 |
 |
 |
 |
 |
 |
||
 |
 |
 |
 |
 |
| 5 | 1/1 | 返回列表 |
| 查看: 780 | 回復: 6 | |||
| 本帖產生 1 個 翻譯EPI ，點擊這里進行查看 | |||
| 當前只顯示滿足指定條件的回帖，點擊這里查看本話題的所有回帖 | |||
高興星期五鐵桿木蟲 (著名寫手)
|
[交流]
求助翻譯3
|
||
|
7.12 Microscope objectives can be ruined by exposure to hydrofluoric acid fumes from etchant residue inadvertently left on the specimen. This problem is very common when the specimen or mounting media contain porosity and when the mounting material (such as Bakelite) does not bond tightly to the specimen resulting in seepage along the edges of the specimen. In all cases, extreme care should be taken to remove all traces of the etchant by thorough washing and complete drying of the specimen before placing it on the microscope stage. 7.13 Tint etchants (9, 11-13) are always used by immersion,never by swabbing, as this would inhibit film formation. An extremely high quality polish is required as tint etchants will reveal remaining polishing damage even if it is not visible with bright field illumination. After polishing, the surface must be carefully cleaned. Use a polyethylene beaker to contain the etchant if it contains fluorine ions (for example, etchants containing ammonium bifluoride, NH4 FHF). The specimen is placed in the solution using tongs, polished face up. Gently agitate the solution while observing the polished surface. After coloration begins, allow the solution to settle and remain motionless. Remove the specimen from the etchant when the surface is colored violet, rinse and dry. A light pre-etch with a general-purpose chemical etchant may lead to sharper delineation of the structure after tint etching. 7.14 Specimens should be carefully cleaned before use of a vapor-deposition interference film (“Pepperhoff”) method (9,11-14). A light pre-etch, or a slight amount of polishing relief, may lead to sharper delination of the constituents after vapor deposition. The deposition is conducted inside a vacuum evaporator of the type used to prepare replicas for electron microscopy. One or several small lumps of a suitable dielectric compound with the desired index of refraction is heated under a vacuum until it evaporates. A vacuum level of 1.3 to 0.013 Pa (10−3 to 10−5 mm Hg) is adequate and the polished surface should be about 10–15 cm beneath the device that holds the dielectric compound. Slowly evaporate the lumps and observe the surface of the specimen. It may be helpful to place the specimen on a small piece of white paper. As the film thickness increases, the surface (and the paper) will become colored with the color sequence changing in the order yellow, green, red, purple, violet, blue, silvery blue. Stop the evaporation when the color is purple to violet, although in some cases, thinner films with green or red colors have produced good results. 7.15 Metals Handbook (15) provides additional advice on etching solutions and techniques for various alloys. 8. Precision and Bias 8.1 It is not possible to specify the precision or bias of this practice since quantitative measurements are not made. 9. Keywords 9.1 etch; etchant; interference method; metallography; metals; microetch; microscope; microstructure; Pepperhoff method; tint etch |
