 |
 |
 |
 |
 |
 |
||
 |
 |
 |
 |
 |
| 3 | 1/1 | 返回列表 |
| 查看: 841 | 回復: 2 | ||
| 本帖產生 1 個 翻譯EPI ，點擊這里進行查看 | ||
劉亞君880530新蟲 (初入文壇)
|
[求助]
泡沫分離論文翻譯
|
|
| 這是由于形成的泡沫中的液膜兩側均與氣相接觸，兩個氣液界面上均吸附著表面活性分子，對于SDS是以十二烷基硫酸根的形式在氣液界面上定向排列形成表面擴散雙電層[17]，如圖6所示。當兩界面靠近到一定程度，帶有相同電荷的粒子之間相互排斥，會阻止泡沫進一步變薄。根據第2節原理可以知道，泡沫在通過篩板時，氣泡相互擠壓加強泡沫的排液以及氣泡的擴張都會導致液膜變薄。對于持液量比較大的泡沫，經篩板作用后仍然存在一定厚度的液膜來維持泡沫的穩定。對于持液量比較小的泡沫，本身液膜的厚度已經很薄，雙電層作用導致自身排液困難，但是篩板仍會強制其排液，使液膜進一步變薄。因此經篩板作用，持液量越小的泡沫的液膜越薄，當與空氣直接接觸的氣泡更容易受蒸發誘導而消泡；當在內部的氣泡也因液膜太薄難以維持氣泡的穩定而更容易聚并形成空穴，從而容易進行消泡。 |
回復此樓» 猜你喜歡
生物學學碩，一志愿湖南大學，初試成績338
已經有5人回復
-
332求調劑
已經有3人回復
-
343求調劑
已經有3人回復
-
學碩274求調劑
已經有8人回復
-
壓國家一區線，求導師收留，有恩必謝！
已經有7人回復
-
081200-11408-276學碩求調劑
已經有4人回復
-
22408 359分調劑
已經有4人回復
-
本科新能源科學與工程，一志愿華理能動285求調劑
已經有5人回復
-
一志愿華北電力大學能動專碩，293，求調劑
已經有5人回復
-
調劑310
已經有7人回復
【答案】應助回帖
★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
劉亞君880530: 金幣+20, 翻譯EPI+1, ★有幫助, 一般 2012-12-07 09:07:56
劉亞君880530: 金幣+20, 翻譯EPI+1, ★有幫助, 一般 2012-12-07 09:07:56
| This is due to the contact of the both sides of the formed foam’s liquid film with the gas phase, the surface active molecules are adsorbed in the two-liquid interface, the SDS which is in the form of lauryl sulfate directionally arranges forming the surface diffusion electric double layer in the gas-liquid interface[17],as shown in Figure 6. When the two interfaces is close to a certain extent, the particles with the same charge each other and it will prevent the foam further thinning. In accordance with the principles of the second section, we can know when the foam through the sieve, the enhancement of mutual squeeze between the foam, the liquid discharge and the expansion of the foam will case the thinner liquid film. For the foam with larger liquid holdup, there is a certain thickness of the liquid film to maintain the stability of the foam after the sieve effect. For the foam with smaller liquid holdup, the thickness of the liquid film of its own is very thin, the role of the electric double layer cause the difficulties of its own liquid discharge, but the sieve will still force its liquid discharge, the liquid film further thinned. Therefore，by the sieve effect, the foam with the smaller liquid holdup will get the thinner liquid film, the foam in the direct contract with the air is more susceptible to evaporation induced leading to defoam; The internal foam is easier aggregating and forming a hole since the liquid film is too thin to maintain air bubbles stable, and thus prone to defoaming. |
2樓2012-12-06 20:25:21
sklyer_123
銀蟲 (小有名氣)
- 翻譯EPI: 2
- 應助: 4 (幼兒園)
- 金幣: 277.4
- 紅花: 1
- 帖子: 241
- 在線: 12.5小時
- 蟲號: 2198228
- 注冊: 2012-12-20
- 性別: MM
- 專業: 會計與審計
【答案】應助回帖
★ ★ ★ ★ ★
劉亞君880530: 金幣+5 2012-12-26 08:48:12
劉亞君880530: 金幣+5 2012-12-26 08:48:12
