| 7 | 1/1 | 返回列表 |
| 查看: 1117 | 回復: 6 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
yingzi1120鐵桿木蟲 (正式寫手)
|
[求助]
求大俠幫翻譯下(漢譯英),感激不盡。!
|
|
|
先說聲謝謝,如下: 1. 我們已在文中前言部分增加了關于納米A的闡述。如下:納米A具有硬度大,高耐磨以及較強的耐腐蝕性等特性。是具有廣闊前景的納米材料,基于它本身的物理化學性質,近年來國內外科研工作者對其在很多領域進行了拓展應用. 2.我們只是想說明圖片上各個區域的成分,因此任意選擇了一個濃度下的樣品進行表征。 3.基于本文前面的分析,粉體濃度在10g/L時制備的涂層中分體含量達到最大值,表面形貌及硬度也達到最佳。因此,這里選取溶液中粉體含量是10g/L來分析樣品的電化學腐蝕性能。 4..在前期的工藝條件探索中,4A/cm2的電流密度在本研究中是最佳的條件,并沒有出現燒焦或是粉化現象。且已有很多相關文獻使用的電流密度也在4A/cm2左右。 5.這是因為研究分析沉積過程要求物體表面要非常穩定且細致均勻,否則會引入外來干擾因素,無法充分說明電沉積形核結晶的機制。而基體表面滿足不了需求,為了排除干擾,更加準確的分析沉積過程,本文選自了相對穩定的B來分析這個沉積過程。 6.復合材料對于實際應用是非常重要的,然而很多類似的工作分析并不全面,尤其是對于C粉體在涂層中的沉積過程報道的并不多。本文通過多種表征手段對制備的復合材料進行分析,得出了一些重要的數據和結論,希望對其他相關的工作者能有一定的借鑒意義。 7.對于復合沉積研究,雖然已有很多報道。然而,很多科研工作者的分析研究并不全面,尤其是運用電化學手段分析C粉體微粒對沉積過程的影響報道更為少之。對于C粉體微粒的研究也較少,前人在復合材料制備上多集中于SiO2, TiO2,Al2O3等粉體微粒。 |
鐵桿木蟲 (正式寫手)
鐵桿木蟲 (正式寫手)
鐵桿木蟲 (正式寫手)
鐵桿木蟲 (正式寫手)
捐助貴賓 (著名寫手)
商家已經主動聲明此回帖可能含有宣傳內容|
1. 我們 已在文中 前言部分 增加了 關于 納米A 的闡述。如下:納米A 具有 硬度大,高耐磨 以及 較強的耐腐蝕 性等特性。是 具有廣闊前景 的納米材料,基于 它本身的 物理化學性質,近年來 國內外科研工作者 對 其在 很多領域 進行了 拓展應用 1. We have added elaboration of Nanomaterial A in the section of introduction. For instance, with advantages of high hardness, high wearability and strong corrosion resistance, Nanomaterial A is enjoying a wide prospect. Based on the physical and chemical properties of itself, in recent year, researchers from home and abroad have conducted studies on the expanding application of such material in various fields. 2.我們只是想說明 圖片上 各個區域 的 成分,因此 任意選擇了 一個濃度下 的 樣品 進行表征。 We did this only for explaining the components of each region in figure, so we randomly selected a sample in a certain concentration for characterization. 3.基于本文前面的分析,粉體濃度 在10g/L時 制備的 涂層中 分體含量 達到最大值,表面形貌 及 硬度 也達到最佳。因此,這里選取 溶液中 粉體含量 是10g/L 來分析 樣品的 電化學腐蝕性能。 3,Based on previous analysis in this paper, with nanopowder concentration of 10g/L, the fission content in coat reaches the max value, the surface appearance and hardness reach the max as well. Therefore, we selected 10g/L of nanopowder concent in solution for analyzing electrochemical corrosion resistance of the sample 4..在前期的 工藝條件 探索中,4A/cm2的電流密度 在本研究中 是最佳的 條件,并沒有出現 燒焦或是粉化 現象。且已有 很多相關文獻 使用的 電流密度 也在4A/cm2左右。 4,In the early exploration of process conditions, we found 4A/cm2 is the optimal current density, under which, no burning or pesting phenomenon emerged. In addition, there have been lots of relative references in which the current density was set as about 4A/cm2. 5.這是因為 研究分析 沉積過程 要求物體表面 要 非常穩定 且 細致均勻,否則 會引入 外來干擾因素,無法充分說明 電沉積形核結晶 的機制。而基體表面 滿足 不了需求,為了 排除干擾,更加準確的 分析 沉積過程,本文 選自了 相對穩定的 B來分析 這個沉積過程。 