 |
 |
 |
 |
 |
 |
||
 |
 |
 |
 |
 |
| 2 | 1/1 | 返回列表 |
| 查看: 588 | 回復: 1 | ||
| 本帖產生 1 個 翻譯EPI ，點擊這里進行查看 | ||
[求助]
高分子材料論文翻譯求助
|
||
|
The nanocomposite multilayer film was prepared using sol–gel method. The TiO2and ferrite sols were synthe-sized respectively first. The TiO2sol was obtained after adding tetrabutyl titanate, diethanolanine and a little of watertotheabsolutealcohol,withstirringfortwohours. According to the composition of BaFe10.5Al1.5O19, BaFe10.1Al1.9O19 and BaFe11.4Cr0.6O19 respectively, stoichiometric amount of barium nitrate, ferric nitrate, aluminum nitrate or chromium nitrate were dissolved in 60?C ethylene glycol with the addition of citric acid. After the ethylene diamine was added to adjust the pH value to 7.0, the ferrites precursor sols were formed. Depending on the weight ratio of ferrite to titanium dioxide for 3:5, three mixed sols were prepared. The mixed sol of BaFe10.1Al1.9O19and TiO2 was first spin coated onto a quartz glass plate, which had been previously cleaned by deionized water and alcohol. The spin speed was 3,000 rpm and the spin time was 15 s. The composite film was dried at 60 ?C for 30 min. Then the above spin process was repeated successively with the other two mixed sols containing BaFe10.5Al1.5O19and BaFe11.4Cr0.6O19. Finally, three layer composite films were calcined at 850 ?C for one hour. Surface morphology of the multilayer film was analyzed with atomic force microscopy (AFM), which was performed on the UHV-SPM. The scanning area was 2 ·2 lm. The crystalline structures of multilayer film were determined with X-ray diffraction (XRD) carried out on a Bruker-AXS D8 Advanced diffrac-tometer with Cu Karadiation in the 2h range from 10? to 90?, by steps of 0.02?. The microwave absorption property was expressed in microwave loss efficiency. The composite film was scraped off the quartz glass and collected together. The powders were filled into a 30 · 30 · 3 mm polytetrafluoroethylene box and pressed tightly. The transmission and reflection coef-ficients were measured with microstrip transmission line in 8722ES vector network analyzer in the fre-quency range from 5 GHz to 15 GHz. The microwave loss AdBwas calculated according to Eq. 1 where PTis the transmission wave power; PIis the incident wave power and PR is the reflection wave power. The microwave loss of the polytetrafluoroeth- ylene box was subtracted. |
回復此樓» 猜你喜歡
材料學碩333求調劑
已經有4人回復
-
各位老師您好：本人初試372分
已經有6人回復
-
【2026考研調劑】制藥工程 284分 求相關專業調劑名額
已經有7人回復
-
334分 一志愿武理-080500 材料求調劑
已經有3人回復
-
0854電子信息求調劑
已經有9人回復
-
347求調劑
已經有4人回復
-
0854人工智能方向招收調劑
已經有4人回復
-
求b區院校調劑
已經有4人回復
-
材料與化工考研調劑
已經有9人回復
-
求調劑
已經有3人回復
【答案】應助回帖
★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ...
