| 查看: 1632 | 回復: 12 | |||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | |||
[交流]
中譯英(30金幣求翻譯某產品使用說明)謝絕軟件
|
|||
|
請將以下文字翻譯成英文,難度應該不是很大,為某產品使用說明,謝絕軟件翻譯 使用說明 清潔表面:使用前必須清潔被沾表面,可用丙酮或酒精去除油污雜質,并使之干燥。雨季或冬季施工前應先用電吹風將被沾表面吹干后再粘接,會取得最佳粘接效果。 操作:滴涂適量膠液于工件表面,壓合,定位并擠出氣泡;在UV燈下照射10-15秒,待工件初固定位后,清理多余膠水,繼續照射至完全固話。UV燈波普,能量,照射距離可能會影響實際粘接效果。如工件時浮法玻璃,不宜在錫面粘接。 注意事項:本品對皮膚有輕微刺激,如不慎濺入眼睛,應立即用大量清水沖洗,并就醫。操作時防止紫外線直射眼睛以防灼傷。 存儲:于陰涼、干燥避光處保存,28度以下保質期12個月。本品不含苯及甲醛。無毒,無溶劑,可按危險品運輸。 [ Last edited by gylovejing on 2010-7-24 at 02:17 ] |
木蟲 (正式寫手)
foreverhappy
|
Direction for use clean surface:The touched surface must be cleaned before you use it, we can use acetone or alcohol for removing oil impurities ,and to make it dry.in the rainy season or winter construction ,for adhesiving you will be blown dry surface with a hair drye,which will achieve the best result. 先給你翻譯一段,你看行不,行我再接著翻譯。 [ Last edited by liufengbao100 on 2010-7-24 at 09:03 ] |

木蟲 (正式寫手)
foreverhappy
|
operation:Spread proper amount of the glue to workpiece surface,pressure,locate and squeeze the bubble. it was illuminated 10-15 seconds in the light of UV,after workpiece was fixed,first,you clean superfluous glue,then continue to illuminate to completely cured. UV lamp Pope, energy and illumination distance may affect bonding effect.If workpiece is float glass, You cannot adhese in the tin surface. notices: This product has a slight irritation to the skin, if it splash into the eyes,you should rinse immediately with plenty of water,and see a doctor .You should prevent ultraviolet light point-blank eyes in order to prevent burns eyes. Store:Avoid light in a cool, dry place,below 28 ℃ it can save 12 months.This product does not contain benzene and formaldehyde.Without solvent and toxic,according to the transport of dangerous product. 壓合我感覺是用pressure較好,pope是波普的意思。英語水平不是很高,僅供參考!呵呵 [ Last edited by liufengbao100 on 2010-7-24 at 14:43 ] |

|
Direction for use clean surface:The touched surface must be cleaned before you use it, we can use acetone or alcohol for removing oil impurities ,and to make it dry.in the rainy season or winter construction ,for adhesiving you will be blown dry surface with a hair dryer,which will achieve the best result. operation:Spread proper amount of the glue to workpiece surface,pressure,locate and squeeze the bubble. it was illuminated 10-15 seconds in the light of UV,after workpiece was fixed,first,you clean superfluous glue,then continue to illuminate to completely cured. UV lamp Pope, energy and illumination distance may affect bonding effect.If workpiece is float glass,You cannot adhese in the tin-surface. Attention items :This product has a slight irritation to the skin;eye contact,F(xiàn)lush with plenty of clean running water immediately ,then consult a physician. You should prevent ultraviolet light point-blank eyes in order to avoid ultraviolet light burns the eyes STORAGE:To be kept avoiding light in a cool, dry place, Quality guarantee for twelve- month,below 28 ℃。This product does not contain benzene and formaldehyde. It is innocuity and has no solvent。according to the transport of dangerous product. |
木蟲 (正式寫手)
foreverhappy
|
Direction for use clean surface:The touched surface must be cleaned before you use it, we can use acetone or alcohol for removing oil impurities ,and make it dry.In the rainy season or winter construction ,you will be blown dry surface with a hair dryerfor adhesiving ,which will achieve the best result. operation:Spread proper amount of the glue to workpiece surface,pressure,locate and squeeze the bubble. it was illuminated 10-15 seconds in the light of UV Pope,after workpiece was fixed,firstly you clean superfluous glue,then continue to illuminate to completely cured. UV Pope, energy and illumination distance may affect bonding effect.If workpiece is float glass,You cannot adhibit in the tin-surface. Attention items :This product has a slight irritation to the skin;if eye contact,flush with plenty of clean running water immediately ,then consult a physician. You should prevent ultraviolet light point-blank eyes in order to avoid ultraviolet light burns your eyes STORAGE:To be kept avoiding light in a cool, dry place, quality guarantee for twelve- months,below 28 ℃。This product does not contain benzene and formaldehyde. It is innocuity and has no solvent。according to the transport of dangerous product 修改好了,看看還有什么需要改的地方么。 [ Last edited by liufengbao100 on 2010-7-24 at 16:12 ] |

