| 查看: 5415 | 回復: 30 | ||
liliandxixi新蟲 (初入文壇)
|
[求助]
誰能教教我怎么對響應面的結果進行分析 已有7人參與
|
|
我的響應面做完了,但是其中的失擬項后面沒有P值和F值,因此我就不能確定其的顯著性,我想知道這是為什么,我已經做了2次了,望大家賜教。急啊~~~~~~ 謝謝了 |
金蟲 (小有名氣)
新蟲 (初入文壇)
新蟲 (初入文壇)
|
Use your mouse to right click on individual cells for definitions. Response 1 浸提液中花青素質量濃度 ANOVA for Response Surface Quadratic Model Analysis of variance table [Partial sum of squares - Type III] Sum of Mean F p-value Source Squares df Square Value Prob > F Model 0.49 9 0.054 21.41 0.0003 significant A-X1 時間 3.916E-003 1 3.916E-003 1.55 0.2530 B-X2 溫度 0.028 1 0.028 11.17 0.0124 C-X3 料液比 0.027 1 0.027 10.85 0.0132 AB 0.088 1 0.088 34.95 0.0006 AC 7.832E-003 1 7.832E-003 3.10 0.1215 BC 0.011 1 0.011 4.16 0.0807 A^2 0.11 1 0.11 45.41 0.0003 B^2 0.12 1 0.12 48.21 0.0002 C^2 0.052 1 0.052 20.46 0.0027 Residual 0.018 7 2.524E-003 Lack of Fit 0.018 3 5.890E-003 Pure Error 0.000 4 0.000 Cor Total 0.50 16 The Model F-value of 21.41 implies the model is significant. There is only a 0.03% chance that a "Model F-Value" this large could occur due to noise. Values of "Prob > F" less than 0.0500 indicate model terms are significant. In this case B, C, AB, A++2+-, B++2+-, C++2+- are significant model terms. Values greater than 0.1000 indicate the model terms are not significant. If there are many insignificant model terms (not counting those required to support hierarchy), model reduction may improve your model. Std. Dev. 0.050 R-Squared 0.9649 Mean 5.50 Adj R-Squared 0.9199 C.V. % 0.91 Pred R-Squared 0.4391 PRESS 0.28 Adeq Precision 14.663 The "Pred R-Squared" of 0.4391 is not as close to the "Adj R-Squared" of 0.9199 as one might normally expect. This may indicate a large block effect or a possible problem with your model and/or data. Things to consider are model reduction, response tranformation, outliers, etc. "Adeq Precision" measures the signal to noise ratio. A ratio greater than 4 is desirable. Your ratio of 14.663 indicates an adequate signal. This model can be used to navigate the design space. Coefficient Standard 95% CI 95% CI Factor Estimate df Error Low High VIF Intercept 5.71 1 0.022 5.65 5.76 A-X1 時間 0.022 1 0.018 -0.020 0.064 1.00 B-X2 溫度 0.059 1 0.018 0.017 0.10 1.00 C-X3 料液比 0.059 1 0.018 0.016 0.10 1.00 AB -0.15 1 0.025 -0.21 -0.089 1.00 AC 0.044 1 0.025 -0.015 0.10 1.00 BC -0.051 1 0.025 -0.11 8.150E-003 1.00 A^2 -0.17 1 0.024 -0.22 -0.11 1.01 B^2 -0.17 1 0.024 -0.23 -0.11 1.01 C^2 -0.11 1 0.024 -0.17 -0.053 1.01 Final Equation in Terms of Coded Factors: 浸提液中花青素質量濃度 = +5.71 +0.022 * A +0.059 * B +0.059 * C -0.15 * A * B +0.044 * A * C -0.051 * B * C -0.17 * A^2 -0.17 * B^2 -0.11 * C^2 Final Equation in Terms of Actual Factors: 浸提液中花青素質量濃度 = -6.13650 +2.79225 * X1 時間 +0.52027 * X2 溫度 +0.11635 * X3 料液比 -0.059400 * X1 時間 * X2 溫度 +8.85000E-003 * X1 時間 * X3 料液比 -1.02500E-003 * X2 溫度 * X3 料液比 -0.66000 * X1 時間^2 -6.80000E-003 * X2 溫度 ^2 -1.10750E-003 * X3 料液比^2 The Diagnostics Case Statistics Report has been moved to the Diagnostics Node. In the Diagnostics Node, Select Case Statistics from the View Menu. Proceed to Diagnostic Plots (the next icon in progression). Be sure to look at the: 1) Normal probability plot of the studentized residuals to check for normality of residuals. 2) Studentized residuals versus predicted values to check for constant error. 3) Externally Studentized Residuals to look for outliers, i.e., influential values. 4) Box-Cox plot for power transformations. If all the model statistics and diagnostic plots are OK, finish up with the Model Graphs icon. |
新蟲 (初入文壇)
新蟲 (小有名氣)
新蟲 (小有名氣)
新蟲 (初入文壇)
新蟲 (小有名氣)
新蟲 (初入文壇)
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 296求調劑 +4 | 大口吃飯 身體健 2026-03-13 | 4/200 |
|
|---|---|---|---|---|
|
[碩博家園] 湖北工業大學 生命科學與健康學院-課題組招收2026級食品/生物方向碩士 +3 | 1喜春8 2026-03-17 | 5/250 |
|
|
[考研] 302求調劑 +9 | 負心者當誅 2026-03-11 | 9/450 |
|
|
[碩博家園] 深圳大學碩士招生(2026秋,傳感器方向,僅錄取第一志愿) +4 | xujiaoszu 2026-03-11 | 9/450 |
|
|
[文學芳草園] 伙伴們,祝我生日快樂吧 +17 | myrtle 2026-03-10 | 26/1300 |
|
|
[考研] 0854控制工程 359求調劑 可跨專業 +3 | 626776879 2026-03-14 | 9/450 |
|
|
[考研] 304求調劑 +3 | 曼殊2266 2026-03-14 | 3/150 |
|
|
[考研] 070303 總分349求調劑 +3 | LJY9966 2026-03-15 | 5/250 |
|
|
[考研] 326求調劑 +3 | mlpqaz03 2026-03-15 | 3/150 |
|
|
[考研] 289求調劑 +4 | 這么名字咋樣 2026-03-14 | 6/300 |
|
|
[考研] 330求調劑 +3 | ?醬給調劑跪了 2026-03-13 | 3/150 |
|
|
[考研] 266求調劑 +4 | 學員97LZgn 2026-03-13 | 4/200 |
|
|
[考研] 材料工程調劑 +9 | 咪咪空空 2026-03-12 | 9/450 |
|
|
[考研] 材料工程調劑 +4 | 咪咪空空 2026-03-11 | 4/200 |
|
|
[考研] 274求調劑 +3 | S.H1 2026-03-12 | 3/150 |
|
|
[考研] 085600材料與化工 309分請求調劑 +7 | dtdxzxx 2026-03-12 | 8/400 |
|
|
[考研] 308求調劑 +3 | 是Lupa啊 2026-03-12 | 3/150 |
|
|
[論文投稿]
投稿問題
5+4
|
星光燦爛xt 2026-03-12 | 6/300 |
|
|
[考研] 0817化學工程與技術考研312分調劑 +3 | T123 tt 2026-03-12 | 3/150 |
|
|
[考研] 283求調劑,材料、化工皆可 +8 | 蘇打水7777 2026-03-11 | 10/500 |
|