 |
 |
 |
 |
 |
 |
||
 |
 |
 |
 |
 |
| 3 | 1/1 | 返回列表 |
| 查看: 708 | 回復: 2 | ||||
lgdab木蟲 (小有名氣)
|
[求助]
翻譯求助——AOAC986.15，關于氫化物發生器 已有1人參與
|
|
Hydride generator.—See Figure 986.15A. Constructed from following: (1) Flat bottom flask.—Borosilicateglass, 50 mL (Corning No. 5160, or equivalent). (2) Stopper fittings.—Two-hole (one through center) No. 9 rubber stopper, fitted with gas outlet tube of 100 mm × 1/8 in. (3mm) id polyethylene tubing through center hole. Place bottom of gas outlet tube through cut off bottom 1 in. (25 mm) segment of 5/8 in. (16 mm) polyethylene test tube with hole in bottom so that 3 mm of tube protrudes through test tube. In sert through second hole 75 mm ×1/8 in. (3 mm) id polyethylene tubing as N2 inlet tube. Seal bottom end of tube with burner and then punch several holes at sealed end with 21 gage needle. Alternatively, prepare similarly 500 mm×1/16 in. (1.5 mm) id polyethylene tubing and hold in place in stopper with hole-through septum. Connect other end of tubing to AA spectrophotometer with 500 mm Tygon tubing by cutting auxiliary line at ca 75 mm from mixing chamber and at taching tubing. (3) Generator mount.—(Op tional.) 64 mm×0.5 in. (13 mm) id pipe secured to laboratory ring stand by means of clamp holder. Insert exten sion clamp into pipe and attach another clamp to back of clamp to hold clamp in place and to serve as handle; clamp is now free to rotate ca 180°. Attach rubber stopper of hydridegenerator to extension clamp with stiffwire and position just at level of clamp jaws. In operation, place flask of generator between jaws of extension clamp, insert stopper firmly into neck of flask, then tighten clamp jaws around neck of flask. Unit can be rapidly and uniformly inverted by rotating handle on extension clamp, thus allowing test solution and sodium borohydride to mix rapidly and reproducibly. 1.jpg |
回復此樓» 猜你喜歡
323求調劑
已經有6人回復
-
一志愿北京化工大學 070300 學碩 336分 求調劑
已經有4人回復
-
352求調劑
已經有3人回復
-
一志愿東華大學化學070300，求調劑
已經有8人回復
-
277材料科學與工程080500求調劑
已經有7人回復
-
317求調劑
已經有18人回復
-
293求調劑
已經有5人回復
-
280分求調劑 一志愿085802
已經有7人回復
-
0854電子信息求調劑
已經有3人回復
-
263求調劑
已經有4人回復
» 本主題相關價值貼推薦，對您同樣有幫助:
- 氫化物發生器-原子吸收測汞求助~~
已經有7人回復
- 【求助】ICP-AES測砷
已經有11人回復
wrgeng
專家顧問 (職業作家)
-
專家經驗: +264 - 應助: 111 (高中生)
- 貴賓: 0.16
- 金幣: 24864.3
- 散金: 150
- 紅花: 48
