| 5 | 1/1 | 返回列表 |
| 查看: 873 | 回復: 4 | |||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | |||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | |||
[交流]
求助:翻譯摘要
|
|||
|
摘要:以原子比為3﹕1的Fe粉和Si粉球磨20 h后加入一定量的Cu,在(1000±30)℃,20 MPa的壓力下通過熱壓燒結的方法制備了致密的Fe3Si-Cu復合材料。通過浸泡腐蝕和電化學腐蝕兩種方法討論了加入不同質量分?jǐn)?shù)Cu(5%,10%)的Fe3Si-Cu復合材料在NaOH溶液中的腐蝕行為。結果表明,加入5%Cu的復合材料具有更好的耐腐蝕性能。Fe3Si-5%Cu的浸泡腐蝕速率要小,腐蝕的要輕一些;Fe3Si-5%Cu 和Fe3Si-10%Cu兩種材料在不同摩爾濃度的NaOH溶液中的極化曲線都出現了鈍化,有寬泛的鈍化區域,明顯的鈍化平臺,兩種材料在不同摩爾濃度的NaOH溶液中的腐蝕是一種均勻的全面腐蝕,沒有出現點蝕現象。比較極化曲線的特征值,F(xiàn)e3Si-5%Cu在0.7 mol/l的NaOH溶液中的自腐蝕電位更正,自腐蝕電流小,并且最先進入鈍化區,在鈍化區域,維鈍電流也小。 關鍵詞:球磨;熱壓燒結Fe3Si-Cu;Cu含量;浸泡腐蝕;電化學腐蝕 |
» 搶金幣啦!回帖就可以得到:
+2/154
+5/120
+1/96
+1/83
+1/81
+1/80
+1/63
+1/43
+1/29
+1/18
+1/16
+1/16
+1/15
+1/12
+1/9
+1/3
+1/3
+1/1
+1/1
+1/1
禁蟲 (職業作家)
|
以原子比為3﹕1的Fe粉和Si粉球磨20 h后加入一定量的Cu,在(1000±30)℃,20 MPa的壓力下通過熱壓燒結的方法制備了致密的Fe3Si-Cu復合材料。 With a Fe to S atomic ratio of 3, the mixture of the powders was ball ground for 20 h before adding a certain amount of Cu. Then dense Fe3Si-Cu composite material was prepared by hot-pressing of the resultant mixture under 20 MPa and (1000±30)℃. |
木蟲 (正式寫手)
|
abstract: With an atomic ratio of Fe/S=3,the mixture of the powders was ball milled for 20 h before adding some Cu.We have prepared dense Fe3Si-Cu composite material by the method of Hot-pressing Sinter-roasting under 20 MPa and (1000±30)℃.Also we discussed the corrosion behavior of Fe3Si-Cu composite material with different concentrations of Cu(5%,10%)in NaOH solution by two methods of static immersing corrosion and electrochemical corrosion.It turned out that the composite material with 5%Cu had better corrosion resistant.The speed of static immersing corrosion of Fe3Si-5%Cu was less,the extent of corrosion was also less.The polarization curves of Fe3Si-5%Cu and Fe3Si-10%Cu composite material appeared passivation in different molar concentrations of NaOH solution,and there was a broad area of passivation and apparently inactive platform.The corrosion of the two kinds of composite material was evenly rounded corrosion in different molar concentrations of NaOH solution.There was no pitting phenomenon appearing.Compared with characteristic values of the polarization curves,corrosion potential of Fe3Si-5%Cu revised in 0.7 mol/l of NaOH solution,its electric current of corrosion potential is small,and it went to area of passivation first .In area of passivation,maintaining passivity current was also small. keyword:ball mill,F(xiàn)e3Si-Cu by Hot-pressing Sinter-roasting,Cu content,static immersing corrosion,electrochemical corrosion |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 0805 316求調劑 +3 | 大雪深藏 2026-03-18 | 3/150 |
|
|---|---|---|---|---|
|
[考研] 求調劑 +5 | 十三加油 2026-03-21 | 5/250 |
|
|
[考研] 材料工程專碩 348分求調劑 +3 | 冬辭. 2026-03-17 | 5/250 |
|
|
[考研] 求調劑 +3 | 13341 2026-03-20 | 3/150 |
|
|
[考研] 316求調劑 +6 | 梁茜雯 2026-03-19 | 6/300 |
|
|
[考研] 初始318分求調劑(有工作經驗) +3 | 1911236844 2026-03-17 | 3/150 |
|
|
[考研] 一志愿華中科技大學,080502,354分求調劑 +5 | 守候夕陽CF 2026-03-18 | 5/250 |
|
|
[考研] 22408 344分 求調劑 一志愿 華電計算機技術 +4 | solanXXX 2026-03-20 | 4/200 |
|
|
[考研] 南京大學化學376求調劑 +3 | hisfailed 2026-03-19 | 6/300 |
|
|
[考研] 一志愿南昌大學,327分,材料與化工085600 +9 | Ncdx123456 2026-03-19 | 9/450 |
|
|
[考研]
|
然11 2026-03-19 | 4/200 |
|
|
[考研] 一志愿蘇州大學材料求調劑,總分315(英一) +5 | sbdksD 2026-03-19 | 5/250 |
|
|
[考研] 350求調劑 +5 | weudhdk 2026-03-19 | 5/250 |
|
|
[考研] 一志愿西安交通大學 學碩 354求調劑211或者雙一流 +3 | 我想要讀研究生 2026-03-20 | 3/150 |
|
|
[考研] 環境工程調劑 +9 | 大可digkids 2026-03-16 | 9/450 |
|
|
[考研] 招收調劑碩士 +4 | lidianxing 2026-03-19 | 12/600 |
|
|
[考研] 求調劑 +3 | 暗涌afhb 2026-03-16 | 3/150 |
|
|
[考研] 一志愿中國海洋大學,生物學,301分,求調劑 +5 | 1孫悟空 2026-03-17 | 6/300 |
|
|
[考研] 328求調劑,英語六級551,有科研經歷 +4 | 生物工程調劑 2026-03-16 | 12/600 |
|
|
[考研] 085601專碩,總分342求調劑,地區不限 +5 | share_joy 2026-03-16 | 5/250 |
|