回復此樓» 猜你喜歡
313求調劑
已經有3人回復
-
083000學碩274求調劑
已經有11人回復
-
環境工程 085701，267求調劑
已經有11人回復
-
291求調劑
已經有12人回復
-
一志愿中海洋320化學工程與技術學碩求調劑
已經有7人回復
-
08工科，295，接受跨專業調劑
已經有4人回復
-
08工科求調劑286
已經有5人回復
-
學碩274求調劑
已經有13人回復
-
一志愿085600中科院寧波所276分求調劑
已經有7人回復
-
0817化工學碩調劑
已經有3人回復
★
wypward(金幣+1):謝謝參與 2010-10-15 13:28:57
wypward(金幣+1):謝謝參與 2010-10-15 13:28:57
| 7.13 色調浸蝕液（9, 11-13)通常通過浸漬來使用而非涂刷，因為后者會阻礙膜的形成。待用的標本需要經過非常高品質的拋光，因為色調浸蝕液能夠顯示出遺留下的拋光損傷，即使這種損傷在明視場照明中是不可見的。標本拋光后，其表面必須仔細清洗。用聚乙烯燒杯來盛含氟離子浸蝕液（如，含有氟化氫銨的浸蝕液，NH4 FHF）。用鉗子將標本置于溶液中，拋光面朝上。輕輕攪動溶液，同時觀察拋光表面。開始著色后，保持溶液靜止不動。當標本表面顯紫色時將其從浸蝕液中取出，沖洗，干燥。色調浸蝕之后再用一般的化學浸蝕液對標本進行輕微的預浸蝕，這樣會使標本的結構輪廓更清晰。 |
5樓2010-10-14 09:25:38
★
wypward(金幣+1):謝謝參與 2010-10-13 17:51:57
高興星期五(金幣+80):非常感謝 2010-10-15 18:22:28
wypward(金幣+1):謝謝參與 2010-10-13 17:51:57
高興星期五(金幣+80):非常感謝 2010-10-15 18:22:28
|
參考。7.13和14有空再補啊，現在沒多余的時間了。 7.12 無意中遺留于標本表面的浸蝕液殘留物揮發出的氫氟酸會對顯微鏡物鏡造成毀壞。當標本或封片膠含有孔道結構或者墊層材料（如酚醛塑料）由于沒有緊固在標本上而產生邊緣滲漏時，這種情況尤為常見。因此， 任何情況下都應該特別注意在將標本置于鏡臺前均應對其進行徹底清洗和干燥以清除其上浸蝕液的所有痕跡。 7.15金屬手冊（15）提供各種合金蝕刻解決方案和技術的補充建議。 8.精度和偏差 8.1.因為沒有進行定量測定，所以這種做法的精度或偏差無法詳細說明。 9.關鍵詞 9.1 刻蝕；蝕刻劑；干涉法；金相學；金屬；微蝕刻；微觀結構/顯微結構；Pepperhoff method（不知道是什么方法）；色調蝕刻 |
2樓2010-10-13 10:32:54
 |
3樓2010-10-13 20:15:05
高興星期五
鐵桿木蟲 (著名寫手)
- 應助: 0 (幼兒園)
- 金幣: 6875.5
- 散金: 73
- 帖子: 2240
- 在線: 28.4小時
- 蟲號: 863010
- 注冊: 2009-10-04
- 性別: MM
- 專業: 鋼鐵冶金
4樓2010-10-13 20:15:57
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 一志愿北化085600材料專碩275|有文章專利｜求調劑 +11 | Micky11223 2026-03-25 | 12/600 |
|
|---|---|---|---|---|
|
|
[考研] 085600材料與化工調劑 +15 | kikiki7 2026-03-30 | 15/750 |
|
|
|
[考研] 266分，求材料相關專業調劑 +6 | 哇呼哼呼哼 2026-03-30 | 8/400 |
|
|
|
[考研] 085701環境工程求調劑 +11 | 多久上課 2026-03-27 | 12/600 |
|
|
|
[考研] 調劑 +4 | GK72 2026-03-30 | 4/200 |
|
|
|
[考研]
 304材料求調劑
+5
|
鐘llll 2026-03-26 | 5/250 |
|
|
[考研] 359求調劑 +5 | 王了個楠 2026-03-25 | 5/250 |
|
|
|
[考研] 求調劑，一志愿 南京航空航天大學大學 ，080500材料科學與工程學碩 +6 | @taotao 2026-03-26 | 7/350 |
|
|
|
[考研] 調劑310 +12 | 溫柔的晚安 2026-03-25 | 13/650 |
|
|
|
[考研] 329求調劑 +10 | 鈕恩雪 2026-03-25 | 10/500 |
|
|
|
[考研] 340求調劑 +6 | Amber00 2026-03-26 | 6/300 |
|
|
|
[考研] 2026年華南師范大學歡迎化學，化工，生物，生醫工等專業優秀學子加入！ +3 | llss0711 2026-03-28 | 6/300 |
|
|
|
[考研] 0703化學求調劑，各位老師看看我�。�！ +5 | 祁祺祺 2026-03-25 | 5/250 |
|
|
|
[考博] 26申博 +3 | 加油沖�。� 2026-03-26 | 3/150 |
|
|
|
[考研] 安徽大學專碩生物與醫藥專業(086000)324分，英語已過四六級，六級521，求調劑 +4 | 美味可樂雞翅 2026-03-26 | 4/200 |
|
|
|
[考研] 305求調劑 +5 | 哇盧卡庫 2026-03-26 | 5/250 |
|
|
|
[論文投稿] Journal of Mechanical Science and Technology +3 | Russ_ss 2026-03-25 | 5/250 |
|
|
|
[碩博家園] 北京林業大學碩導招生廣告 +6 | kongweilin 2026-03-26 | 8/400 |
|
|
|
[考研] 085601求調劑總分293英一數二 +4 | 鋼鐵大炮 2026-03-24 | 4/200 |
|
|
|
[考研] 一志愿 南京郵電大學 288分 材料考研 求調劑 +3 | jl0720 2026-03-26 | 3/150 |
|