| 3 | 1/1 | 返回列表 |
| 查看: 588 | 回復: 2 | |||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | |||
[交流]
求助物理方面英譯漢一段
|
|||
|
As mentioned above, besides high conductivity (~106 S), effective TCO thin films should have a very low absorption coefficient in the near UV-VIS-NIR region. The transmission in the near UV is limited by Eg, as photons with energy larger than Eg are absorbed. A second transmission edge exists at the NIR region, mainly due to reflection at the plasma frequency. Ideally, a wide band gap TCO should not absorb photons in the transmission “window” in the UV-VIS-NIR region. However, there are no “ideal” TCOs thin films, and even if such films could be deposited, reflection and interference would also affect the transmission. Hence, 100% transparency over a wide region cannot be obtained. The optical properties of TCOs transmission T, reflection R, and absorption A, are determined by its refraction index n, extinction coefficient k, band gap Eg, and geometry. Geometry includes film thickness, thickness uniformity, and film surface roughness. T, R and, A are intrinsic, depending on the chemical composition and solid structure of the material, whereas the geometry is extrinsic. There is a negative correlation between the carrier density and the position of the IR absorption edge, but positive correlation between the carrier density and the UV absorption edge, as Eg increases at larger carrier density (Moss-Burstein effect). As a result, the TCO transmission boundaries and conductivity are interconnected. The width of the VIS transmission window of a TCO film with thickness deposited on a transparent substrate is affected not only by the optical parameters of the TCO film but also by the optical properties of the substrate. The refractive index nsub of the most common substrates are ~1.45 for fused silica and ~1.6 for various glasses. The extinction coefficient of the substrate (ksub) is generally < 10-7, hence any light absorption would take place in the film, where generally kfilm> ksub. For films thicker than 100 nm, several interference bands could be formed, producing maximal and minimal values of T when either the wavelength or thickness is varied. When kfilm 0, the peak transmission (Tmax) is equal to the transmission of the substrate. Hence, assuming that the sample is in air, Tmax = 90% and 93% for films deposited on glass and fused silica, respectively. The minimum sample transmission (Tmin) in air is expressed by: As most TCO films have values of n in the VIS in the range 1.8 – 2.8, Tmin will be in the range 0.8 – 0.52. Tmin is closely approximated by the relation: Tmin = 0.051n2-0.545n+1.654. As n in the VIS decreases with wavelength, Tmin increases with wavelength, but will not exceed ~0.8. When the film extinction coefficient is not negligible and affects the transmission, Tmax < Tsub, and Tmin also decreases. By decreasing the TCO film thickness, T is increased but the sheet resistance decreases. Combining together the optical and electrical properties of the film, the fraction of the flux absorbed in a film (A) is given by the expression: Fig. 1 presents plots of the fraction of the absorbed power at wavelength of 400 nm and k ~0.02 as a function of the conductivity for three representative values of RS. For a given low values of RS necessitate using thick films, and lower conductivity requires the use of even thicker films, resulting in an increase in the loss of radiative power. The dependence of film thickness on the conductivity for three values of Rs is presented in Fig. 2. Using the same film conductivity, applications requiring the lowest RS will be thicker and, and the absorbed fraction will be higher. At present, only high quality ITO is compatible at present with the condition that the absorbed power fraction be lower than 10% and RS = 10 At lower extinction coefficient (k) films with lower conductivities can be used, e.g., when k = 0.002 instead of 0.02, the absorbed power A is lower by a factor of ~8, and allows the use of thicker films. The combination of film thickness, conductivity, and extinction coefficient determine the absorption of the radiation flux. However, when the total transmission T is considered, reflection and interference must be considered, which depend on the refractive indices of the substrate and the film, and the film thickness. A general formula for T and R was given by Cisneros. |
» 搶金幣啦!回帖就可以得到:
+3/1718
+1/289
+1/271
+1/193
+1/185
+5/170
+2/140
+1/91
+1/22
+1/19
+1/17
+1/10
+1/9
+1/7
+1/4
+1/3
+1/3
+1/1
+1/1
+1/1
鐵桿木蟲 (職業作家)
|
不行,翻了一點兒發現有些專業符號不認識。。。 糾結。。。 As mentioned above, besides high conductivity (~106 S), effective TCO thin films should have a very low absorption coefficient in the near UV-VIS-NIR region. The transmission in the near UV is limited by Eg, as photons with energy larger than Eg are absorbed. 如上所述,除了高電導率(〜106 S)外,有效的TCO薄膜還應該在近紫外-可見-近紅外吸收光譜區域有一個非常低的吸收系數。在近紫外區域的發射受到EG的限制,結果導致能量大于EG的光子被吸收。 |
鐵桿木蟲 (職業作家)
| 3 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 【考研調劑】化學專業 281分,一志愿四川大學,誠心求調劑 +15 | 吃吃吃才有意義 2026-03-19 | 16/800 |
|
|---|---|---|---|---|
|
[考研] 調劑 +4 | 13853210211 2026-03-24 | 4/200 |
|
|
[考研] 【雙一流院校新能源、環境材料,材料加工與模擬招收大量調劑】 +4 | Higraduate 2026-03-22 | 7/350 |
|
|
[考研] 材料與化工328分調劑 +4 | 。,。,。,。i 2026-03-23 | 4/200 |
|
|
[考研] 279分求調劑 一志愿211 +18 | chaojifeixia 2026-03-19 | 20/1000 |
|
|
[考研] 一志愿陜師大生物學071000,298分,求調劑 +3 | SYA! 2026-03-23 | 3/150 |
|
|
[考研] 298求調劑 +8 | 上岸6666@ 2026-03-20 | 8/400 |
|
|
[考研] 317求調劑 +12 | 申子申申 2026-03-19 | 18/900 |
|
|
[考研] 307求調劑 +11 | 冷笙123 2026-03-17 | 11/550 |
|
|
[考研] 一志愿華中農業071010,總分320求調劑 +5 | 困困困困坤坤 2026-03-20 | 6/300 |
|
|
[考研] 308求調劑 +3 | 墨墨漠 2026-03-21 | 3/150 |
|
|
[考研] 260求調劑 +3 | 朱芷琳 2026-03-20 | 4/200 |
|
|
[考研] 085600材料與化工306 +4 | z1z2z3879 2026-03-21 | 4/200 |
|
|
[考研] 材料學碩301分求調劑 +7 | Liyouyumairs 2026-03-21 | 7/350 |
|
|
[考研] 求調劑 +3 | 13341 2026-03-20 | 3/150 |
|
|
[考研] 336求調劑 +5 | rmc8866 2026-03-21 | 5/250 |
|
|
[考研] 材料與化工(0856)304求 B區 調劑 +3 | 邱gl 2026-03-21 | 3/150 |
|
|
[考研] 考研調劑求學校推薦 +3 | 伯樂29 2026-03-18 | 5/250 |
|
|
[考研] 求調劑,一志愿:南京航空航天大學大學 ,080500材料科學與工程學碩,總分289分 +4 | @taotao 2026-03-19 | 4/200 |
|
|
[考研] 0817 化學工程 299分求調劑 有科研經歷 有二區文章 +22 | rare12345 2026-03-18 | 22/1100 |
|