版塊導航: 正在加載中...

應《網絡安全法》要求，自2017年10月1日起，未進行實名認證將不得使用互聯網跟帖服務。為保障您的帳號能夠正常使用，請盡快對帳號進行手機號驗證，感謝您的理解與支持！

24小時熱門版塊排行榜

返回列表

本帖產生 1 個 翻譯EPI ，點擊這里進行查看

wanghaiju

金蟲 (正式寫手)

應助: 2 (幼兒園)
金幣: 620.2
散金: 100
紅花: 1
帖子: 358
在線: 85.6小時
蟲號: 1047538
注冊: 2010-06-25
性別: MM
專業: 應用有機化學

[求助] 高分子論文翻譯求助

Table 2 shows the electrical conductivity measurement results of the as-received and heat-treated SiC-based ceramic fibers. The as-received ZE8 fiber had the highest electrical conductivity among the samples, which can be explained by its higher Si and C content when compared with the other two fibers. After heat treatment, the ZE8 fiber maintained this tendency, acquiring the highest conductivity value among the heat-treated fibers. The results of the electrical conductivity measurements of the as-received and heat-treated SiC-based ceramic fibers showed that electrical conductivity decreases significantly following
heat treatment, accounted for by the formation of an oxide layer around the fibers. The lack of an explicit continuous oxide layer could have resulted in the lower electrical conductivity decrease in the ZE8-type fiber.

Interaction of ceramic woven fabrics with electromagnetic radiation

   The parameters used to quantify the interaction of electromagnetic waves with the woven fabrics—reflection loss,RdB, and transmission loss, TdB—were measured in the 17–40 GHz frequency range using the free-space method. The fractions of reflected and transmitted waves were calculated using Eq. 2, where P0, PR, PTshow the incident, reflected, and transmitted wave powers, respectively.
   The changes in reflection loss in the as-received and heat-treated SiC-based ceramic woven fabrics are presented in Fig. 5a and b, respectively, measured in
decibels (dB) as a function of frequency. A decrease in reflection loss (increasing negative dB) indicates that the reflected portion of the electromagnetic wave from the material surface is diminished. The ZE8 fabric recorded the highest reflection loss among all the as-received fabrics in the 17–40 GHz frequency range (Fig. 5a). Electrical conductivity has a marked effect on the reflection loss of ceramic woven fabrics. Increases in electrical conductivity result in more reflected fraction from the materials, and thus an increase in reflection loss, whereas lower electrical conductivity leads to less reflection from the material surface, and hence lower reflection loss. This relation can be explained by the increase in the electromagnetic impedance of the material as conductivity decreases. Consequently, the level of impedance mismatch to air becomes lower, reducing the reflection loss of the material. In line with this explanation, the ZE8 fabric retained the highest reflection loss following heat treatment due to its highest level of electrical conductivity (Fig. 5b).
   A comparison of reflection losses of the as-received and heat-treated fabrics revealed a distinct behavior of the PN fabric. At low frequencies, reflection loss of the as-received PN fabric was about -5 dB, corresponding to a ~31%reflection of the electromagnetic wave; while at similar frequencies reflection loss of the PN-H fabric decreased to -14 dB with a ~3% reflection of the electromagnetic wave. The PN-type fabric is composed of carbon-coated SiC-based fibers, and the high conductivity of the carbon yielded higher reflection losses in the as-received condition. However, after heat treatment in air, as a result of the
loss of the carbon coating and the formation of an oxide layer the electrical conductivity of the fiber decreased, causing a considerable difference between the reflection losses of the as-received and PN-H fabrics.

回復此樓

» 猜你喜歡

284求調劑已經有10人回復
一志愿山東大學藥學學碩求調劑已經有4人回復
07化學280分求調劑已經有4人回復
298-一志愿中國農業大學-求調劑已經有12人回復
求材料，環境專業調劑已經有3人回復
335求調劑已經有5人回復
求調劑已經有7人回復
一志愿吉大化學322求調劑已經有4人回復
環境學碩288求調劑已經有8人回復
341求調劑(一志愿湖南大學070300) 已經有6人回復

1樓 2014-06-11 11:54:49

已閱回復此樓關注TA 給TA發消息送TA紅花 TA的回帖

reko34

木蟲 (正式寫手)

翻譯EPI: 132
應助: 117 (高中生)
金幣: 4794.2
散金: 22
紅花: 12
帖子: 780
在線: 417.4小時
蟲號: 3055206
注冊: 2014-03-15
性別: GG
專業: 機械測試?yán)碚撆c技術

【答案】應助回帖

★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
wanghaiju: 金幣+36, 翻譯EPI+1, ★★★★★最佳答案 2014-06-12 18:10:33

表2所示為收貨狀態和經熱處理的基于SiC的陶瓷纖維的電導率測量結果。收貨狀態的ZE8纖維在全部樣件中電導率最高，可解釋為Si和C含量高于其他2種纖維。熱處理后，ZE8纖維維持這種趨勢，獲得熱處理纖維中最高的電導率。收貨狀態和熱處理后的基于SiC的陶瓷纖維的電導率測量結果表明，熱處理后電導率顯著下降，可解釋為纖維周圍氧化層的形成。缺乏明顯的連續氧化層導致ZE8型纖維的電導率下降。

陶瓷織物與電磁輻射的相互作用

用于量化電磁波與織物間相互作用的參數-反射損失，RdB和傳輸損失，TdB在17-40GHz頻率范圍通過自由空間法測量。反射和傳輸波的部分通過式2計算，P0、PR、PT分別表示發射、反射和傳輸波功率。
收貨狀態和熱處理后的基于SiC的陶瓷織物的反射損失變化分別如圖5a、b所示，作為關于頻率的函數測量其分貝值（dB）。反射損失的下降（負dB增加）表示材料表面的電磁波反射部分減弱。在17-40GHz頻率范圍上，ZE8織物在所有收貨狀態織物中顯示出最高的反射損失（圖5a）。電導率對陶瓷織物的反射損失有明顯影響。電導率增加導致材料反射更多的電磁波，使反射損失增加，而低電導率使材料表面的反射減少，于是反射損失降低。材料的電磁阻抗增加將這種關系解釋為電導率下降。于是，與空氣之間的阻抗差距降低，減少了材料的反射損失。根據這種解釋，ZE8織物因其最高的電導率水平在熱處理后保持最高的反射損失（圖5b）。
收貨狀態和熱處理后織物的反射損失比較揭示了PN織物一個顯著特性。低頻率上，收貨狀態的PN織物的反射損失約-5dB，對應31%的電磁波反射；在相似的頻率上，PN-H織物的反射損失降到-14dB，電磁波的反射為3%。PN型織物由涂碳的SiC基纖維構成，碳的高電導率導致收貨狀態的高反射損失。然而，經過空氣中熱處理，碳層的損失和氧化層的形成使纖維電導率下降，導致收貨狀態和熱處理后PN織物的反射損失出現顯著差距。

贊一下(2人)

回復此樓

2樓2014-06-12 14:22:09

已閱回復此樓關注TA 給TA發消息送TA紅花 TA的回帖

相關版塊跳轉 我要訂閱樓主 wanghaiju 的主題更新