| 5 | 1/1 | 返回列表 |
| 查看: 968 | 回復: 3 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | ||
王靈杰金蟲 (初入文壇)
|
[求助]
150單詞獎勵150金幣(不夠再加 不差錢)
|
|
| The intensity ratio of the D and G bands (ID/IG) is commonly used to evaluate the quality of carbon materials. No obvious D band was observed for any of the MWCNTs dispersed on substrates (Supplementary Fig. 6), suggesting the high quality of the starting materials. The average ID/IG values were respectively 0.38, 0.30 and 0.28 for our single-, bi- and trilayer GNRs with 10–20-nm widths.Because defect density on the pristine MWCNTs was low, the D-band Raman signal of our GNRs should be mainly due to their open edges24,25. The ID/IG values were lower than those for GNRs obtained by lithographic etching of pristine graphene sheets (ID/IG was ,2 for a bilayer GNR of,28-nm width obtained by lithographic patterning (X. R. Wang et al., unpublished data); see Supplementary Fig. 5),indicating the high quality of our GNRs, in particular the high degree of edge smoothness. |
至尊木蟲 (職業作家)
至尊木蟲 (職業作家)
| The intensity ratio of the D and G bands (ID/IG) is commonly used to evaluate the quality of carbon materials.D帶和G帶強度比常常用來評價碳材料的質量。 No obvious D band was observed for any of the MWCNTs dispersed on substrates (Supplementary Fig. 6), suggesting the high quality of the starting materials. 對任何分散在基質中的MWCNTs,均未能觀測到明顯的D帶,提示起始原料良好的質量。The average ID/IG values were respectively 0.38, 0.30 and 0.28 for our single-, bi- and trilayer GNRs with 10–20-nm widths. 我們寬度為10-20nm的單、雙和三層GNR的平均ID/IG 值分別為0.38、0.30和0.28。 Because defect density on the pristine MWCNTs was low, the D-band Raman signal of our GNRs should be mainly due to their open edges24,25. 由于原始MWCNT的缺陷密度低,所以我們的GNR的D帶拉曼信號主要應該是由于它們開放的邊緣。The ID/IG values were lower than those for GNRs obtained by lithographic etching of pristine graphene sheets (ID/IG was ,2 for a bilayer GNR of,28-nm width obtained by lithographic patterning (X. R. Wang et al., unpublished data); see Supplementary Fig. 5),indicating the high quality of our GNRs, in particular the high degree of edge smoothness.這些ID/IG值比由平板印刷蝕刻原始石墨烯片之軀的GNR的ID/IG值要低,提示我們的GNR具有較好的質量,尤其具有高度的邊緣平衡度。 |
金蟲 (職業作家)
| D帶和G帶的強度比通常用來評估含碳材料的質量。從分散的MWCNTs的底物(補充的圖表6)上沒有發現明顯的D帶,不能表明原始材料的高質量。平均的ID/IG的比值分別是0.38,0.30,0.28對應于單個的,兩個和三個革蘭氏陰性菌的10-20納米的寬度。有缺點的密度在早期的MWCNTs上很低,革蘭氏陰性菌的D帶的拉曼信號主要?dú)w功于它們開放的邊緣24,25.革蘭氏陰性菌的ID/IG的比值低于這些從原始的石板印刷的已經腐蝕的圖表中得到的數據(從圖表中獲得的ID/IG的比值是2,對于雙分子層的革蘭氏陰性菌其寬度是28納米)(X. R. Wang 等未公開的數據);參看補充的圖表5),表明我們的革蘭氏陰性菌的高質量,部分是高純度的邊緣光滑度。 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 083000學碩274求調劑 +10 | Li李魚 2026-03-26 | 10/500 |
|
|---|---|---|---|---|
|
[考研] 083000環境科學與工程調劑,總分281 +4 | 橙子(勝意) 2026-03-30 | 4/200 |
|
|
[考研] 266分,求材料相關專業調劑 +6 | 哇呼哼呼哼 2026-03-30 | 8/400 |
|
|
[考研] 288資源與環境專碩求調劑,不限專業,有學上就行 +11 | lllllos 2026-03-30 | 11/550 |
|
|
[考研] 297 地理學070500 復試求調劑 +3 | 小圓圈圈ooo 2026-03-30 | 3/150 |
|
|
[考研] 311求調劑 +7 | 藍月亮亮 2026-03-30 | 7/350 |
|
|
[考研] 310求調劑 +10 | 爭取九點睡 2026-03-30 | 10/500 |
|
|
[考研] 化學308分調劑 +7 | 你好明天你好 2026-03-30 | 8/400 |
|
|
[考研] 0703本科鄭州大學求調劑 +7 | nhj_ 2026-03-25 | 7/350 |
|
|
[考研] 298求調劑 +4 | 種圣賜 2026-03-28 | 4/200 |
|
|
[考研] 266分,求材料冶金能源化工等調劑 +7 | 哇呼哼呼哼 2026-03-27 | 9/450 |
|
|
[考研] 286求調劑 +12 | PolarBear11 2026-03-26 | 12/600 |
|
|
[考研] 材料求調劑一志愿哈工大324 +7 | 閆旭東 2026-03-28 | 9/450 |
|
|
[考研] 295求調劑 +5 | 1428151015 2026-03-27 | 6/300 |
|
|
[考研] 086000調劑 +3 | 7901117076 2026-03-26 | 3/150 |
|
|
[考研] 求調劑 +4 | 零八# 2026-03-27 | 4/200 |
|
|
[考研] 0703化學一志愿南京師范大學303求調劑 +3 | zzffylgg 2026-03-24 | 3/150 |
|
|
[考研] 一志愿吉大071010,316分求調劑 +3 | xgbiknn 2026-03-27 | 3/150 |
|
|
[考研] 機械學碩總分317求調劑。。。 +4 | Acaciad 2026-03-25 | 4/200 |
|
|
[考研] 調劑 +4 | 13853210211 2026-03-24 | 4/200 |
|