| 5 | 1/1 | 返回列表 |
| 查看: 495 | 回復: 3 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | ||
wskk新蟲 (小有名氣)
|
[求助]
麻煩大家?guī)臀曳g一下下面這段話
|
|
| In addition to the trans isomer, photoexcitation of cis-stilbene generates the cyclic product 4a,4b-dihydrophenanthrene in 10% yield. The yields of the three processes add up to ~1, suggesting that only one pathway may be available for the deactivation excited stilbene. Trans-stilbene is thermodynamically more stable; however, the barrier to thermal isomerization is significantly larger than that of AB, and the rate of thermal isomerization at room temperature is very slow.Dynamic simulations and ab initio lculations predict isomerization of stilbene to be dominated by rotation, with some contribution from skeletal deformations. A crossover point between S1 and S0 states has been located near a torsional angle of 90. Both trans and cis-stilbene must acquire the same conformation prior to S0 ←S1 intersystem crossing; however a small barrier exists on the side of the trans isomer. As a result, the S1 state of trans-stilbene has a considerably longer lifetime than that of the cis isomer. Ultrafast timeresolved spectroscopy has revealed S0←S1 relaxation of stilbene to be unimodal. |
捐助貴賓 (著名寫手)
捐助貴賓 (著名寫手)
商家已經主動聲明此回帖可能含有宣傳內容| 關于以上引用資料中提到的,以銅為催化劑的PhEt氧化反應,有幾篇文章研究內容就涉及到了將復合物固定到某個支撐點,即,利用Y型沸石,封裝9-, 12-, 14-,16- 三態水磨石大環配體復合物,具體方法首先將CuII Salen復合物固定在改良的碳納米管上,然后將層狀雙氫氧化物,插入2,20- 二吡啶-5,50-二元羧酸鹽 CuII 復合物的夾層,最后利用聚合物固定2-(a- 羥甲基)苯并咪唑 CuII 復合物。 |
捐助貴賓 (著名寫手)
商家已經主動聲明此回帖可能含有宣傳內容|
In addition to the trans isomer, photoexcitation of cis-stilbene generates the cyclic product 4a,4b-ihydrophenanthrene in 10% yield. 除了反式異構體,順勢光激勵也能生成環狀產物4a,4b-二氫菲(產率為10%)。 The yields of the three processes add up to ~1, suggesting that only one pathway may be available for the deactivation excited stilbene. 三個步驟的產率增加到了 ~1,這就標明,其中只有一個方法能夠鈍化刺激的對稱二苯代乙烯。 Trans-stilbene is thermodynamically more stable; however, the barrier to thermal isomerization is significantly larger than that of AB, and the rate of thermal isomerization at room temperature is very slow. 雖然二苯乙烯的熱力學穩定性更高,然而,其熱異構化的困難比實現AB異構化的困難要大得多,而且在室溫環境中,熱異構化速率非常慢。 Dynamic simulations and ab initio calculations predict isomerization of stilbene to be dominated by rotation, with some contribution from skeletal deformations. 受骨骼形變的啟發,動態仿真和從頭計算法預測,對稱二苯代乙烯異構將由分子旋轉完成。 A crossover point between S1 and S0 states has been located near a torsional angle of 90. Both trans and cis-stilbene must acquire the same conformation prior to S0 ←S1 intersystem crossing; however a small barrier exists on the side of the trans isomer. 經過定位,S1和S0質檢的交叉點接近于90度的扭轉角。在系統由S1穿越到S0之前,無論順式和反式異構都必須有同樣的構象;其中對于反式異構體,這存在一點小小的困難。 As a result, the S1 state of trans-stilbene has a considerably longer lifetime than that of the cis isomer. Ultrafast timeresolved spectroscopy has revealed S0←S1 relaxation of stilbene to be unimodal. 因此,比起順式異構體,反式-二苯乙烯的S1狀態相當?shù)拈L。 極速時間分辨光譜法標明,對稱二苯代乙烯又S1狀態緩沖到S0狀態是單向的。 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 一志愿085600中科院寧波所276分求調劑 +24 | 材料學257求調劑 2026-03-28 | 25/1250 |
|
|---|---|---|---|---|
|
[考研] 07生物學求調劑 一志愿同濟大學359分 +3 | LAMC. 2026-03-30 | 3/150 |
|
|
[考研] 一志愿9初試366 本雙非求調劑 +4 | 運氣來得若有似?/a> 2026-04-02 | 4/200 |
|
|
[考研] 266求調劑 +4 | 學員97LZgn 2026-04-02 | 4/200 |
|
|
[考研] 367求調劑 +8 | 芋泥啵! 2026-03-28 | 8/400 |
|
|
[考研] 08生物與醫藥專碩初試346找調劑 +6 | dianeeee 2026-04-01 | 7/350 |
|
|
[考研] 英一數一408,總分284,二戰真誠求調劑 +12 | 12.27 2026-03-30 | 14/700 |
|
|
[考研] 292求調劑 +17 | 木蟲er12138 2026-04-01 | 17/850 |
|
|
[考研] 【求調劑】085601材料工程專碩 | 總分272 | +10 | 腳滑的守法公民 2026-03-27 | 10/500 |
|
|
[考研] 291求調劑 +3 | 迷蒙木木 2026-04-01 | 4/200 |
|
|
[考研] 求0861交通運輸專碩or材料專碩調劑 +4 | 勒布朗@ 2026-03-31 | 4/200 |
|
|
[考研] 材料求調劑 一志愿哈工大總分298分,前三科223分 +11 | dongfang59 2026-03-27 | 11/550 |
|
|
[考博] 材料專業申博 +5 | 杜雨婷dyt 2026-03-29 | 5/250 |
|
|
[考研] 一志愿大連理工大學,機械工程學碩,341 +3 | 西瓜田的守望者 2026-03-30 | 3/150 |
|
|
[考研] 323分 食品與營養調劑 +3 | 嘿ooo 2026-03-31 | 3/150 |
|
|
[考研] 348求調劑 +6 | 小懶蟲不懶了 2026-03-28 | 6/300 |
|
|
[考研] 2026年華南師范大學歡迎化學,化工,生物,生醫工等專業優秀學子加入! +3 | llss0711 2026-03-28 | 6/300 |
|
|
[考研] 085405 考的11408求各位老師帶走 +3 | Qiu學ing 2026-03-28 | 3/150 |
|
|
[考研] 308求調劑 +7 | 墨墨漠 2026-03-27 | 7/350 |
|
|
[考研] 一志愿吉大071010,316分求調劑 +3 | xgbiknn 2026-03-27 | 3/150 |
|