efficiency of sample LS play to the best and at above 200 ° C, sample KS play to the best of its comprehensive efficiency. For sample KS and LS, the improvement of the structure strength means the reducing plastic, which indicated that the strength and ductility of the structure is difficult to balance and the high strength is obtained at the expense of the cost of the plastic, therefore, the future should consider increasing its plasticity in the premise of ensuring the strength of the structure. |
回復此樓» 猜你喜歡
323求調劑
已經有6人回復
-
一志愿北京化工大學 070300 學碩 336分 求調劑
已經有4人回復
-
352求調劑
已經有3人回復
-
一志愿東華大學化學070300，求調劑
已經有8人回復
-
277材料科學與工程080500求調劑
已經有7人回復
-
317求調劑
已經有18人回復
-
293求調劑
已經有5人回復
-
280分求調劑 一志愿085802
已經有7人回復
-
0854電子信息求調劑
已經有3人回復
-
263求調劑
已經有4人回復
【答案】應助回帖
★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
wxqtjw: 金幣+20 2014-07-14 14:27:07
wxqtjw: 金幣+20 2014-07-14 14:27:07
|
For sample KS and LS, when the strength of structure is improved,the plastic of structure would be reduced. It has indicated that the strength and ductility of the structure are difficult to reach equilibrium and the higher strength is obtained at the expense of the cost of the plastic.Therefore, we should focus on increasing its plasticity in the premise of ensuring the strength of the structure. 你自己翻譯的很不錯，我都不知道怎么改  |
4樓2014-07-11 15:16:36
【答案】應助回帖
★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
真強必勝: 金幣+1, 多謝 2014-07-12 11:34:02
wxqtjw: 金幣+30, ★★★★★最佳答案 2014-07-14 14:27:22
真強必勝: 金幣+1, 多謝 2014-07-12 11:34:02
wxqtjw: 金幣+30, ★★★★★最佳答案 2014-07-14 14:27:22
| 第一段As shown in table 1, the order of modulus difference value for samples LS and KS was ΔE500 <ΔE200 <ΔE20 in different temperatures，and the order of plastic difference value for samples LS and KS was ΔS500 <ΔS200 <ΔS20.The modulus difference value and plastic difference value of the sample KS and LS will be maximum when the temprature is 20°C, and 200 ° C followed by time, 500°C is the minimum. The difference between the modulus and plastic difference value in diffrent tempratures may be due to the distinct microstructures of two samples. |
2樓2014-07-11 14:51:15
【答案】應助回帖
★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
真強必勝: 金幣+1, 多謝 2014-07-12 11:34:09
wxqtjw: 金幣+15 2014-07-14 14:27:14
真強必勝: 金幣+1, 多謝 2014-07-12 11:34:09
wxqtjw: 金幣+15 2014-07-14 14:27:14
| 第二段At 200 ° C, the comprehensive effectiveness of the sample KS is greater than the sample LS，while at 20 °C and 500 °C, the comprehensive efficiency of the sample LS is greater than the sample KS. It has shown that the comprehensive efficiency of sample LS play to the best when the temprature is 20°C and sample KS has the best comprehensive efficiency at above 200 ° C. |
3樓2014-07-11 15:04:06
RXMCDM
版主 (文壇精英)
- 翻譯EPI: 530
- 應助: 401 (碩士)
- 貴賓: 1.908
- 金幣: 38947.6
- 散金: 4908
- 紅花: 88
- 沙發: 4
- 帖子: 11453
- 在線: 1355.6小時
- 蟲號: 2739168
- 注冊: 2013-10-20
- 性別: GG
- 專業: 一般管理理論與研究方法論
- 管轄: 論文翻譯
|
For sample of KS and LS, the improvement of the structure strength means the reducing of plastic indicated that it is difficult to balance the strength and ductility of the structure , high strength is obtained at the expense of plastic reduce , and, future research/development should increase its plasticity in the premise of ensuring the strength of the structure. |
5樓2014-07-11 16:19:11
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 352求調劑 +3 | 大米飯！ 2026-03-22 | 3/150 |
|
|---|---|---|---|---|
|
|
[考研] 298求調劑 +6 | 上岸6666@ 2026-03-20 | 6/300 |
|
|
|
[考研] 310求調劑 +4 | baibai1314 2026-03-16 | 4/200 |
|
|
|
[考研] 298求調劑一志愿211 +3 | 上岸6666@ 2026-03-20 | 3/150 |
|
|
|
[考研] 085600材料與化工306 +4 | z1z2z3879 2026-03-21 | 4/200 |
|
|
[考研] 資源與環境 調劑申請(333分) +5 | holy J 2026-03-21 | 5/250 |
|
|
|
[考研] 廣西大學材料導師推薦 +3 | 夏夏夏小正 2026-03-17 | 5/250 |
|
|
|
[考研] 化學調劑 +5 | yzysaa 2026-03-21 | 5/250 |
|
|
|
[考研] 機械專碩299求調劑至材料 +3 | kkcoco25 2026-03-16 | 4/200 |
|
|
|
[考研] 材料工程（專）一志愿985 初試335求調劑 +3 | hiloiy 2026-03-17 | 4/200 |
|
|
|
[考研] 材料 336 求調劑 +3 | An@. 2026-03-18 | 4/200 |
|
|
|
[考研] 274求調劑 +10 | S.H1 2026-03-18 | 10/500 |
|
|
|
[考研] 304求調劑 +7 | 司空. 2026-03-18 | 7/350 |
|
|
|
[考研] 一志愿西安交通大學 學碩 354求調劑211或者雙一流 +3 | 我想要讀研究生 2026-03-20 | 3/150 |
|
|
|
[考研] 298-一志愿中國農業大學-求調劑 +9 | 手機用戶 2026-03-17 | 9/450 |
|
|
|
[考研] 344求調劑 +6 | knight344 2026-03-16 | 7/350 |
|
|
|
[考研] 085601專碩，總分342求調劑，地區不限 +5 | share_joy 2026-03-16 | 5/250 |
|
|
|
[考研] 312求調劑 +8 | 陌宸希 2026-03-16 | 9/450 |
|
|
|
[考研] 材料，紡織，生物（0856、0710），化學招生啦 +3 | Eember. 2026-03-17 | 9/450 |
|
|
|
[考研] 301求調劑 +4 | A_JiXing 2026-03-16 | 4/200 |
|