| 3 | 1/1 | 返回列表 |
| 查看: 398 | 回復: 2 | |||
葬花公子鐵桿木蟲 (著名寫手)
General
|
[求助]
求賽來昔布(Celecoxibum)在USP36以上的質量標準 已有1人參與
|
| 各位大蝦,緊急求助Celecoxibum的最新質量標準,最好是膠囊或制劑的,原料的EP7.5和USP35的標準我自己就有,USP36的沒有,求各位幫忙!~ |

金蟲 (正式寫手)
|
Celecoxib (sel'' e kox' ib). C17H14F3N3O2S 381.4 4-[5-(4-Methylphenyl)-3-(trifluoromethyl)-1H-pyrazol-1-yl]benzenesulfonamide; p-[5-p-Tolyl-3-(trifluoromethyl)pyrazol-1-yl]benzenesulfonamide [169590-42-5]. DEFINITION Celecoxib contains NLT 98.0% and NMT 102.0% of C17H14F3N3O2S, calculated on the anhydrous basis. IDENTIFICATION A. Infrared Absorption 197: [Note??Methods 197A, 197K, or 197M under Infrared Absorption may be used. ] [Note??If the spectra obtained show differences, dissolve the substance to be examined and the Reference Standard separately in isopropyl alcohol, evaporate to dryness, and record the new spectra. ] B. The retention time of the major peak of the Sample solution corresponds to that of the Standard solution, as obtained in the Assay. ASSAY Procedure Buffer: 2.7 g/L of monobasic potassium phosphate adjusted with phosphoric acid to a pH of 3.0 ?? 0.2 Mobile phase: Methanol, acetonitrile, and Buffer (3:1:6) Diluent: Methanol and water (3:1) System suitability solution: 0.5 mg/mL of USP Celecoxib RS and 2.4 ??/mL each of USP Celecoxib Related Compound A RS and USP Celecoxib Related Compound B RS in Diluent Standard solution: 0.5 mg/mL of USP Celecoxib RS in Diluent Sample solution: 0.5 mg/mL of Celecoxib in Diluent Chromatographic system (See Chromatography 621, System Suitability.) Mode: LC Detector: UV 215 nm Column: 4.6-mm ?? 25-cm; 5-?? packing L11 Column temperature: 60 Flow rate: 1.5 mL/min Injection size: 25 L Run time: About 1.5 times the celecoxib peak elution System suitability Samples: System suitability solution and Standard solution Suitability requirements Resolution: NLT 1.8 between celecoxib related compound A and celecoxib and NLT 1.8 between celecoxib and celecoxib related compound B, System suitability solution Relative standard deviation: NMT 0.73%, Standard solution Analysis Samples: Standard solution and Sample solution Calculate the percentage of C17H14F3N3O2S in the portion of Celecoxib taken: Result = (rU/rS) ?? (CS/CU) ?? 100 rU = = peak response from the Sample solution rS = = peak response from the Standard solution CS = = concentration of the Standard solution (mg/mL) CU = = concentration of the Sample solution (mg/mL) Acceptance criteria: 98.0%?C102.0% on the anhydrous basis IMPURITIES Inorganic Impurities Heavy Metals: NMT 20 ppm Diluent: Acetone and water (17:3) Standard solution: Dilute 1.0 mL of Standard Lead Solution, prepared as directed under Heavy Metals 231, Special Reagents, with Diluent to 20 mL. Sample solution: Dissolve 0.50 g of Celecoxib in 20 mL of Diluent. Blank solution: 20 mL of Diluent Analysis Samples: Standard solution, Blank solution, and Sample solution To each solution, add 2 mL of pH 3.5 Acetate Buffer, prepared as directed under Heavy Metals 231, Method I. Mix, and add to each solution 1.2 mL of thioacetamide?Cglycerin base TS. Mix immediately, and allow to stand for 2 min. Pass the solutions through a filter of 0.45-?? pore size. Compare the spots on the filters obtained from each of the solutions. Acceptance criteria: The brownish-black color of the spot resulting from the Sample solution is not more intense than that of the spot resulting from the Standard solution. The test is invalid if the Standard solution does not show a brownish-black color compared to the Blank solution. Residue on Ignition 281: NMT 0.2%, using a platinum crucible Organic Impurities Procedure Buffer, Mobile phase, Diluent, System suitability solution, Sample solution, and Chromatographic system: Proceed as directed in the Assay. Standard solution: 0.5 ??/mL of USP Celecoxib RS in Diluent System suitability Samples: System suitability solution and Standard solution Suitability requirements Resolution: NLT 1.8 between celecoxib related compound A and celecoxib and NLT 1.8 between celecoxib and celecoxib related compound B, System suitability solution Signal-to-noise ratio: NLT 20, Standard solution Analysis Samples: Standard solution and Sample solution Calculate the percentage of each impurity in the portion of Celecoxib taken: Result = (rU/rS) ?? (CS/CU) ?? 100 rU = = peak response for each impurity in the Sample solution rS = = peak response of celecoxib in the Standard solution CS = = concentration of celecoxib in the Standard solution (mg/mL) CU = = concentration of Celecoxib in the Sample solution (mg/mL) Acceptance criteria Individual impurities: See Table 1. [Note??Disregard any impurity peak less than 0.05%. ] Table 1 Name Relative Retention Time Acceptance Criteria, NMT (%) Celecoxib related compound Aa 0.9 0.4 Celecoxib 1.0 ?? Celecoxib related compound Bb 1.1 0.10 Individual unspecified impurity ?? 0.10 Total impurities ?? 0.5 a 4-[5-(3-Methylphenyl)-3-(trifluoromethyl)-1H-pyrazol-1-yl]benzenesulfonamide. b 4-[3-(4-Methylphenyl)-5-(trifluoromethyl)-1H-pyrazol-1-yl]benzenesulfonamide. SPECIFIC TESTS Water Determination, Method I 921: NMT 0.5%, using a 400-mg sample ADDITIONAL REQUIREMENTS Packaging and Storage: Preserve in tight containers, protected from light and moisture. Store at room temperature. USP Reference Standards 11 USP Celecoxib RS p-[5-p-Tolyl-3-(trifluoromethyl)pyrazol-1-yl]benzenesulfonamide. C17H14F3N3O2S 381.4 USP Celecoxib Related Compound A RS 4-[5-(3-Methylphenyl)-3-(trifluoromethyl)-1H-pyrazol-1-yl]benzenesulfonamide. C17H14F3N3O2S 381.4 USP Celecoxib Related Compound B RS 4-[3-(4-Methylphenyl)-5-(trifluoromethyl)-1H-pyrazol-1-yl]benzenesulfonamide. C17H14F3N3O2S 381.4 Auxiliary Information?? Please check for your question in the FAQs before contacting USP. Topic/Question Contact Expert Committee Monograph Hillary Z Cai Scientific Liaison, Small Molecules (301) 230-3379 (SM22010) Monographs - Small Molecules 2 Reference Standards RS Technical Services 1-301-816-8129 rstech@usp.org USP37?CNF32 Page 2246 Pharmacopeial Forum: Volume No. 36(6) Page 1519 Chromatographic Column?? CELECOXIB Chromatographic columns text is not derived from, and not part of, USP 37 or NF 32. |

