 |
 |
 |
 |
 |
 |
||
 |
 |
 |
 |
 |
| 5 | 1/1 | 返回列表 |
| 查看: 3432 | 回復: 6 | |||
| 當前只顯示滿足指定條件的回帖，點擊這里查看本話題的所有回帖 | |||
yxg123管理員
|
[交流]
IEEE Transactions on Power Delivery被拒，請高手幫忙指點下 已有6人參與
|
||
|
文章一審2個多月，今天收到Reject - Do Not Resubmit的通知，請高手幫忙指點下，還有修改再投的意義嗎？ We regret to advise you that the Reviewing Committee is unable to accept the subject paper for publication as a PES Transactions paper even with possible revisions. Enclosed please find the comments of the reviewers that should serve to explain the recommendation of the reviewing committee. I hope you will find the explanations satisfactory. Although we could not accept this paper, we hope that you will consider Transactions on Power Delivery for other papers in the future. We thank you for your continued interest in the Power Engineering Society. COMMENTS TO THE AUTHORS: Editor's Comments: Editor Editor Comments for Author: The paper has received in general bad reviews. Much of the criticism has been caused by the problems with the English language. It is recommended to the authors that before they submit papers to the IEEE Transactions on Power Delivery to use professional proofreading services. Reviewers' Comments: Reviewer: 1 Comments to the Author Authors have presented a method to improve the measurement accuracy of mutual inductance transmission line parameters. However, reviewer has not found enough new research work performed by authors to be published in IEEE transactions of Power Delivery. The authors have compared their method with NPFM method, which is not explained that how it works. Further, authors have not provided enough latest references of the NPFM method. In the introduction section, authors have mentioned that the TTM method performance is affected by multi-circuit line, but they have not shown the performance of the proposed method in this case. In the section II, the subsections A and B are not having much significant role in the proposed work. In the section II, subsection C; authors have explained the proposed algorithm. In that subsection, equations 18 to 22 are not new. They have already been derived in the past. Please refer a paper of - Niranjan Kumar, A. K. Sahani, “Microprocessor Based Measurement of Π-Model Transmission Line Parameters Under Fault Conditions”, IET-UK International Conference on Information and Communication Technology in Electrical Sciences (ICTES 2007), Dr. M.G.R. University, Chennai, Tamil Nadu, India. Dec. 20-22, 2007, pp. 389-392. Hence, reviewer has not found enough new research work done by the authors in this subsection. Reviewer: 2 Comments to the Author Authors have presented a method of adaptive single ended sweep measurement which can be used for measuring the mutual inductance transmission line parameters. (i) There are many grammatical errors in the abstract as well as in the introduction. Further, introduction is written in very poor form. Most importantly, connectivity is missing between each section as well as between each sentence. (i) The authors have not clarified what their novelty is. Reviewer: 3 Comments to the Author This paper presents a method for transmission line mutual inductance parameters estimation. Following the authors, the method considers the shunt capacitive effect on the transmission line model, which is ignored by the ´traditional methods´. The proposed method, following the authors, is based on ´non-linear frequency response analysis of transmission line parameters´. This reviewer has the following comments/questions: - The theoretical analysis presents the behavior of isolated and three-phase conductors impedance with relation to the frequency. On both analyses, AC and DC resistances and inductances are shown in respect with Frequency. A LGJQ-300 wire is given as example. It is not clear how this frequency selection is automatically done by the method for different wire types. As presented the frequency choice seems to be