| 5 | 2/1 | 返回列表 |
| 查看: 2455 | 回復: 15 | ||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | ||
linsoklove金蟲 (著名寫手)
|
[求助]
各位幫我分析理解一下審稿意見,讓我知道該怎么回答 已有4人參與
|
|
|
今天終于收到了審稿意見,但是由于英文不太好,也由于太過于緊張了吧,現在一臉茫然。還希望各位幫我分析一下該如何回答。審稿意見如下: Comments from the editors and reviewers: -Reviewer 1 - Strengths: The problem shown in the manuscript is interesting and well defined. The solving method may be interesting for other researchers. The application of results may lead to increase heat transfer capabilities which is within the scope of the Journal. The CFD simulation is compared with some experimental results. Most of the model parameters are explained. Weaknesses: The main interest for readers would be the simulation method which is described, but some more details could be given such as mesh details (the picture is informative, but number of cells, cell and shape in all regions could be given explicitly). The comparison with the experiment is shown only for offset angle, is it possible to address also at least qualitatively the thickness of the layer? Maybe for one case only but some remarks could be important for other researchers. The minimal flow for sur wetting could be simulated using this method? There is a small mistyped number in Fig 3b experiment shall be 200 instead of 100. -Reviewer 2 - Dear Author, This is well-written article that does identify an important gap in xxxx. There has been a few researches on xxxx reported in open literature. However, the article would be significantly improved with the addition of more review of the xxxx. This is because the review of the literature is not thorough for study of xxxx; because the author only referred to two articles which were published in 2014 and 2007, which has a big gap almost 10 years. The author did not critically review xxxx in the Introduction. This helps to show that this parameter is important to characterize xxxx. The details of my comments and suggestions are attached with this reviewer comments. |
金蟲 (著名寫手)
金蟲 (著名寫手)
榮譽版主 (文壇精英)

| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 哈爾濱工業大學材料與化工專碩378求調劑 +3 | 塔比烏斯 2026-03-30 | 3/150 |
|
|---|---|---|---|---|
|
[考研] 一志愿北京化工大學材料與化工(085600)296求調劑 +25 | 稻妻小編 2026-03-26 | 25/1250 |
|
|
[考研] 085601材料工程找調劑 +17 | oatmealR 2026-03-29 | 18/900 |
|
|
[考研] 085600 材料與化工 329分求調劑 +18 | Mr. Z 2026-03-25 | 19/950 |
|
|
[考研] 342求調劑 +4 | 加油a李zs 2026-03-26 | 4/200 |
|
|
[考研] 311求調劑 +10 | lin0039 2026-03-26 | 10/500 |
|
|
[考研] 291求調劑 +5 | Y-cap 2026-03-29 | 6/300 |
|
|
[考研] 332求92調劑 +8 | 蕉蕉123 2026-03-28 | 8/400 |
|
|
[考研] 279求調劑 +4 | 蝶舞輕繞 2026-03-29 | 4/200 |
|
|
[考研] 調劑 +3 | 好好讀書。 2026-03-28 | 3/150 |
|
|
[考研] 286求調劑 +4 | 丟掉懶惰 2026-03-27 | 7/350 |
|
|
[考研] 352分 化工與材料 +5 | 海納百川Ly 2026-03-27 | 5/250 |
|
|
[考研] 272求調劑 +7 | 腳滑的守法公民 2026-03-27 | 7/350 |
|
|
[考研] 一志愿南師大0703化學 275求調劑 +4 | Ripcord上岸 2026-03-27 | 4/200 |
|
|
[考研] 085600,材料與化工321分調劑 +4 | 大饞小子 2026-03-27 | 6/300 |
|
|
[考研]
|
WWW西西弗斯 2026-03-24 | 8/400 |
|
|
[考研] 一志愿天津大學339材料與化工求調劑 +3 | 江往賣魚 2026-03-26 | 3/150 |
|
|
[考研] 296求調劑 +4 | 汪!?! 2026-03-25 | 7/350 |
|
|
[考研] 一志愿武理085500機械專業總分300求調劑 +3 | an10101 2026-03-24 | 7/350 |
|
|
[考研] 一志愿北化315 求調劑 +3 | akrrain 2026-03-24 | 3/150 |
|