| 4 | 1/1 | 返回列表 |
| 查看: 795 | 回復: 3 | |||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | |||
[求助]
求助高手英譯漢,謝謝啦!
|
|||
|
1)不同種類Mg2B2O5晶須的加入使得復合材料的摩擦磨損性能略有不同,在相同條件下,基體、裸晶須、涂覆CuO和ZnO涂層增強的鋁復合材料的磨損率依次減小。 2) 在干摩擦條件下,隨著載荷與滑動速度的增加,復合材料的摩擦系數有變小的趨勢,磨損率隨之增大,且摩擦磨損機制由低載低速時的粘著磨損逐漸向高速高載下得磨粒磨損轉變,在摩擦磨損過程中伴隨著微觀疲勞磨損,三種磨損同時發生,互相交替變化。 3)通過SEM分析復合材料磨損表面、磨屑以及摩擦副表面形貌發現,隨著載荷與摩擦速率的增大,磨損表面出現大量的犁溝、裂紋和空穴且磨面上出現典型的機械混合層;磨屑由細小的顆粒狀逐步變?yōu)榇执蟮钠瑺钋夷デ蛏险持锏拿娣e有變小的趨勢。 萬分緊急。。!跪求給位大俠幫忙,汗顏! |

禁蟲 (正式寫手)
|
1 Friction and wear properties of composite materials appearred slightly different with the accession of different types Mg2B2O5 whisker. under the same condition, the wear rate of substrate, bare whiskers , aluminum composite material coated with CuO and ZnO successively reduced. 2 Under dry friction condition,with the load and sliding speed increases, Friction coefficient of composite materials tend to be smaller, wear rate will be increased, Friction and wear mechanism gradually changed from adhesive wear in low-load and low speed to abrasive wear in high-speed and high load, associated with micro-fatigue wear in friction and wear process, three kinds of wear occurred simultaneously, alternating with each other. 3 Analyzed the worn surface of composite materials、 wear debris and morphology of friction surface by SEM, found that with the increasing rate of load and friction, it appears a large number of furrows, cracks and holes on wear surface , and typical mechanical mixed layer on the grinding surface. Wear debris gradually changed from small granular to thick sheet, adhesive material on the area tend to be smaller. |
榮譽版主 (文壇精英)
有愛的二哥

| 4 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 274求調劑 +8 | S.H1 2026-03-18 | 8/400 |
|
|---|---|---|---|---|
|
[考研] 一志愿南昌大學,327分,材料與化工085600 +5 | Ncdx123456 2026-03-19 | 5/250 |
|
|
[考研] 085410人工智能專碩317求調劑(0854都可以) +4 | xbxudjdn 2026-03-18 | 4/200 |
|
|
[考研] 26調劑/材料/英一數二/總分289/已過A區線 +8 | 步川酷紫123 2026-03-13 | 8/400 |
|
|
[論文投稿]
申請回稿延期一個月,編輯同意了。但系統上的時間沒變,給編輯又寫郵件了,沒回復
10+3
|
wangf9518 2026-03-17 | 4/200 |
|
|
[考研] 一志愿北京化工大學0703化學318分,有科研經歷,求調劑 +3 | 一瓶苯甲酸 2026-03-14 | 3/150 |
|
|
[考研] 化學求調劑 +3 | 臨澤境llllll 2026-03-17 | 4/200 |
|
|
[考研] 287求調劑 +3 | 晨昏線與星海 2026-03-19 | 4/200 |
|
|
[考研] 一志愿天大材料與化工(085600)總分338 +5 | 蔡大美女 2026-03-13 | 5/250 |
|
|
[考研] 0817調劑 +3 | 沒有答案_ 2026-03-14 | 3/150 |
|
|
[考研] 330求調劑 +3 | 小材化本科 2026-03-18 | 3/150 |
|
|
[考研] 【同濟軟件】軟件(085405)考研求調劑 +3 | 2026eternal 2026-03-18 | 3/150 |
|
|
[考研] 304求調劑 +12 | 小熊joy 2026-03-14 | 13/650 |
|
|
[考研] 303求調劑 +4 | 睿08 2026-03-17 | 6/300 |
|
|
[考研] 材料,紡織,生物(0856、0710),化學招生啦 +3 | Eember. 2026-03-17 | 9/450 |
|
|
[考研] 301求調劑 +9 | yy要上岸呀 2026-03-17 | 9/450 |
|
|
[碩博家園] 湖北工業大學 生命科學與健康學院-課題組招收2026級食品/生物方向碩士 +3 | 1喜春8 2026-03-17 | 5/250 |
|
|
[考研] 材料與化工專碩調劑 +5 | heming3743 2026-03-16 | 5/250 |
|
|
[考研] 288求調劑 +4 | 奇點0314 2026-03-14 | 4/200 |
|
|
[考研] 招收0805(材料)調劑 +3 | 18595523086 2026-03-13 | 3/150 |
|