| 5 | 1/1 | 返回列表 |
| 查看: 544 | 回復: 4 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | ||
子時至尊木蟲 (著名寫手)
|
[求助]
(急)幾段期刊論文翻譯。
|
|
|
Freezing processes Two freezing processeswere applied: air-blast freezing (conventional method) was performed in a pilot freezer (Servathin, Poissy, France) at −30 °C using an air speed 4 m/s, during 2 h (AF samples); pressure shift freezing (PSF samples) was carried out in a 3.5 L reactor unit (ACB Pressure Systems, Nantes, France) equipped with temperature and pressure regulator device. The temperature of the transmittingmedium (ethanol/water 50/50 %v/v) was maintained at −18 °C. Samples were placed in the vessel and the pressurewas increased to 200 MPa at a rate of 3 MPa/s.When the temperature of samples reached−18 °C, pressure was rapidly released (2 s) to initiate the nucleation process. After depressurization, samples were left in the vessel for completion of the freezing under atmospheric conditions. Microstructure analysis Small pieces (approximately 5×5×10mm) were cut transversally to the fibers of frozen muscle inside a chamber at −20 °C. The isothermal freeze substitution technique (Martino & Zaritzky, 1986) was carried out with some modifications in these samples to visualize the size and location of the ice crystals. Pieces (3 pieces/sample, 2 samples/system) were placed in a fixative solution at −20 °C (Carnoy solution: 60% ethanol absolute, 30% chloroform, and 30% glacial acetic acid). In the case of unfrozen samples (F), cuts and fixation were performed in a chamber at 5 °C. After fixation (24–48 h), samples were brought to room temperature, dehydrated with ethanol absolute (2 h), ethanol:toluene (50:50 %v/v) overnight and treated with toluene (4– 5 h). Dehydrated samples were consecutively immersed in toluene/ paraffin solutions of increasing paraffin concentration at 60 °C (1 h each) and in paraffin pure (2 h). Finally, samples were embedded in paraffin in small molds. Ten μm thick sections (4 sections/piece) were obtainedwith amicrotome (SM-2000-R, LeicaMicrosystems, Bensheim, Germany) and fixed to glass plates with glycerin albumin inwater (1/ 25 v/v), heating at 57 °C to melting the paraffin. After paraffin removing (toluene, twice, 10 min), solvent elimination (ethanol absolute) and rehydration (ethanol:water and pure water), sections were stained. First, samples were treated for 2 min with Orange G (0.5 g Orange G, 1 ml acetic acid, 99 ml distilled water, filtered at 0.45 μm), which stained muscle proteins orange. After washing with distilled water, a second staining with Aniline blue for 2 min (0.01 g Aniline blue, 1 ml acetic acid, 99 ml distilled water, filtered at 0.45 μm) was performed (for collagen staining) (Chéret, Chapleau, Delbarre-Ladrat, Verrez-Bagnis & Lamballerie, 2006). Stained sections were mounted with Eukitt (Labonord, France). Observations were carried out in a microscope (Leica DML, Germany) equipped with a CCD RGB camera (MACC-C71, Sony, Japan). |

鐵蟲 (小有名氣)

木蟲 (正式寫手)
|
冷凍過程 兩個凍結過程被應用到:空氣鼓風凍結(常規方法)使用先進的冷凍器( Servathin ,法國,Poissy )在-30℃下使用的空氣速度為4米/秒,約2小時; 壓力移位冷凍( PSF樣本)在一個3.5升的反應器單元(ACB壓力系統, Nantes,法國)執行,配備溫度和壓力調節器。轉變媒介 (乙醇/水的50 / 50%體積/體積)的溫度保持在-18 ℃。樣品被放置在容器里和壓力 以3兆帕/ s的速率增加到200兆帕。當樣品溫度達到18 ° C時,壓力在兩秒鐘內 迅速釋放開始成核過程。減壓后,將樣品留在容器中,在大氣條件下完成凍結。 ( ⊙o⊙。┩厶L(zhǎng)了! |

至尊木蟲 (著名寫手)

