| 4 | 1/1 | 返回列表 |
| 查看: 968 | 回復: 3 | |||
又個七年木蟲 (著名寫手)
|
[交流]
這樣的修改意見是積極的嗎? 已有2人參與
|
|
各位蟲友大家好。 這次投了一篇文章到NEW journal of chemistry,終于等到了消息,但我總感覺到兇多吉少,以前也碰見過大修的狀況,但感覺都不如這一次更嚴峻,小弟只有求助各位大俠了,看看是個什么情況,畢竟我現在在準備十月9號的雅思考試,肯定沒那多精力搞論文了,但是這也是我放的心血最多的一篇論文了,小弟拜謝各位了: 以下是修改意見,貌似第一個審稿人就直接拒掉了 In view of the criticisms of the reviewers, I must decline the manuscript for publication in New Journal of Chemistry at this time. However, a new manuscript may be submitted which takes into consideration these comments and which resolves the problems raised by the reviewers. Please note that resubmitting your manuscript does not guarantee eventual acceptance, and that your resubmission will be subject to re-review by the reviewers before a decision is taken. Reviewer(s)' Comments to Author: Referee: 1 Comments to the Author The manuscript describes a facile, environmentally friendly hydrothermal route with tetrabutylammonium bromide (TBAB) as surfactant to prepare PbS macrostructures. The morphology of the final product can be easily controlled by changing the reaction parameters. Furthermore, the proposed formation mechanism and optical property of the PbS macrostructures are also presented. Unfortunately, there are still left many unclear questions in the manuscript. In addition, the contents of the manuscript lack novelty, logicality and significance. Specifically, there are some technical problems as listed below. (1) The language is OK but still needs some improvement. There are also some spelling errors, such as Page 7: line 3“CBAB”; Page 10: last line “PS”; Page 16: line 8“smoot”. (2) The authors claimed that the biggest advantage is to use TBAB as surfactant, and it has similar chemical structure with CTAB. So what’s the difference between them on manipulating the morphology of PbS crystals? Please cite reference or discuss about it. (3) As shown in Figure 2e, many nanocubes are observed through the magnified TEM image. Why these nanoparticles could exist? The authors just said that they prepared two different products from the same reaction process instead of explaining the reason and the reaction process is not reasonable. (4) Page 10: line 25“……as shown in Figure 5e.” The curve and labeling isn't matching in Figure 5. (5) The manuscript emphasizes on the adsorption and sustained release of S2+ by TBAB. However, the explanation of molecular structure is not clear in Figure 8. Even the chemical reaction equation can't explain how TBAB release of S2+? In conclusion, this manuscript does not reach the standard of New Journal of Chemistry. I do not recommend it for publication in New Journal of Chemistry. Referee: 2 Comments to the Author The manuscript describes the synthesis of hierarchical structures of PbS by employing a hydrothermal method. A surfactant, TBAB is used for sustained release of sulfide ions, which the authors claim to be crucial for the control of material architecture. The reaction product is analyzed by various microscopic and spectroscopic techniques. Authors varied the TBAB concentrations and other experimental parameters systematically and investigated its effect on morphology. The product morphology is not very attractive and there are many reports in the literature showing better control of morphology. The prospect of encasing H2S inside the precursor is interesting, and should be pursued by experimental verification. Therefore this part should be more convincingly stated. The important point in the article is the role of different reactants and the growth mechanism. The following questions should be more clearly addressed: 1. Why branching takes place at certain concentrations? What is the role of surfactant in branching? 2. How can the size of the product be reduced in order to obtain nanostructures? 3. If possible, a schematic should be provided to illustrate the growth mechanism. 4. The optical properties are rather preliminary and are not relevant to the study and therefore should be removed. There are several careless mistakes such as CTAB should be TBAB in line 3 of the section ‘effect of TBAB’. The manuscript should be accepted upon suitable modification by the authors. |
木蟲 (著名寫手)
| 4 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 一志愿華中科技大學071000,求調劑 +4 | 沿岸有貝殼6 2026-03-21 | 4/200 |
|
|---|---|---|---|---|
|
[考研] 一志愿北京化工大學070300 學碩336求調劑 +3 | vv迷 2026-03-21 | 4/200 |
|
|
[考研] 材料學碩301分求調劑 +7 | Liyouyumairs 2026-03-21 | 7/350 |
|
|
[考研] 材料求調劑 +5 | @taotao 2026-03-21 | 5/250 |
|
|
[考研] 333求調劑 +5 | 87639 2026-03-21 | 7/350 |
|
|
[考研] 306求0703調劑一志愿華中師范 +5 | 紙魚ly 2026-03-21 | 5/250 |
|
|
[考研] 299求調劑 +6 | △小透明* 2026-03-17 | 6/300 |
|
|
[考研] 265求調劑 +9 | 梁梁校校 2026-03-17 | 9/450 |
|
|
[考研] 一志愿重慶大學085700資源與環境專碩,總分308求調劑 +3 | 墨墨漠 2026-03-18 | 3/150 |
|
|
[考研] 274求調劑 +10 | S.H1 2026-03-18 | 10/500 |
|
|
[考研] 一志愿武漢理工材料工程專碩調劑 +9 | Doleres 2026-03-19 | 9/450 |
|
|
[考研] 324求調劑 +5 | lucky呀呀呀鴨 2026-03-20 | 5/250 |
|
|
[考研] 288求調劑 +16 | 于海海海海 2026-03-19 | 16/800 |
|
|
[考研] 329求調劑 +9 | 想上學吖吖 2026-03-19 | 9/450 |
|
|
[考研] 一志愿華中農業071010,總分320求調劑 +3 | 困困困困坤坤 2026-03-20 | 3/150 |
|
|
[考研] 環境工程調劑 +9 | 大可digkids 2026-03-16 | 9/450 |
|
|
[考研] 085600材料與化工調劑 324分 +10 | llllkkkhh 2026-03-18 | 12/600 |
|
|
[考研] 本科鄭州大學物理學院,一志愿華科070200學碩,346求調劑 +4 | 我不是一根蔥 2026-03-18 | 4/200 |
|
|
[考研] 070303 總分349求調劑 +3 | LJY9966 2026-03-15 | 5/250 |
|
|
[考研] 085601材料工程315分求調劑 +3 | yang_0104 2026-03-15 | 3/150 |
|