| 24小時熱門版塊排行榜 |
| 5 | 1/1 | 返回列表 |
| 查看: 751 | 回復: 6 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | ||
[求助]
關于藥動學里方法學的一段話,不太懂
|
||
|
Linearity of calibration curves, LLOD and LLOQ LLOQ can be quantitated with accuracy within 15% of nominal and precision not exceeding 15% CV, and was 4.0 ng/mL for TB-II and 3.9 ng/mL for TA-III. LLOD of TB-II and TA-III was obtained when the solution was diluted to 1.8 ng/mL and 1.6 ng/mL, respectively, and the signal-to-noise ratio was 2-fold. The calibration curve of TB-II was y = 0.3379x + 0.02973 (r = 0.9978) and was y = 1.778x−0.02613(r = 0.9989) for TA-III. The difference between the nominal standard concentration and the back-calculated concentration from the weighed linear regression line was varied from−4.3% to 4.6% for each point on the standard curve (CV varied from 1.7% to 8.2%). Carry-over was tested by injecting two processed blank matrix samples subsequently after injection of an ULOQ (the upper limit of quantification) sample in three independent runs.The response in the first blank matrix at the retention time of the analytes should be less than 20% of the mean response of a LLOQ sample for the analytes. The response in the first blank matrix at the retention time of the analytes was less than 7% of the mean response at the LLOQ for TA-III and 3% for TB-II. Therefore, the carry-over test was found to be acceptable. |
版主 (文壇精英)

版主 (文壇精英)
|
Carry-over was tested by injecting two processed blank matrix samples subsequently after injection of an ULOQ (the upper limit of quantification) sample in three independent runs. 攜帶污染測試:三次獨立測試,加入定量測定的最大上限樣本后,加入兩個經過處理的空白基質樣品。 |

版主 (文壇精英)
|
這個你都不知道?不管用什么方法,都有一個檢測范圍,超過這個范圍的測定結果是不準確的。以標準曲線法為例吧,首先用標準物質做標準曲線,做完標準曲線后待測樣品同樣條件(試劑與樣本比例,保溫時間等)進行檢測,一般是測得吸光度,根據吸光度查標準曲線得到待檢樣品的值。但標準曲線有一個范圍,超出這個范圍的高濃度樣品要經過稀釋然后檢測,低濃度樣品就沒法了。根據方法的最大檢測限,重復、回收、干擾、以及你的文章中提到的攜帶污染都要求在這個濃度下進行測定。 |

| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 材料與化工306分找調劑 +13 | 滄海輕舟e 2026-04-02 | 13/650 |
|
|---|---|---|---|---|
|
[考研] 070300化學求調劑 +5 | 起個名咋這么難 2026-03-27 | 5/250 |
|
|
[考研] 324求調劑 +8 | 想上學求調 2026-04-02 | 8/400 |
|
|
[考研] 085600,材料與化工321分求調劑 +11 | 大饞小子 2026-03-28 | 11/550 |
|
|
[考博] 材料工程專業碩士申博 +3 | 麟正宇 2026-03-30 | 3/150 |
|
|
[考研] 材料求調劑 一志愿哈工大總分298分,前三科223分 +12 | dongfang59 2026-03-27 | 12/600 |
|
|
[考研] 考研調劑0702 +3 | 梅子味晚霞 2026-03-28 | 3/150 |
|
|
[考研] 英一數一408,總分284,二戰真誠求調劑 +12 | 12.27 2026-03-30 | 14/700 |
|
|
[考研] 279求調劑 +7 | 莫xiao 2026-04-01 | 7/350 |
|
|
[考研] 350求調劑 +7 | 阿佳~ 2026-03-31 | 7/350 |
|
|
[考研] 材料專碩322分 +9 | 哈哈哈吼吼吼哈 2026-04-01 | 9/450 |
|
|
[考研] 070300化學專業279調劑 +10 | 哈哈哈^_^ 2026-03-31 | 10/500 |
|
|
[考研] 318求調劑 +10 | 陳晨79 2026-03-30 | 10/500 |
|
|
[考研] 一志愿中海洋材料357 +4 | 麥恩莉. 2026-03-30 | 4/200 |
|
|
[考研] 370求調劑 +3 | 080700調劑 2026-03-30 | 3/150 |
|
|
[考研] 求調劑 +10 | 張zz111 2026-03-27 | 11/550 |
|
|
[考研] 305求調劑 +8 | RuiFairyrui 2026-03-28 | 8/400 |
|
|
[考研] 一志愿南京航空航天大學材料學碩求調劑 +3 | @taotao 2026-03-28 | 3/150 |
|
|
[考研] 081200-314 +3 | LILIQQ 2026-03-27 | 4/200 |
|
|
[考研] 295求調劑 +5 | 1428151015 2026-03-27 | 6/300 |
|