empirical. An explanation on such could be included on the manuscript; - Equations (20)-(22) are adequate for single phase systems modeled with lumped parameters. The extended equations for 3 phase systems should be presented in the manuscript ; - Long Transmission lines should be modeled with frequency dependent distributed parameters at the selected frequency range (300-800Hz). Comments on such approximation should be included in the manuscript; - By selecting the ´best test frequency´, the method makes some considerations about the resistance and inductance behavior of wires. However the resistance and inductance behavior of the three phase lines are dependent, between others, on geometric and construction parameters. Equation 13 provides such relation. It is not clear how the estimated resistance and inductance values (which equations are not presented), will be used together with the line frequency characteristic curves to provide the mutual inductance parameter. Detail explanation on such should be provided on the manuscript; - It is not clear on the proposed method, how the estimated values are compensated from the mutual inductance effect. An explanation on such could be included on the manuscript; - Different geometric configurations and operating conditions will produce different mutual inductance values. A discussion on such, based on test results, could be included on the manuscript; - No reference for the so called NPFM method is presented. Such reference should be in the manuscript; - A complete grammatical text review could improve greatly the manuscript readability. Figure 4 text should read inductance instead of resistance; Reviewer: 4 Comments to the Author (There are no comments. Please check to see if comments were included as a file attachment with this e-mail or as an attachment in your Author Center.) |
回復此樓» 猜你喜歡
0856材料與化工調劑，339
已經有9人回復
-
一志愿西安交大材料學碩（英一數二）347，求調劑到高分子/材料相關專業
已經有7人回復
-
324分 085600材料與化工
已經有9人回復
-
考研調劑
已經有6人回復
-
材料專碩306英一數二
已經有3人回復
-
材料調劑
已經有5人回復
-
309分085801求調劑
已經有6人回復
-
一志愿武理材料工程302調劑環化或化工
已經有10人回復
-
311（085601）求調劑
已經有13人回復
-
335求調劑
已經有4人回復
» 本主題相關價值貼推薦，對您同樣有幫助:
7樓2012-07-16 09:55:42
chuzhufei
超級版主
中場魔術師
- SEPI: 5
- 應助: 105 (高中生)
- 貴賓: 0.001
- 金幣: 5829.3
- 散金: 7481
- 紅花: 30
- 沙發: 1
- 帖子: 2608
- 在線: 1857.6小時
- 蟲號: 706214
- 注冊: 2009-02-22
- 專業: 電路與系統
2樓2012-07-08 12:06:53
liupanjr
主管區長
- 應助: 1 (幼兒園)
- 金幣: 1088.2
- 散金: 10
- 帖子: 245
- 在線: 132.1小時
- 蟲號: 488643
- 注冊: 2007-12-30
- 性別: GG
- 專業: 計算機科學的基礎理論
4樓2012-07-08 12:29:29
xiajimu
版主
- 應助: 1703 (講師)
- 金幣: 12573.5
- 散金: 9739
- 紅花: 35
- 帖子: 5940
- 在線: 2164.6小時
- 蟲號: 288243
- 注冊: 2006-10-21
- 性別: GG
- 專業: 化學工程及工業化學
5樓2012-07-08 14:48:46
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 070300化學279求調劑 +9 | 哈哈哈^_^ 2026-03-31 | 11/550 |
|
|---|---|---|---|---|
|
|
[考研] 一志愿南師大0703化學 275求調劑 +5 | Ripcord上岸 2026-03-27 | 5/250 |
|
|
|
[考研] 0856材料化工調劑 總分330 +17 | zhubinhao 2026-03-27 | 17/850 |
|
|
[考研] 317求調劑 +12 | 蛋黃咸肉粽 2026-03-26 | 13/650 |
|
|
|
[考研] 0856 335分 | 封裝or激光加工 老師看看我��！ +9 | cccchenso 2026-03-29 | 9/450 |
|
|
|
[考研] 085601 材料工程 313分 求調劑 +6 | Ong3 2026-03-27 | 6/300 |
|
|
|
[考研] 一志愿大連理工大學，機械工程學碩，341 +3 | 西瓜田的守望者 2026-03-30 | 3/150 |
|
|
|
[考研] 320分，材料與化工專業，求調劑 +10 | 一定上岸aaa 2026-03-27 | 14/700 |
|
|
|
[考研] 一志愿 南京航空航天大學 ，080500材料科學與工程學碩 +5 | @taotao 2026-03-30 | 5/250 |
|
|
|
[考研] 293分求調劑，外語為俄語 +5 | 加一一九 2026-03-31 | 5/250 |
|
|
|
[考研] 292求調劑 +13 | 是妍子也是研子 2026-03-30 | 13/650 |
|
|
|
[考研] 283求調劑（080500） +14 | A child 2026-03-27 | 14/700 |
|
|
|
[考研] 343求調劑085601 +3 | 要努力學習x 2026-03-29 | 3/150 |
|
|
|
[考研] 308求調劑 +7 | 墨墨漠 2026-03-27 | 7/350 |
|
|
|
[考研] 265求調劑 +8 | 小木蟲085600 2026-03-27 | 8/400 |
|
|
|
[考研] 085600，材料與化工321分調劑 +4 | 大饞小子 2026-03-27 | 6/300 |
|
|
|
[考研] 調劑求收留 +7 | 果然有我 2026-03-26 | 7/350 |
|
|
|
[考研]
 085602化學工程求調劑。
+4
|
平樂樂樂 2026-03-26 | 4/200 |
|
|
|
[考研] 一志愿天津大學339材料與化工求調劑 +3 | 江往賣魚 2026-03-26 | 3/150 |
|
|
|
[考研] 材料與化工304求B區調劑 +3 | 邱gl 2026-03-25 | 3/150 |
|