This is due to the formation of the bubble in the liquid film on both sides and gas phase exposure, two gas-liquid interface are adsorbed surfactant molecules, for SDS is twelve alkyl sulfate forms at the air-liquid interface are aligned along the formation of surface diffuse electric double layer [17], as shown in figure 6. When the two interface close to a certain extent, with the same charge between particles repel each other, will prevent further bubble thinning. According to the second principles can know, foam in through the sieve, bubble mutual extrusion reinforcing foam drainage and bubble expansion will lead to membrane thinning. The liquid holdup is large compared to the foam, the sieve effect still exists a certain thickness of liquid film to maintain the stability of foam. The liquid holdup is small compared to the foam, itself has very thin film thickness, the electric double layer lead to its discharge is difficult, but still enforce the discharge sieve plate, the film further thinning. Therefore, the sieve plate, liquid holdup smaller bubble liquid membrane is thin, when in direct contact with air bubbles are more easily influenced by evaporation induced and defoaming; when in the interior of the bubble by liquid membrane is too thin to maintain stable and easier bubble coalescence to form a hole, thereby easily defoaming. |
3樓2012-12-25 17:12:29
相關版塊跳轉
我要訂閱樓主 劉亞君880530 的主題更新
| 3 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 304求調劑 +6 | 曼殊2266 2026-03-27 | 6/300 |
|
|---|---|---|---|---|
|
[考研] 求化學調劑 +4 | wulanna 2026-03-28 | 4/200 |
|
|
|
[考研] 317求調劑 +6 | 十閑wx 2026-03-24 | 6/300 |
|
|
|
[考研] 283求調劑 +7 | A child 2026-03-28 | 7/350 |
|
|
|
[考研] 0856，材料與化工321分求調劑 +12 | 大饞小子 2026-03-27 | 13/650 |
|
|
|
[考研] 277跪求調劑 +5 | 1915668 2026-03-27 | 9/450 |
|
|
|
[考研] 085405 考的11408求各位老師帶走 +3 | Qiu學ing 2026-03-28 | 3/150 |
|
|
|
[考研] 291求調劑 +6 | HanBeiNingZC 2026-03-24 | 6/300 |
|
|
|
[考研] 材料求調劑 一志愿哈工大總分298分，前三科223分 +5 | dongfang59 2026-03-27 | 5/250 |
|
|
|
[考研] 330一志愿中國海洋大學 化學工程 085602 有讀博意愿 求調劑 +3 | wywy.. 2026-03-27 | 4/200 |
|
|
|
[考研] 0703化學求調劑，各位老師看看我�。�！ +5 | 祁祺祺 2026-03-25 | 5/250 |
|
|
|
[考研] 材料與化工085600，總分304，本科有兩篇sci參與，求調劑 +10 | 幸運的醬醬 2026-03-22 | 12/600 |
|
|
|
[考研] 調劑推薦 +5 | 清酒714 2026-03-26 | 6/300 |
|
|
|
[考研] 276求調劑。有半年電池和半年高分子實習經歷 +10 | 材料學257求調劑 2026-03-23 | 11/550 |
|
|
|
[考研] 總分322求生物學/生化與分子/生物信息學相關調劑 +5 | 星沉uu 2026-03-26 | 6/300 |
|
|
|
[考研] 081700 調劑 267分 +11 | 迷人的哈哈 2026-03-23 | 11/550 |
|
|
|
[考研] 打過很多競賽，085406控制工程300分，求調劑 +3 | askeladz 2026-03-26 | 3/150 |
|
|
|
[考研] 網絡空間安全0839招調劑 +4 | w320357296 2026-03-25 | 6/300 |
|
|
|
[基金申請] 請教下大家 2026年國家基金申請是雙盲審嗎？ +3 | lishucheng1 2026-03-22 | 5/250 |
|
|
|
[考研] 一志愿國科過程所081700，274求調劑 +3 | 三水研0水立方 2026-03-23 | 3/150 |
|