| 4 | 1/1 | 返回列表 |
| 查看: 950 | 回復: 3 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
王靈杰金蟲 (初入文壇)
|
[求助]
150單詞獎勵150金幣(不夠再加 不差錢)
|
|
| The intensity ratio of the D and G bands (ID/IG) is commonly used to evaluate the quality of carbon materials. No obvious D band was observed for any of the MWCNTs dispersed on substrates (Supplementary Fig. 6), suggesting the high quality of the starting materials. The average ID/IG values were respectively 0.38, 0.30 and 0.28 for our single-, bi- and trilayer GNRs with 10–20-nm widths.Because defect density on the pristine MWCNTs was low, the D-band Raman signal of our GNRs should be mainly due to their open edges24,25. The ID/IG values were lower than those for GNRs obtained by lithographic etching of pristine graphene sheets (ID/IG was ,2 for a bilayer GNR of,28-nm width obtained by lithographic patterning (X. R. Wang et al., unpublished data); see Supplementary Fig. 5),indicating the high quality of our GNRs, in particular the high degree of edge smoothness. |
至尊木蟲 (職業作家)
| The intensity ratio of the D and G bands (ID/IG) is commonly used to evaluate the quality of carbon materials.D帶和G帶強度比常常用來評價碳材料的質量。 No obvious D band was observed for any of the MWCNTs dispersed on substrates (Supplementary Fig. 6), suggesting the high quality of the starting materials. 對任何分散在基質中的MWCNTs,均未能觀測到明顯的D帶,提示起始原料良好的質量。The average ID/IG values were respectively 0.38, 0.30 and 0.28 for our single-, bi- and trilayer GNRs with 10–20-nm widths. 我們寬度為10-20nm的單、雙和三層GNR的平均ID/IG 值分別為0.38、0.30和0.28。 Because defect density on the pristine MWCNTs was low, the D-band Raman signal of our GNRs should be mainly due to their open edges24,25. 由于原始MWCNT的缺陷密度低,所以我們的GNR的D帶拉曼信號主要應該是由于它們開放的邊緣。The ID/IG values were lower than those for GNRs obtained by lithographic etching of pristine graphene sheets (ID/IG was ,2 for a bilayer GNR of,28-nm width obtained by lithographic patterning (X. R. Wang et al., unpublished data); see Supplementary Fig. 5),indicating the high quality of our GNRs, in particular the high degree of edge smoothness.這些ID/IG值比由平板印刷蝕刻原始石墨烯片之軀的GNR的ID/IG值要低,提示我們的GNR具有較好的質量,尤其具有高度的邊緣平衡度。 |
金蟲 (職業作家)
| D帶和G帶的強度比通常用來評估含碳材料的質量。從分散的MWCNTs的底物(補充的圖表6)上沒有發現明顯的D帶,不能表明原始材料的高質量。平均的ID/IG的比值分別是0.38,0.30,0.28對應于單個的,兩個和三個革蘭氏陰性菌的10-20納米的寬度。有缺點的密度在早期的MWCNTs上很低,革蘭氏陰性菌的D帶的拉曼信號主要歸功于它們開放的邊緣24,25.革蘭氏陰性菌的ID/IG的比值低于這些從原始的石板印刷的已經腐蝕的圖表中得到的數據(從圖表中獲得的ID/IG的比值是2,對于雙分子層的革蘭氏陰性菌其寬度是28納米)(X. R. Wang 等未公開的數據);參看補充的圖表5),表明我們的革蘭氏陰性菌的高質量,部分是高純度的邊緣光滑度。 |
至尊木蟲 (職業作家)
| 4 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 一志愿中南化學337求調劑 +3 | niko- 2026-03-19 | 4/200 |
|
|---|---|---|---|---|
|
[考博] 招收博士1-2人 +3 | QGZDSYS 2026-03-18 | 3/150 |
|
|
[考研] 一志愿吉林大學材料學碩321求調劑 +11 | Ymlll 2026-03-18 | 14/700 |
|
|
[考研] 材料080500調劑求收留 +6 | 一顆meteor 2026-03-13 | 6/300 |
|
|
[考研] 295材料求調劑,一志愿武漢理工085601專碩 +3 | Charlieyq 2026-03-19 | 3/150 |
|
|
[考研]
|
不想起名字112 2026-03-19 | 3/150 |
|
|
[考研] 307求調劑 +9 | 冷笙123 2026-03-17 | 9/450 |
|
|
[考研] 288求調劑 +15 | 于海海海海 2026-03-19 | 15/750 |
|
|
[考博] 申博26年 +3 | 八6八68 2026-03-19 | 3/150 |
|
|
[考研] 288求調劑,一志愿華南理工大學071005 +5 | ioodiiij 2026-03-17 | 5/250 |
|
|
[考研] 一志愿天津大學化學工藝專業(081702)315分求調劑 +11 | yangfz 2026-03-17 | 11/550 |
|
|
[考研] 求調劑,一志愿:南京航空航天大學大學 ,080500材料科學與工程學碩,總分289分 +3 | @taotao 2026-03-19 | 3/150 |
|
|
[考研] 0703化學調劑,求各位老師收留 +10 | 秋有木北 2026-03-14 | 10/500 |
|
|
[考研] 材料專業求調劑 +5 | hanamiko 2026-03-18 | 5/250 |
|
|
[考研] 311求調劑 +11 | 冬十三 2026-03-15 | 12/600 |
|
|
[考研]
|
胡辣湯放糖 2026-03-15 | 6/300 |
|
|
[考研] 268求調劑 +8 | 一定有學上- 2026-03-14 | 9/450 |
|
|
[考研] 一志愿蘇州大學材料工程(085601)專碩有科研經歷三項國獎兩個實用型專利一項省級立項 +6 | 大火山小火山 2026-03-16 | 8/400 |
|
|
[考研] [導師推薦]西南科技大學國防/材料導師推薦 +3 | 尖角小荷 2026-03-16 | 6/300 |
|
|
[考研] 330求調劑 +3 | ?醬給調劑跪了 2026-03-13 | 3/150 |
|