5 This is because in analysis of sedimentation process, a highly stable,uniform and particular surface should be guarranteed, otherwise outside interference factors will be introduced, leading to the failure in fully demonstrating the mechanism of electrodeposition crystal nucleation. On this basis, (這里是不是漏掉了“A”表面無法滿足)the surface of Nanomaterial A can hardly meet such requirements, so we selected the more stable B to analyze the sedimentation process in higher accuracy. 6.復合材料 對于 實際應用 是非常重要的,然而 很多類似的 工作 分析 并不全面,尤其是 對于C粉體 在 涂層中的 沉積過程 報道的 并不多。本文 通過 多種表征手段 對 制備的 復合材料進 行分析,得出了 一些重要的 數據和結論,希望對 其他相關的工作者 能有 一定的借鑒意義。 6. Composite material plays a vital role in practical application, however, many analyses on compasite material, especially on the sedimentation process of C power are not comprehensively written enough. In this paper, through multiple characterization methods, we analyzed the resulted composite material and obtained some data and conclusions, which are expected to be of reference significance to relative researchers. 7.對于 復合沉積研究,雖然 已有很多報道。然而,很多科研工作者的 分析研究 并不全面,尤其是 運用 電化學手段 分析C粉體 微粒 對 沉積過程的 影響報道 更為少之。對于C粉體微粒的 研究也較少,前人在 復合材料 制備上 多集中于 SiO2, TiO2,Al2O3 等粉體微粒。 7, There have been lots of reports on composite deposition, however many of researches within are not comprehensively written. Especially on the sedimentation process of C powder particles by electrochemistry method, reports are fewer. In addition, studies on C power practicles are few, former researches mostly focused on SiO2, TiO2,Al2O3 as the powder particles for preparing composite materials. |
鐵桿木蟲 (正式寫手)
| 7 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 一志愿 南京航空航天大學大學 ,080500材料科學與工程學碩 +3 | @taotao 2026-03-20 | 3/150 |
|
|---|---|---|---|---|
|
[考研] 0817 化學工程 299分求調劑 有科研經歷 有二區文章 +20 | rare12345 2026-03-18 | 20/1000 |
|
|
[考研] 梁成偉老師課題組歡迎你的加入 +9 | 一鴨鴨喲 2026-03-14 | 11/550 |
|
|
[考研] 【考研調劑】化學專業 281分,一志愿四川大學,誠心求調劑 +5 | 吃吃吃才有意義 2026-03-19 | 5/250 |
|
|
[考研] 化學求調劑 +3 | 臨澤境llllll 2026-03-17 | 4/200 |
|
|
[考研] 330求調劑 +3 | 小材化本科 2026-03-18 | 3/150 |
|
|
[考研] 085600材料與化工 +5 | 安全上岸! 2026-03-16 | 5/250 |
|
|
[考研] 一志愿西南交大,求調劑 +4 | 材化逐夢人 2026-03-18 | 4/200 |
|
|
[考研] 312求調劑 +8 | 陌宸希 2026-03-16 | 9/450 |
|
|
[考研]
|
胡辣湯放糖 2026-03-15 | 6/300 |
|
|
[考研] 299求調劑 +5 | △小透明* 2026-03-17 | 5/250 |
|
|
[考研] 280求調劑 +6 | 咕嚕曉曉 2026-03-18 | 7/350 |
|
|
[考研] 301求調劑 +9 | yy要上岸呀 2026-03-17 | 9/450 |
|
|
[基金申請] 被我言中:新模板不強調格式了,假專家開始管格式了 +4 | beefly 2026-03-14 | 4/200 |
|
|
[考研]
|
zhouzhen654 2026-03-16 | 3/150 |
|
|
[基金申請]
今年的國基金是打分制嗎?
50+3
|
zhanghaozhu 2026-03-14 | 3/150 |
|
|
[考研] 304求調劑 +4 | ahbd 2026-03-14 | 4/200 |
|
|
[考研] 326求調劑 +3 | mlpqaz03 2026-03-15 | 3/150 |
|
|
[考研] 289求調劑 +4 | 這么名字咋樣 2026-03-14 | 6/300 |
|
|
[碩博家園] 085600 260分求調劑 +3 | 天空還下雨么 2026-03-13 | 5/250 |
|