禁蟲 (職業作家)
|
Instruction for use: Cleaning Surface: The touched surface must be cleaned before using it.You can use acetone or alcohol for removing oil impurities,and make it dry. Before construction in the rainy season or winter , for gluing you need to blow dry the surface with a hair dryer, which will achieve the best result. Operation: Dispense proper amount of glue onto the surface, press it, locate it and squeeze out any air bubbles;Then, 10-15 seconds in the UV lamp irradiation ;After the workpiece is initially fixed, clean up the excess glue, and continue irradiating to completely cured. UV lamp spectrum, energy and irradiation distance may affect the actual bonding effect.If the workpiece is float glass,it is not suitable for bonding in the tin surface. Attention: This product stimulates mildly to the skin.If it accidentally splashes into the eyes, rinse immediately with plenty of water and seek medical advice. To prevent eyes from getting burnt ,you should avoid UV irradiation being in your eyes. Storage: Keep in a cool、dry place and protect from light. It will keep for 12 months if stored at a temperature below 28℃。This product does not contain benzene and formaldehyde. It is innocuity and has no solvent. Can be transpored according to the transport of dangerous product. [ Last edited by lwjamy on 2010-7-26 at 13:46 ] |

|
Instructions for Use Cleaning the Surface:The touched surface must be cleaned before use. Acetone or alcohol can be used to remove oil impurities. The surface needs to keep dry. In the rainy season or winter, for the better adhesive effect, you can blow the surface dry with a hair dryer before bonding. Operation: Spread proper amount of glue on the surface of the workpiece, press down, locate and squeeze the bubble. First illuminate in the light of UV for 10 to 15 seconds. After the workpiece was slightly fixed, you can clean the superfluous glue, then continue to illuminate to completely fixed. UV lamp pope, energy and illumination distance may affect bonding effect. If the workpiece is float glass,You can not adhibit on the tin-surface. Attention:This product has a slight irritation to skin;If splash it into eyes mindlessly, flush with plenty of clean running water immediately,then consult a physician. You should prevent ultraviolet light point-blank eyes from burning. Storage and Transportation:To be kept avoiding light in a cool, dry place, below 28 ℃, for quality guarantee of twelve-month. This product does not contain benzene and formaldehyde. It is innocuous and has no solvent。It can be transported as dangerous goods. |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 085700資源與環境308求調劑 +3 | 墨墨漠 2026-03-18 | 3/150 |
|
|---|---|---|---|---|
|
[考研] 求材料調劑 +8 | 隔壁陳先生 2026-03-12 | 8/400 |
|
|
[考研] 一志愿中海洋材料工程專碩330分求調劑 +5 | 小材化本科 2026-03-18 | 5/250 |
|
|
[考研] 311求調劑 +4 | 冬十三 2026-03-18 | 4/200 |
|
|
[考研] 354求調劑 +4 | Tyoumou 2026-03-18 | 7/350 |
|
|
[考研] 328求調劑,英語六級551,有科研經歷 +3 | 生物工程調劑 2026-03-17 | 7/350 |
|
|
[考研] 一志愿武理材料305分求調劑 +5 | 想上岸的鯉魚 2026-03-18 | 6/300 |
|
|
[考研] 286求調劑 +6 | lemonzzn 2026-03-16 | 9/450 |
|
|
[考研] 311求調劑 +11 | 冬十三 2026-03-15 | 12/600 |
|
|
[考研] 331求調劑(0703有機化學 +7 | ZY-05 2026-03-13 | 8/400 |
|
|
[考研] 288求調劑,一志愿華南理工大學071005 +4 | ioodiiij 2026-03-17 | 4/200 |
|
|
[考研] 304求調劑 +12 | 小熊joy 2026-03-14 | 13/650 |
|
|
[考研] 0703化學求調劑 總分331 +3 | ZY-05 2026-03-13 | 3/150 |
|
|
[考研] 307求調劑 +3 | 冷笙123 2026-03-17 | 3/150 |
|
|
[考研] 考研調劑 +3 | 淇ya_~ 2026-03-17 | 5/250 |
|
|
[考研] 一志愿211 0703方向310分求調劑 +3 | 努力奮斗112 2026-03-15 | 3/150 |
|
|
[考研] 285求調劑 +6 | ytter 2026-03-12 | 6/300 |
|
|
[考研] 294求調劑 +3 | Zys010410@ 2026-03-13 | 4/200 |
|
|
[考研] 學碩285求調劑 +13 | Wisjxn 2026-03-12 | 46/2300 |
|
|
[考研] 0703化學求調劑 +7 | 綠豆芹菜湯 2026-03-12 | 7/350 |
|