木蟲 (正式寫手)
|
好吧!給你翻一下吧!你大致看看!記得給金幣哦! 微觀結構分析 小片(約5×5 ×10mm的)于-20℃下的腔室內部,冷凍肌肉纖維被橫向的切斷。等溫凍結取代技術(馬蒂諾及Zaritzky 1986 )在這些樣品中進行了一些修改為了適應可視化的冰晶體的大小和位置。樣品( 3片/ 樣本,2個/系統)被放置在在-20℃ (卡諾溶液: 60%無水乙醇, 30%氯仿, 30 %冰乙酸固定液酸)。至于解凍的樣品(F),在一個腔室中進行在5 ℃下削減和固定。樣品固定后( 24-48小時) ,然后拿至室溫,用無水乙醇( 2小時) ,乙醇:甲苯(50:50 %體積/體積)中過夜脫水,并用甲苯(4 - 5小時)處理。連續脫水的樣品浸漬在甲苯/鏈烷烴的溶液中增加石蠟的濃度,在60℃下(每只1小時) ,并在石蠟中純的( 2小時) 。最后,將樣品在小型模具中嵌入石蠟。 10微米厚的部分是從顯微鏡下觀察到的 ( SM-2000 -R , Leica Microsystems ,本斯海姆,德國) (4節/件)并且,固定在玻璃板與甘油白蛋白水中( 1/25 V / V) ,加熱到57°C熔化的石蠟。石蠟去除后(甲苯,兩次,10分鐘) ,消除(無水乙醇)和補液溶劑(乙醇:水和純凈水) ,切片進行染色。首先,樣品用Orange G( G, 0.5克橙1毫升醋酸,99毫升蒸餾水,過濾0.45微米)前處理2分鐘,把肌肉蛋白質染色成橙色,持續2分鐘。用蒸餾水洗滌后, 在用苯胺藍(0.01克苯胺藍, 1毫升乙酸,99毫升蒸餾水中,在0.45微米的過濾)進行了染色2分鐘(膠原染色) , ( Chéret ,普洛, Verrez - Bagnis Lamballerie , 2006年) 。染色部分被安裝在Eukitt ( Labonord ,法國) 中的顯微鏡(Leica DML,德國)的配備的CCD RGB攝像頭(MACC -C71 ,索尼,日本)下進行了觀察。 |

| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 274求調劑 +4 | 薛定諤的虎。 2026-04-01 | 4/200 |
|
|---|---|---|---|---|
|
[考研] 266求調劑 +7 | 陽陽哇塞 2026-04-01 | 7/350 |
|
|
[考研] 319求調劑 +9 | 太容易1018 2026-04-01 | 9/450 |
|
|
[考研] 求調劑推薦 材料 304 +21 | 荷包蛋hyj 2026-03-26 | 21/1050 |
|
|
[考研] 286求調劑 +5 | lim0922 2026-03-26 | 5/250 |
|
|
[考研] 材料科學與工程339求調劑 +11 | hyz0119 2026-03-31 | 12/600 |
|
|
[考研] 材料專業調劑 +5 | 啦啦啦哭 2026-03-31 | 6/300 |
|
|
[考研]
|
y7czhao 2026-03-26 | 11/550 |
|
|
[考研] 生物學 296 求調劑 +9 | 朵朵- 2026-03-26 | 11/550 |
|
|
[考研] 考研調劑 +11 | Amber00 2026-03-31 | 11/550 |
|
|
[考研] 291求調劑 +3 | 迷蒙木木 2026-04-01 | 4/200 |
|
|
[考研] 318一志愿吉林大學生物與醫藥 求調劑 +6 | 篤行致遠. 2026-03-28 | 6/300 |
|
|
[考研] 各位老師好,我的一志愿為北京科技大學085601材料專碩 +12 | Koxui 2026-03-28 | 12/600 |
|
|
[考研] 0703化學 +20 | 妮妮ninicgb 2026-03-27 | 20/1000 |
|
|
[考研] 085600材料與化工調劑 +16 | kikiki7 2026-03-30 | 16/800 |
|
|
[考研] 323分 食品與營養調劑 +3 | 嘿ooo 2026-03-31 | 3/150 |
|
|
[考研] 334分 一志愿武理 材料求調劑 +16 | 李李不服輸 2026-03-26 | 16/800 |
|
|
[考研] 293求調劑 +3 | 末未mm 2026-03-30 | 5/250 |
|
|
[考研] 環境科學與工程334分求調劑 +6 | 王一一依依 2026-03-30 | 8/400 |
|
|
[考研] 295求調劑 +5 | 1428151015 2026-03-27 | 6/300 |
|