- 帖子: 4710
- 在線: 629.5小時
- 蟲號: 1227257
- 注冊: 2011-03-09
- 性別: GG
- 專業: 凝聚態物性I:結構、力學和
- 管轄: 精細化工
【答案】應助回帖
商家已經主動聲明此回帖可能含有宣傳內容
★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
感謝參與，應助指數 +1
lgdab: 金幣+20, ★★★很有幫助, 謝謝，這段真不好翻譯，一直看不懂 2013-12-24 15:47:25
hanches: 金幣+2, 感謝應助，BB獎勵，歡迎常來本版參與交流~~~ 2013-12-24 20:50:43
感謝參與，應助指數 +1
lgdab: 金幣+20, ★★★很有幫助, 謝謝，這段真不好翻譯，一直看不懂 2013-12-24 15:47:25
hanches: 金幣+2, 感謝應助，BB獎勵，歡迎常來本版參與交流~~~ 2013-12-24 20:50:43
|
氫氣發生器-見圖 986.15A.結構如下 (1)平底燒瓶-硅硼玻璃，50毫升 (訂購代碼 No. 5160, 或等同品). (2) 截止閥.—兩孔（一孔通過中心） No. 9 橡膠塞,配有 100 mm × 1/8 in. (3mm)時聚乙烯管通過中心孔。將聚乙烯管放置到一個直徑為 5/8 in. (16 mm) 的聚乙烯試管內25mm,并通過試管的底部. 另一個75 mm ×1/8 in. (3 mm) 聚乙烯管作為氮?dú)獾膶?dǎo)入管，用火焰將聚乙烯管封閉，并用針扎幾個小孔， 同時制備另一個 500 mm×1/16 in. (1.5 mm)聚乙烯管并穿過橡膠塞. 用500 mm Tygon管連接另一端到 AA 光譜儀 ，并在混合器開始大約75mm處連接一個輔助管 taching？？ tubing. (3)發生器監測—(Op tional.) 64 mm×0.5 in. (13 mm) id 牢固的固定到實驗室. 安裝兩個固定裝置，并使固定裝置可以自由轉動180度，在氫氣發生器和外置卡子之間安裝一個橡膠塞并防放置在卡子的上部。在操作過程中，將發生器燒瓶放置在外置卡子中，并固定在燒瓶的頸部，這樣整套裝置可以迅速的轉化，通過旋轉外置卡子的把手，使得試樣和硼氫化鈉迅速混合和再生。 設備安裝部分有點難度，僅供參考。 |
2樓2013-12-23 14:41:32
 |
3樓2013-12-23 14:56:54
相關版塊跳轉
我要訂閱樓主 lgdab 的主題更新
| 3 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 307求調劑 +11 | 冷笙123 2026-03-17 | 11/550 |
|
|---|---|---|---|---|
|
[考研] 尋找調劑 +4 | 倔強芒? 2026-03-21 | 4/200 |
|
|
|
[考研] 311求調劑 +3 | 26研0 2026-03-20 | 3/150 |
|
|
|
[考研] 269專碩求調劑 +6 | 金恩貝 2026-03-21 | 6/300 |
|
|
|
[考研] 291 求調劑 +3 | 化工2026屆畢業?/a> 2026-03-21 | 3/150 |
|
|
|
[考研] 求助 +5 | 夢里的無言 2026-03-21 | 6/300 |
|
|
|
[考研] 299求調劑 +5 | shxchem 2026-03-20 | 7/350 |
|
|
|
[考研] 求調劑 +3 | .m.. 2026-03-21 | 4/200 |
|
|
|
[考研] 307求調劑 +3 | wyyyqx 2026-03-17 | 3/150 |
|
|
|
[考研] 274求調劑 +10 | S.H1 2026-03-18 | 10/500 |
|
|
|
[考研] 南京大學化學376求調劑 +3 | hisfailed 2026-03-19 | 6/300 |
|
|
|
[考研] 一志愿中海洋材料工程專碩330分求調劑 +8 | 小材化本科 2026-03-18 | 8/400 |
|
|
|
[考研] 求調劑 +3 | @taotao 2026-03-20 | 3/150 |
|
|
|
[考研] 材料與化工專碩調劑 +7 | heming3743 2026-03-16 | 7/350 |
|
|
|
[考研] 廣西大學家禽遺傳育種課題組2026年碩士招生（接收計算機專業調劑） +3 | 123阿標 2026-03-17 | 3/150 |
|
|
|
[考研] 生物學調劑招人�。�！ +3 | 山海天嵐 2026-03-17 | 4/200 |
|
|
|
[考研] 085601專碩，總分342求調劑，地區不限 +5 | share_joy 2026-03-16 | 5/250 |
|
|
|
[考研] 0854可跨調劑，一作一項核心論文五項專利，省、國級證書40+數一英一287 +8 | 小李0854 2026-03-16 | 8/400 |
|
|
|
[考研] 考研調劑 +3 | 淇ya_~ 2026-03-17 | 5/250 |
|
|
|
[考研] 070300化學學碩求調劑 +6 | 太想進步了0608 2026-03-16 | 6/300 |
|