金蟲 (正式寫手)

| 3 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 0856求調劑 +9 | 楒桉 2026-03-28 | 9/450 |
|
|---|---|---|---|---|
|
[考研] 合肥區域性重點一本招收調劑 +4 | 6266jl 2026-03-30 | 8/400 |
|
|
[考研] 285求調劑 +6 | AZMK 2026-03-30 | 11/550 |
|
|
[考研] 材料與化工272求調劑 +25 | 阿斯蒂芬2004 2026-03-28 | 25/1250 |
|
|
[考研] 085600 295分求調劑 +13 | W55j 2026-03-30 | 15/750 |
|
|
[考研] 一志愿西電085401數一英一299求調劑 六級521 +4 | 愛吃大鴨梨 2026-03-31 | 4/200 |
|
|
[考研] 調劑求院校招收 +7 | 鶴鯨鴿 2026-03-28 | 7/350 |
|
|
[考研] 總分322求生物學/生化與分子/生物信息學相關調劑 +6 | 星沉uu 2026-03-26 | 7/350 |
|
|
[考研] 323分 食品與營養調劑 +3 | 嘿ooo 2026-03-31 | 3/150 |
|
|
[考研] 085601一志愿西北工業大學初試346 +4 | 085601初試346 2026-03-30 | 4/200 |
|
|
[考研] 085600 286分 材料求調劑 +11 | 麻辣魷魚 2026-03-27 | 12/600 |
|
|
[考研] 材料化工340求調劑 +3 | jhx777 2026-03-30 | 3/150 |
|
|
[考研] 334分 一志愿武理 材料求調劑 +16 | 李李不服輸 2026-03-26 | 16/800 |
|
|
[考研] 求調劑 +10 | 張zz111 2026-03-27 | 11/550 |
|
|
[考研] 081200-11408-276學碩求調劑 +6 | 崔wj 2026-03-26 | 6/300 |
|
|
[考研] 330一志愿中國海洋大學 化學工程 085602 有讀博意愿 求調劑 +3 | wywy.. 2026-03-27 | 4/200 |
|
|
[考研] 070300化學求調劑 +4 | 起個名咋這么難 2026-03-27 | 4/200 |
|
|
[考研] 298調劑 +3 | jiyingjie123 2026-03-27 | 3/150 |
|
|
[考研]
|
平樂樂樂 2026-03-26 | 4/200 |
|
|
[考研] 309求調劑 +4 | gajsj 2026-03-25 | 5/250 |
|