 |
 |
 |
 |
 |
 |
||
 |
 |
 |
 |
 |
| 5 | 1/1 | 返回列表 |
| 查看: 2261 | 回復: 18 | |||
| 【懸賞金幣】回答本帖問題，作者gc452將贈送您 50 個金幣 | |||
| 當前只顯示滿足指定條件的回帖，點擊這里查看本話題的所有回帖 | |||
gc452金蟲 (著名寫手)
|
[求助]
蟲友們，幫忙給點建議�。∈欠g成中文投稿呢，還是？？ 已有4人參與
|
||
|
畢業工作了8年，心血來潮寫了艱難的寫了一篇英文論文，已經第五次被拒了，都不知怎么辦了？是翻譯成中文投了算了，還是繼續改了頭英文的？繼續的話有什么好建議嘛？謝謝 這是最后一次投稿返回的審稿建議�。∠x友們給點意見嘛 PONE-D-21-16128 Dear Dr. XX, Thank you for submitting your manuscript to PLOS ONE. After careful consideration, we have decided that your manuscript does not meet our criteria for publication and must therefore be rejected. The referees rose important questions that cannot be solved by a revision. I am sorry that we cannot be more positive on this occasion, but hope that you appreciate the reasons for this decision. Yours sincerely, Pasquale Avino, Ph.D. Academic Editor PLOS ONE Reviewers' comments: Reviewer #1: In the manuscript entitled "xxxxxxx", the authors reported a method for the multi-element analysis in the geological samples. The manuscript lacks clarity in many places. There are incomplete and ill constructed sentences that demand correction throughout the text. The treatments involved for the optimization in the manuscript are not clear for reader to follow. It seems that a “technical note” rather than a “research article” would be more appropriate. Please explain more clearly what the novelty and advantage of your approach is, compared to already existing papers. You cite studies on the same topic, so one might wonder why your work was necessary at all. This applies mainly for the introduction but also a bit for the discussion and conclusion. For the specific comments that demand adjustment, see below. Title: Delete “simultaneous”. Line 8. Method Line 11. Replace 1 with l: HCl-HNO3-HF-HClO4 Line 12. Change the color of the text: The instrumental operating parameters are optimized Lines 15-17. Please explain the following sentence: Therefore, the standard solution for drawing standard curve is prepared by dissolving simultaneously the certified reference material with the samples, the matrix effect caused by different viscosity of solution is further eliminated. Line 17. Delete “The elements of” -> “Barium, Be, Co, Cu, Li, Mn, Ni, Pb, Sc, Sr, Ti, V, and Zn. Lines 19-24. The methods are used to determine the certified reference material of stream sediment, soil and rock. The obtained results are in agreement with the certified values, the relative standard deviation (RSD) is less than 10% except for Ta, and the relative errors (RE) are all within the 16% for all elements. Line 23. Relative errors (RE) are bias%? Lines 24-25. The method has high accuracy and allows the determination of 51 elements… Line 37. Please explain “small self-absorption effect” Line 41. It is not correct to write simultaneous determination of elements. ICP-MS allows a sequential determination of the elements. Please correct all text in agreement. Line 49. Replace 1 with l: HCl-HNO3-HF-HClO4, please correct throughout the text. Line 50. Check the space: “micro，trace” Line 51. “… rare element were determined by the ICP-OES and ICP-MS” Line 54. Lack of comprehensive statistical analysis. Appropriate method comparison statistics is missing. Line 55. Instruments and operating conditions Line 59. Table 1. All initials in capital letters: RF power, Cooling gas flow etc. Lines 60-63. Company information should be given for all used instruments and reagents such as MilliQ-system and HCl, HNO3, HF, and HClO4 … as COMPANY (CITY, COUNTRY). In addition, authors should inform which standard solutions were used for the calibration curves. Line 70. “A sample mass (~0.25 g) was accurately weighed…” Lines 78-79. Please indicate the internal standard used for the ICP-OES analysis. Lines 81-83. Arrange the elements in alphabetical order. Line 84. Calibration standard curves Lines 85-87. Please explain. It is not clear what was done. Was the standard addition method used? The mathematical formula of the curve and the goodness-of-fit of the data to the curve should be described and acceptability ranges for the parameters