| 2 | 1/1 | 返回列表 |
| 查看: 334 | 回復: 1 | |||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | |||
wanghao69新蟲 (小有名氣)
|
[求助]
求大神幫忙翻譯一小段英文片段急急急!!
|
||
|
Fig. 2 presents the results of XRD analysis of the AM at 1100℃, 1200℃, 1300℃ and 1400℃. The spinel peak began to appear at around 1200℃, and it was confirmed that the peak rose in proportion to the increase in temperature. It is assumed that the spinel formation was completed at 1400℃, as the magnesia peak entirely disappeared at 1400℃. The CA6 peak did not appear until 1400℃, which suggested that the peak probably might appear at the temperature higher than 1400℃. Fig. 3 presents the thermal linear expansion and shrinkage of each specimen. As seen in the graph, each specimen shows different thermal behavior according to the increases in temperature. The categories of thermal behavior have been classified into 1) sintering shrinkage, 2) in-situ spinel formation, and 3) CA6 generation by Sako et al.4). |
木蟲 (小有名氣)
|
圖2展示了AM在1100度,1200度,1300度和1400時XRD分析結果.尖晶石峰值在大約1200度時出現.已經確認峰值是與溫度成比例增加的.因?yàn)檠趸V峰值在1400度是完全消失了,可以推斷尖晶石在1400度之前已經形成了.在1400度之前,CA6峰值沒有出現,這說明其峰值可能會高于1400度時出現.圖3每一個樣本熱線性膨脹和收縮值.如圖所示,隨著溫度的增加,每一個樣本顯示出不同的熱行為.這些熱行為可以劃分為:1)燒結收縮,2)現場尖晶石形成,和3)通過Sako等等產生CA6 注:最后一句可能不太妥當,你再斟酌下 |
| 2 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|