版塊導航: 正在加載中...

登錄注冊

應《網絡安全法》要求，自2017年10月1日起，未進行實名認證將不得使用互聯網跟帖服務。為保障您的帳號能夠正常使用，請盡快對帳號進行手機號驗證，感謝您的理解與支持！

24小時熱門版塊排行榜

北京石油化工學院2026年研究生招生接收調劑公告

返回列表

本帖產生 1 個 翻譯EPI ，點擊這里進行查看

aaa_dujiang

金蟲 (正式寫手)

應助: 6 (幼兒園)
金幣: 890.5
散金: 651
紅花: 18
帖子: 741
在線: 365.3小時
蟲號: 1290235
注冊: 2011-05-09
專業: 電化學

[求助] 一段鋰電池材料英文摘要翻譯，謝謝

里面有些專業詞匯不太懂謝謝了
Carbon coating on lithium iron phosphate (LiFePO4) plays a crucial role in determining its electrochemical performance. This study investigates the effect of carbon coating on lithiumironphosphate particles synthesized using a continuous supercritical hydrothermal synthesis (SHS) method and a conventional solid-state (SS) method, with sucrose as a carbon precursor. The carbon content, carbon structure, morphology, electronic conductivity, and electrochemical performance of the carbon-coated LiFePO4 (C-LiFePO4) are characterized as a function of the following coating conditions: sucrose concentration, calcination temperature, and calcination time. The particles produced using supercritical water have a smaller size (400–1000 nm), larger BET surface area of 7.3 m2/g, and lower degree of particle aggregation compared with those produced via solid-state synthesis (particle size: 3–15 μm; BET surface area: 2.4 m2/g). The differences in the particle size and particle morphology of the LiFePO4 prepared using the two synthetic methods cause a significant difference in the uniformity of the carbon coating, carbon structure, and electronic conductivity. A more uniform carbon layer coating and greater amount of graphitic carbon are found in the LiFePO4 particles produced via the SS method. This leads to a higher discharge capacity of 147 mA h/g at a current density of 17 mA/g (0.1 C) after 30 cycles when compared with the C-LiFePO4 produced by the SHS method (135 mA h/g). No obvious capacity fading was observed. At a high current of 1700 mA/g (10 C), the delivered capacities of the C-LiFePO4 particles produced via the SS and the SHS methods are 55% and 52% of the theoretical value, respectively, at a carbon content of 6 wt.%. The carbon-coated samples prepared using the SHS and SS methods exhibit similar discharge capacity trends for the carbon content. As the carbon content increased to 6 wt.%, the discharge capacity increased, while a further increase in the carbon content to 10 wt.% resulted in a decrease in the discharge capacity. Thus, the carbon content and particle properties need to be carefully optimized to enhance the electrochemical performance of C-LiFePO4

回復此樓

» 猜你喜歡

291求調劑已經有15人回復
材料學碩333求調劑已經有17人回復
070300化學求調劑已經有5人回復
070300一志愿211，312分求調劑院校已經有6人回復
物理學調劑已經有3人回復
08工科，295，接受跨專業調劑已經有5人回復
材料科學與工程調劑已經有12人回復
本2一志愿C9-333分，材料科學與工程，求調劑已經有5人回復
一志愿西交288化工專碩求調劑已經有4人回復
308求調劑已經有8人回復

1樓 2012-06-28 18:42:49

已閱回復此樓關注TA 給TA發消息送TA紅花 TA的回帖

yufenfei3002

金蟲 (小有名氣)

翻譯EPI: 8
應助: 17 (小學生)
金幣: 1103.3
散金: 10
紅花: 4
帖子: 220
在線: 117.6小時
蟲號: 589612
注冊: 2008-08-29
專業: 無機非金屬類光電信息與功

【答案】應助回帖

★ ★ ★ ★ ★ ★ ★
愛與雨下: 金幣+2 2012-07-08 21:23:33
sltmac: 金幣+5, 翻譯EPI+1 2012-08-04 13:16:29

太長了，超時了10分鐘，去干活了~

磷酸鐵鋰表面的碳包覆層對電極的電化學性能具有十分重要的作用。本課題使用蔗糖作為碳
源，研究了碳包覆對超臨界水熱法(SHS)和傳統固相法(SS)制備的磷酸鐵鋰顆粒的影響。對碳包覆磷酸鐵鋰的碳含量、結構、形貌、電導和電化學性能隨包覆條件（蔗糖濃度、預燒溫度和預燒時間）的變化進行了表征。和SS方法相比（顆粒粒徑3-15um，比表面積2.4m2/g），使用SHS方法制備的磷酸鐵鋰顆粒具有較小的粒徑（0.4-1um），較大的比表面積（7.3m2/g）和較低的顆粒團聚度。這兩種方法制備的磷酸鐵鋰在顆粒粒徑和形貌上的不同給碳包覆的連續性、碳層的結構及電導性能來來較大的差異。使用SS方法制備的LFP顆粒表面的碳包覆層更均一，碳含量也更高。這使得其具有更高的請充放電容量（147mA·h/g）和更大的電流密度17mA/g(0.1C)，高于SHS方法（135mA/g）。實驗沒有觀察到明顯的容量衰減現象。當碳包覆含量為6w%時，在1700mA/g(10C)的放電電流下，兩種方法制備的C-LFP顆粒的放電容量分別達到理論值的55%和52%。隨碳含量的變化，兩種方法制備的C-LFP的放電容量呈現相似的變化趨勢。當碳包覆的含量增加到6w%時，放電容量增加；但當進一步升高碳含量至10w%時，放電容量反而降低。因此，碳含量和顆粒的性質對于C-LFP的電化學性能至關重要，需嚴格控制。

贊一下

回復此樓

雨紛飛

2樓2012-07-07 13:41:46

已閱回復此樓關注TA 給TA發消息送TA紅花 TA的回帖

相關版塊跳轉 我要訂閱樓主 aaa_dujiang 的主題更新