RXMCDM: 金幣+1, 多謝應助！ 2014-04-09 18:30:09
wanghaiju: 金幣+75, 翻譯EPI+1, ★★★★★最佳答案 2014-04-09 22:05:16
RXMCDM: 金幣+1, 多謝應助！ 2014-04-09 18:30:09
wanghaiju: 金幣+75, 翻譯EPI+1, ★★★★★最佳答案 2014-04-09 22:05:16
| 用溶膠——凝膠方法制備納米復合材料多層膜。首先分別合成TiO2和陶鐵磁體溶膠。加入鈦酸四丁酯、diethanolanine和少量的watertotheabsolutealcohol并攪拌2小時后得到TiO2溶膠。分別根據BaFe10.5Al1.5O19, BaFe10.1Al1.9O19和BaFe11.4Cr0.6O19的復合物，化學計量的硝酸鋇、硝酸鐵、硝酸鋁或硝酸鉻溶于60℃乙烯乙二醇的檸檬酸溶液中。用乙二胺調節PH至7.0后，鐵酸鹽的前提溶膠形成。根據鐵酸鹽與二氧化鈦的重量比為3:5，制備三分混合溶膠。BaFe10.1Al1.9O19與 TiO2的混合溶膠首先旋轉涂于事先被去離子水和無水乙醇清洗的石英玻璃盤子上。旋轉速度為3000 rpm/s，算轉時間為15s。復合膜60℃干燥30min。其他兩種含有BaFe10.5Al1.5O19和BaFe11.4Cr0.6O19的混和溶膠采用上述相同的旋轉過程連續涂于其上。最后這三層復合膜于850℃焙烤1小時。使用原子力顯微鏡分析該多層膜的表面形態，掃描范圍是2*2 lm。用X-射線衍射儀測定多層膜的晶體結構，（carried out on a Bruker-AXS D8 Advanced diffractometer with Cu Karadiation in the 2h range from 10? to 90?, by steps of 0.02?——這些是X-射線衍射儀的測定條件與關鍵設備部件的型號）。用微波損失率表達微波吸收性能。將復合膜從石英玻璃上刮下來，并收集，將這些粉末至于30*30*3 mm聚四氟乙烯盒子內，壓實。用頻率范圍為5-15 GHz 的8722ES矢量網絡分析儀中的微波傳送帶傳遞線測定傳遞和反射系數。根據Eq. 1計算微波損失AdBwas，PTis是傳遞波能；PIis是入射波能；PR是反射波能。減去聚四氟乙烯盒子的微波損失。 |
2樓2014-04-09 16:03:52
相關版塊跳轉
我要訂閱樓主 wanghaiju 的主題更新
| 2 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 081700 調劑 267分 +10 | 迷人的哈哈 2026-03-23 | 10/500 |
|
|---|---|---|---|---|
|
|
[考研]
 085602 289分求調劑
+6
|
WWW西西弗斯 2026-03-24 | 6/300 |
|
|
|
[考研] 材料專碩找調劑 +5 | 哈哈哈吼吼吼哈 2026-03-23 | 5/250 |
|
|
|
[考研] 070300化學求調劑 +9 | 苑豆豆 2026-03-20 | 9/450 |
|
|
[考研] 341求調劑(一志愿湖南大學070300) +5 | 番茄頭--- 2026-03-22 | 6/300 |
|
|
|
[考研] 材料/農業專業，07/08開頭均可，過線就行 +3 | 呵唔哦豁 2026-03-23 | 4/200 |
|
|
|
[考研] 327求調劑 +5 | prayer13 2026-03-23 | 5/250 |
|
|
|
[考研] 化學308分求調劑 +3 | 你好明天你好 2026-03-23 | 3/150 |
|
|
|
[考研] 336求調劑 +4 | 收到VS 2026-03-20 | 4/200 |
|
|
|
[考研] 石河子大學（211、雙一流）碩博研究生長期招生公告 +3 | 李子目 2026-03-22 | 3/150 |
|
|
|
[考研] 275求調劑 +6 | shansx 2026-03-22 | 8/400 |
|
|
|
[考研] 303求調劑 +5 | 安憶靈 2026-03-22 | 6/300 |
|
|
|
[考研] 085600材料與化工306 +4 | z1z2z3879 2026-03-21 | 4/200 |
|
|
|
[考研] 297求調劑 +3 | 喜歡還是不甘心 2026-03-20 | 3/150 |
|
|
|
[考研] 材料 271求調劑 +5 | 展信悅_ 2026-03-21 | 5/250 |
|
|
|
[考研] 南昌大學材料專碩311分求調劑 +6 | 77chaselx 2026-03-20 | 6/300 |
|
|
|
[考研] 329求調劑 +9 | 想上學吖吖 2026-03-19 | 9/450 |
|
|
|
[考研] 求調劑一志愿南京航空航天大學289分 +3 | @taotao 2026-03-19 | 3/150 |
|
|
|
[考研] 261求B區調劑，科研經歷豐富 +3 | 牛奶很忙 2026-03-20 | 4/200 |
|
|
|
[考研]
320求調劑0856
+3
|
不想起名字112 2026-03-19 | 3/150 |
|