of the curve should be described. Linearity should be reported and values of the upper limit of quantification (ULOQ) would be appreciated. The maximal dynamic range (ULOQ/Lower LOQ) should be discussed in comparison to previously published methods. Line 87. There is no section 2.3 in the text, please explain “procedure of section 2.3 with sample solutions prepared” Line 90. Delete “Interference and calibration” Lines 94-97. It's very confusing. Split into two sentences. Lines 98-102. Delete the sentence. It is a repetition of what was previously written. Line 103. Selected wavelength of elements Line 106. Please what does it mean: ICP-MS has good… strong anti-interference ability Lines 110-112. Delete the following sentence: Therefore, during the analysis by the ICP-MS, the isotope of element, with a less interference, high abundance and high signal intensity is chosen as the analytical element. Line 124 and 173. Tables 4 and 5: please add standard deviation. Line 131. Delete the following sentence: “As shown in Error! Reference source not found.” Lines 148-153. The LOD calculated from 3 times the standard deviation at the blank is probably less accurate than the one using the residuals of the slope. It depends on the performance of the system and not on the preference of the analyst. I strongly suggest using the later, because it will provide a LOD that includes data from the entire measurement range. The classical method is likely to overestimate the analytical performance. In my opinion, both LODs should be presented. It will allow the reader to compare this work with other publications. Line 151: Please explain “As illustrated in 0” Lines 165-166. … are all within the 13% for most elements Line 176. Replace 1 with l: HCl-HNO3-HF-HClO4 Line 181. How is the method rapid and simple? In the “Results and discussion section”, please explain more clearly the novelty and advantage of your approach than already existing papers. Reviewer #2: There is nothing new in this manuscript. There are innumerable number of both spelling and grammatical mistakes. First sentence in abstract starts with a spelling mistake. If you want to improve this manuscript - you have to write and convince why you taken up this study ? What are the problems with earlier studies? What extra you did in this study which is not available in other studies so far? In addition, you have to improve your English. |
回復此樓» 猜你喜歡
265求調劑
已經有4人回復
-
085700資源與環境308求調劑
已經有6人回復
-
一志愿吉林大學材料學碩321求調劑
已經有12人回復
-
286分人工智能專業請求調劑愿意跨考！
已經有3人回復
-
329求調劑
已經有5人回復
-
申請回稿延期一個月，編輯同意了。但系統上的時間沒變，給編輯又寫郵件了，沒回復
已經有4人回復
-
材料學碩318求調劑
已經有5人回復
-
一志愿中國海洋大學，生物學，301分，求調劑
已經有6人回復
-
081700化工學碩調劑
已經有3人回復
-
一志愿蘇州大學材料求調劑，總分315（英一）
已經有3人回復
鄙人認為應該凝煉創新點或者與現有常規技術比較，作者研究的這個方法意義所在，放大之，再投～ 發自小木蟲Android客戶端 |
3樓2021-06-10 21:09:00
2樓2021-06-10 21:05:02
4樓2021-06-10 22:43:21
5樓2021-06-11 00:28:28
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 307求調劑 +9 | 冷笙123 2026-03-17 | 9/450 |
|
|---|---|---|---|---|
|
|
[考研] 288求調劑 +15 | 于海海海海 2026-03-19 | 15/750 |
|
|
|
[考研] 一志愿西安交通大學材料工程專業 282分求調劑 +5 | 楓橋ZL 2026-03-18 | 7/350 |
|
|
[考研] 085600材料與化工調劑 324分 +10 | llllkkkhh 2026-03-18 | 12/600 |
|
|
|
[考研] 324分 085600材料化工求調劑 +3 | llllkkkhh 2026-03-18 | 3/150 |
|
|
|
[考研] 求調劑，一志愿:南京航空航天大學大學 ，080500材料科學與工程學碩，總分289分 +3 | @taotao 2026-03-19 | 3/150 |
|
|
|
[考研] 化學求調劑 +3 | 臨澤境llllll 2026-03-17 | 4/200 |
|
|
|
[考研] 0703化學調劑 +5 | pupcoco 2026-03-17 | 8/400 |
|
|
|
[考研] 材料專碩英一數二306 +5 | z1z2z3879 2026-03-18 | 5/250 |
|
|
|
[考研] 354求調劑 +4 | Tyoumou 2026-03-18 | 7/350 |
|
|
|
[考研] 一志愿武理材料305分求調劑 +5 | 想上岸的鯉魚 2026-03-18 | 6/300 |
|
|
|
[考研] 化學工程321分求調劑 +15 | 大米飯！ 2026-03-15 | 18/900 |
|
|
|
[考研] 08工科 320總分 求調劑 +5 | 梨花珞晚風 2026-03-17 | 5/250 |
|
|
|
[考研] 一志愿西南交大，求調劑 +4 | 材化逐夢人 2026-03-18 | 4/200 |
|
|
|
[考研] 考研求調劑 +3 | 橘頌. 2026-03-17 | 4/200 |
|
|
|
[考研] 301求調劑 +4 | A_JiXing 2026-03-16 | 4/200 |
|
|
|
[考研] 考研化學學碩調劑，一志愿985 +4 | 張vvvv 2026-03-15 | 6/300 |
|
|
|
[考研] 308求調劑 +4 | 是Lupa啊 2026-03-16 | 4/200 |
|
|
|
[考研] 294求調劑 +3 | Zys010410@ 2026-03-13 | 4/200 |
|
|
|
[考研] 304求調劑 +7 | 7712b 2026-03-13 | 7/350 |
|