| 2 | 1/1 | 返回列表 |
| 查看: 1315 | 回復: 1 | |||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | |||
lclclclc88金蟲 (小有名氣)
|
[求助]
求助英語文獻翻譯2 關于無線通信的
|
||
|
IX. PERFORMANCREE SULTS Both performance measures discussed in this paper, namely data-packet delay and voice-call blocking probability, have been evaluated computationally. In this section we present the results of our evaluation of both fixed- and movable-boundary versions of the WIMA protocol. All of the results are for M = MV = 10 and L = R = 12. Our earlier studies of the IFF0 protocols have shown that performance is quite insensitive to the number of terminals for M greater than about 5 [3], and this behavior has also been observed for the WIMA protocol; thus the results for M = 10 are representative of higher values as well. The number of iterations required for convergence ranged from 2 at extremely low throughput rates to more than 2000 at extremely high throughput rates. Fig. 6 shows the expected data-packet system time (which is normalized with respect to the frame length L) as a function of data throughput for the fixed-boundary WIMA scheme for values of V, ranging from 0 to 6. Note that data throughput is defined to be the expected number of data packets successfully delivered by the system per time slot,where the average is taken over all L slots in the frame, including the status slot and those that are used for voice transmission. Recall that this performance index is independent of all voice-call parameters except V, in fixed-boundary systems. Note that the curve for V, = 0 is actually the curve for PR-NIFFL, which is data-only system. The maximum achievable data throughput under the WIMA schemes is (L - 1 - Vmax)/L, and we may define the "utilization" to be the data throughput normalized by this quantity. As the utilization approaches 1, which occurs at different values of data throughput for different values of V, the expected delay increases to co. For all values of V, results were obtained for utilization values of at least 0.98 (for which a 700 x 700 transition matrix was used), thereby demonstrating the ability of our model to evaluate heavily-loaded systems. Fig. 7 shows the effect of varying pv (and hence the expected length of voice calls) over a wide range for the movable-boundary scheme with V,,, = 6, while Xv is kept fixed at 0.01. For small values of pv, the system is heavily loaded, and performance approaches that of the fixed-boundary scheme. As pv increases, the average length of voice calls decreases, resulting in a decrease in the voice-call load and hence an increase in the number of slots available for data traffic. Thus the system is able to support higher levels of data traffic. Fig. 8 shows the voice-call blocking probability as a function of Vmax for Xv = 0.01 and several values of pv. Clearly,increasing Vmax results in lower blocking probability because more of the channel resource is available for the voice calls. Also, since large values of pv correspond to short voice calls,increasing pv results in lower channel utilization and hence in lower blocking probability. |
至尊木蟲 (小有名氣)
|
供參考: 本文討論了兩項工作特性測定,即通過計算對數據信息包延遲和語音呼叫閉鎖概率進行了評價。這一節給出WIMA協議中固定邊界和可調邊界形式的評價結果,結果均為M = MV = 10、L = R = 12。早期IFF0協議的研究顯示,當M大于5時,工作特性對終端數值不敏感,對WIMA協議也觀察了這種特性,當M=10時的結果同樣是具有代表性的高值。收斂所需的迭代次數范圍從最低輸送速度2到最高輸送速度2000。圖6所示為預期數據包系統時間(關于幀長L歸一化處理)為輸送給固定邊界WIMA方案數據的函數,其中V值范圍從0到6。注意輸送數據定義為每個時隙系統成功傳送的數據包期望值,這里時隙平均值被幀中全部L槽接收,包括狀態槽和用于語音傳送的槽。在固定邊界系統中,該性能指數與除V外的所有語音呼叫參數無關。注意V=0時的曲線實際上僅為數據系統PR-NIFFL的曲線。WIMA模式下最大可輸送數據為L,可定義數據被該數值歸一化的“利用”,當“利用”接近1時,期望的延遲增加至結束工作,對于不同V值這種情況出現在不同的輸送數據值。對于全部V值,利用值至少0.98(采用700 x 700傳遞矩陣)得到的結果論證了我們模型評估重載系統的能力。圖7所示為V=6而XV保持固定值0.01時,在可調邊界模式的整個廣域內改變PV(因此語音呼叫預期長度變化)的影響。對于小的PV值,系統重載,工作特性接近固定邊界模式。隨著PV增加,語音呼叫平均長度減小,導致語音呼叫輸入降低,因此增加可獲得的用于數據傳送槽的數量,這樣系統能支持更高水平的數據傳遞。圖8所示Xv = 0.01而幾個PV值時,語音呼叫閉鎖概率為最大V值的函數,顯然V最大值增加導致閉鎖概率降低,因為更多的信道資源可用于語音呼叫。而且,由于大PV值與短語音呼叫對應,增加PV導致信道利用降低因此閉鎖概率降低。 |
| 2 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[基金申請] 被我言中:新模板不強調格式了,假專家開始管格式了 +4 | beefly 2026-03-14 | 4/200 |
|
|---|---|---|---|---|
|
[考研] 299求調劑 +4 | △小透明* 2026-03-17 | 4/200 |
|
|
[考研] 304求調劑 +8 | 小熊joy 2026-03-14 | 8/400 |
|
|
[考研] 293求調劑 +6 | 世界首富 2026-03-11 | 6/300 |
|
|
[考研] 332求調劑 +6 | Zz版 2026-03-13 | 6/300 |
|
|
[考研] 085600材料與化工求調劑 +5 | 緒幸與子 2026-03-17 | 5/250 |
|
|
[考研] 一志愿南京大學,080500材料科學與工程,調劑 +4 | Jy? 2026-03-16 | 4/200 |
|
|
[考研] 東南大學364求調劑 +5 | JasonYuiui 2026-03-15 | 5/250 |
|
|
[考研] 070303 總分349求調劑 +3 | LJY9966 2026-03-15 | 5/250 |
|
|
[考研] 材料與化工一志愿南昌大學327求調劑推薦 +7 | Ncdx123456 2026-03-13 | 8/400 |
|
|
[考研] 求老師收留調劑 +4 | jiang姜66 2026-03-14 | 5/250 |
|
|
[考研] 復試調劑 +3 | 呼呼?~+123456 2026-03-14 | 3/150 |
|
|
[考研] 一志愿哈工大材料324分求調劑 +5 | 閆旭東 2026-03-14 | 5/250 |
|
|
[考研] 一志愿中科院,化學方向,295求調劑 +4 | 一氧二氮 2026-03-11 | 4/200 |
|
|
[考研] 336求調劑 +6 | Iuruoh 2026-03-11 | 6/300 |
|
|
[考研] 0703化學一志愿211 總分320求調劑 +5 | 瑪卡巴卡啊哈 2026-03-11 | 5/250 |
|
|
[考研] 310求調劑 +3 | 【上上簽】 2026-03-11 | 3/150 |
|
|
[考研] 工科調劑 +4 | Jiang191123! 2026-03-11 | 4/200 |
|
|
[考研] 材料301分求調劑 +5 | Liyouyumairs 2026-03-12 | 5/250 |
|
|
[考研] 270求調劑 085600材料與化工專碩 +3 | YXCT 2026-03-11 | 3/150 |
|