| 3 | 1/1 | 返回列表 |
| 查看: 574 | 回復: 2 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
livesun木蟲 (小有名氣)
|
[求助]
懇求高手翻譯一下內容,翻譯成英語
|
|
|
以單片機為核心的控制軟件具有實時性、靈活性、通用性及運行可靠性的特 點,現在對太陽能充電控制器軟件的設計介紹如下: 1、首先主程序要完成系統初始化,為了在初始化的過程中,防止中斷的意外到來,應在主程序的開始處先關閉中斷,完成初始化后,再打開中斷。 2、由于太陽能的輸出電壓是隨著負載的變化而變化,因此用單片機X模式對太陽能電池進行穩壓。具體為,當太陽能輸出電壓大于給定的參數V時,X模式的占空比減少進行反饋而是太陽能輸出電壓降低,否則增大占空比。直到穩定。 3、LCD要顯示電池兩端的充電電壓及電池的充電電流,如果電池在充電時,有相應的指示燈亮,如果電池充滿電會使繼電器斷開,以使得電池?cái)嚅_,并有相應的指示燈亮。 |
木蟲 (小有名氣)
新蟲 (初入文壇)
|
Control software with real-time SCM as the core, flexibility, versatility, and reliability Now to the solar charge controller software design is described below: 1, first of all, the main program to complete the system initialization, initialization process, prevent broken accidents, should be shut down at the beginning of your program breaks in the main, after the initialization is complete, open break. 2, due to changes in solar output voltage as load changes, with single-chip solar cells by x mode voltage regulator. In particular, when solar power when the output voltage is greater than the given parameter v, x-mode feedback but the duty reduction of solar output voltage lower or increase the duty cycle. Until stable. 3, LCD displays both ends of the battery charging voltage and charging current of the battery, if the battery is charging, the corresponding led is lit, if the battery relay disconnected so that the battery disconnected and the corresponding led is lit. |
| 3 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 0703 調劑 +3 | 我可以上岸的對?/a> 2026-03-16 | 6/300 |
|
|---|---|---|---|---|
|
[考研] 323求調劑 +6 | 洼小桶 2026-03-18 | 6/300 |
|
|
[考研] 280分求調劑 一志愿085802 +4 | PUMPT 2026-03-22 | 7/350 |
|
|
[考研] 石河子大學(211、雙一流)碩博研究生長期招生公告 +3 | 李子目 2026-03-22 | 3/150 |
|
|
[考研] 08工科 320總分 求調劑 +11 | 梨花珞晚風 2026-03-17 | 11/550 |
|
|
[考研] 311求調劑 +3 | 26研0 2026-03-20 | 3/150 |
|
|
[考研] 機械專碩299求調劑至材料 +3 | kkcoco25 2026-03-16 | 4/200 |
|
|
[考研] 265求調劑 +3 | Jack?k?y 2026-03-17 | 3/150 |
|
|
[考研] 083200學碩321分一志愿暨南大學求調劑 +3 | innocenceF 2026-03-17 | 3/150 |
|
|
[考研] 二本跨考鄭大材料306英一數二 +3 | z1z2z3879 2026-03-17 | 3/150 |
|
|
[考研] 一志愿華南師大 070300(化學)304分求調劑 +3 | 0703武芊慧雪304 2026-03-18 | 3/150 |
|
|
[考研] 材料專業求調劑 +6 | hanamiko 2026-03-18 | 6/300 |
|
|
[考研] 考研調劑求學校推薦 +3 | 伯樂29 2026-03-18 | 5/250 |
|
|
[考研] 材料學碩297已過四六級求調劑推薦 +11 | adaie 2026-03-19 | 11/550 |
|
|
[考研] 一志愿西安交通大學 學碩 354求調劑211或者雙一流 +3 | 我想要讀研究生 2026-03-20 | 3/150 |
|
|
[考研] 材料與化工專碩調劑 +7 | heming3743 2026-03-16 | 7/350 |
|
|
[考研] 288求調劑,一志愿華南理工大學071005 +5 | ioodiiij 2026-03-17 | 5/250 |
|
|
[考研] 085601材料工程專碩求調劑 +10 | 慕寒mio 2026-03-16 | 10/500 |
|
|
[考研] 考研調劑 +3 | 淇ya_~ 2026-03-17 | 5/250 |
|
|
[考研] 070300化學學碩求調劑 +6 | 太想進步了0608 2026-03-16 | 6/300 |
|