24小時熱門版塊排行榜

北京石油化工學院2026年研究生招生接收調劑公告

返回列表

沫汐-靜

木蟲 (小有名氣)

應助: 0 (幼兒園)
金幣: 1981.8
帖子: 79
在線: 52.8小時
蟲號: 2512249
注冊: 2013-06-18
性別: MM
專業: 中藥資源

[求助] 揮發油抑制酪氨酸酶的溶解性問題

請問有沒有人做揮發油的酪氨酸酶抑制試驗，我的樣品室揮發油，溶解在DMSO或乙醇中，但是當PBS緩沖液加在樣品以后，DMSO或乙醇濃度降低，不足以是揮發油溶解，導致?lián)]發油析出，呈現為小油滴，使得反應體系渾濁，同時也不可測得揮發油真實的抑制率，求哪位大俠遇到過這種問題，解釋這一現象，并解決

回復此樓

» 猜你喜歡

一志愿哈爾濱工業大學材料與化工方向336分已經有8人回復
藥學105500求調劑已經有3人回復
考研調劑已經有4人回復
0703化學 已經有7人回復
291求調劑已經有20人回復
學碩274求調劑已經有6人回復
321求調劑已經有6人回復
085600，材料與化工321分求調劑已經有3人回復
【求調劑】085601材料工程專碩 | 總分272 | 已經有6人回復
0856，材料與化工321分求調劑已經有13人回復

………………

1樓 2016-04-18 19:56:13

已閱關注TA 給TA發消息送TA紅花 TA的回帖

bonzu

新蟲 (小有名氣)

應助: 2 (幼兒園)
金幣: 669.6
散金: 52
紅花: 2
帖子: 59
在線: 36.1小時
蟲號: 2189175
注冊: 2012-12-16
性別: GG
專業: 天然藥物化學

Set up progressive dilution of the essential oil (EO) in Ethanol 60% (start from an original dilution od 1:100 corresponding to about 0.0087 g/mL of oil and then progressively dilute 2-1.5 fold in EtOH 60%, at each dilution vortex extensively. Vortex well the dilution just before adding it to 200 ul of final reaction: add 10 uL of the dilution, but you can even add 5 uL in 200 uL to improve solubility (final EtOH 1,5%). When the enzyme is added to start reaction, mix very well again by pipetting in the single wells and by programming a shaking of the plate in the plate-reader instrument, if possible. Some cloudiness may be neglected. Indeed, as we monitored the delta absorbance per time, the initial absolute absorbance was almost irrelevant: what you need is 1) the reaction takes place; 2)the difference value between Abs at time zero and Abs at the end.

I have also experienced some problem in solubility. Actually final concentration above 430 ug/mL could not be achieved and, in some replicas, at these high concentrations (about 400ug/mL) solution could look cloudy: just mix very well by pipetting and use the correct incubation temperature; because your oil might be slightly different in composition from what I used, and this could affect solubility, too, I suggest you could use dilutions of 350-200 ug/mL as maximum final concentrations of the EO in the reaction mix. At such concentrations you should not have problems in dissolving the EO….

Another possibility is to use DMSO at 60% or higher to solubilize the EO: we have been using this solvent for another set of Eos (unpublished data) because it performed better than ethanol, but this depends also, as I said, on the specific type and composition of the EO…

贊一下

回復此樓

2樓2016-04-18 20:00:52