 |
 |
 |
 |
 |
 |
||
 |
 |
 |
 |
 |
| 3 | 1/1 | 返回列表 |
| 查看: 502 | 回復: 2 | ||
| 本帖產生 1 個 翻譯EPI ，點擊這里進行查看 | ||
[求助]
拿出一半家產,求高手幫我的一段英文潤色啊.謝謝
|
||
|
1。The structures of the AlN(1 nm)/MN(d nm)/AlN(1 nm) are sketched in Fig. 1 (a). Fig. 1 (b) shows the AR-H curves for the AlN(1 nm)/MN(d nm)/AlN(1 nm) films [d =5, 30, 80] before and after annealing at 400 °C. One can see the AR value drops from 1.0% for the as-deposited sample to about only 0.2% for the annealed one when d =5 nm. However, for d =30 nm, the AR value reaches about 3% for the annealed sample, which is very close to that of the sample in the as-grown state. In contrast, when d =80 nm, the AR value increases from 3.7% for the as-deposited sample to 4.7% for the annealed one, the value of which even exceeds the bulk value. As expected, Figure 1(c) shows the relationship between the AR and the MN thickness for the AlN/MN/AlN before and after annealing at 400 °C. It is noted that the AR values of the annealed samples are significantly lower than those of the as-grown ones when d < 30nm, whereas when the film thickness exceeds a critical thickness of 30nm, AR values of the annealed samples are significantly higher than those of the as-deposited samples. Apparently, AR change after annealing shows a significant thickness dependent behavior. 文中有些結構被替換掉了，請見諒 2. the grain size changes little after annealing, so in this case, what causing the abnormal resistivity increase and the resulted AR reduction remains indefinitive. [ Last edited by 檸檬樹 on 2013-3-23 at 12:05 ] |
回復此樓» 猜你喜歡
280求調劑
已經有7人回復
-
環境領域全國重點實驗室招收博士1-2名
已經有5人回復
-
303求調劑
已經有6人回復
-
290求調劑
已經有10人回復
-
0703化學求調劑 總分331
已經有3人回復
-
一志愿天津大學化學工藝專業（081702）315分求調劑
已經有8人回復
-
0703化學調劑
已經有3人回復
-
材料，紡織，生物（0856、0710），化學招生啦
已經有9人回復
-
一志愿中國海洋大學，生物學，301分，求調劑
已經有3人回復
-
0703化學調劑 ，六級已過，有科研經歷
已經有9人回復
bwshanxi
至尊木蟲 (文壇精英)
- 翻譯EPI: 4
- 應助: 292 (大學生)
- 金幣: 17072.6
- 紅花: 18
- 帖子: 15794
- 在線: 878.9小時
- 蟲號: 454546
- 注冊: 2007-11-09
- 性別: GG
- 專業: 有機分子功能材料化學
【答案】應助回帖
| 結構AlN（1納米）/ MN（d納米）/AlN（1納米）的繪制如圖1（a）圖1（b）表示退火前和退火后對AR-H的AlN（1納米）/ MN（d納米）/AlN（1納米）薄膜〔d= 5，30，80] 曲線在400℃�？梢钥吹紸R值從1.0％下降為沉積的樣品大約只有0.2％的退火當d =5納米時候。然而，當d =30nm時候，在AR值達到退火的樣品的約3％，這是非常接近在生長狀態的樣品。相反，當d =80nm時候，AR的值從3.7％增加為沉積樣品退火的1至4.7％，甚至超過大容量值，它的值。正如預期的那樣，圖1（c）示出的關系之間的AR和MN厚度的AlN/ MN/ AlN成前和退火后，在400℃下值得注意的是，退火后的樣品的AR值明顯低于那些生長的當d<30nm左右，而當薄膜厚度超過某一臨界厚度為30nm時，退火后的樣品的AR值顯著高于如此沉積的樣品。顯然，AR變化后退火顯示了顯著的厚度依賴行為。 |
2樓2013-03-23 12:48:41
hookhans
鐵桿木蟲 (著名寫手)
Farmer
- 翻譯EPI: 263
- 應助: 186 (高中生)
- 貴賓: 0.142
- 金幣: 8087.5
- 散金: 576
- 紅花: 51
- 帖子: 2080
- 在線: 400.1小時
- 蟲號: 2260260
- 注冊: 2013-01-25
- 專業: 催化化學
【答案】應助回帖
★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
檸檬樹: 金幣+30, 翻譯EPI+1, ★★★★★最佳答案, 非常有用 非常感謝啊 2013-03-23 16:30:52
檸檬樹: 金幣+30, 翻譯EPI+1, ★★★★★最佳答案, 非常有用 非常感謝啊 2013-03-23 16:30:52
|
1。The structures of the AlN(1 nm)/MN(d nm)/AlN(1 nm) and the AR-H curves of the AlN(1 nm)/MN(d nm)/AlN(1 nm) films [d =5, 30, 80] before and after annealing at 400 °C are shown in Fig. 1 (a) and Fig. 1 (b), respectively. It can be seen that the AR value drops from 1.0% to 0.2% after annealing the sample with d =5 nm. However, for the sample with d =30 nm, the AR value reaches about 3% after annealing, which is very close to that of the as-grown sample. In contrast, the AR value increases from 3.7% to 4.7% for the sample with d =80 nm after annealing, (the value of) which even exceeds the bulk value. Figure 1(c) shows the relationship between the AR and the MN thickness of the AlN/MN/AlN before and after annealing at 400 °C. It is noted that the AR values of the annealed samples are significantly lower than those of the as-grown ones when d < 30nm, whereas the AR values of the annealed samples are significantly higher than those of the as-deposited samples when the film thickness exceeds a critical thickness of 30nm. Apparently, AR change after annealing shows a significant thickness dependent behavior. 2. Since the grain size changes little after annealing, it still remains unclear exactly what causes the increase of the abnormal resistivity and the consequent AR reduction. |
3樓2013-03-23 16:16:15
相關版塊跳轉
我要訂閱樓主 檸檬樹 的主題更新
| 3 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 0703化學調劑 +3 | 妮妮ninicgb 2026-03-17 | 3/150 |
|
|---|---|---|---|---|
|
|
[考研] 材料，紡織，生物（0856、0710），化學招生啦 +3 | Eember. 2026-03-17 | 9/450 |
|
|
[考研] 307求調劑 +3 | 冷笙123 2026-03-17 | 3/150 |
|
|
|
[考研] 環境工程調劑 +8 | 大可digkids 2026-03-16 | 8/400 |
|
|
|
[考研] 268求調劑 +7 | 好運連綿不絕 2026-03-12 | 8/400 |
|
|
|
[考研] 材料與化工求調劑 +6 | 為學666 2026-03-16 | 6/300 |
|
|
|
[考研] 211本，11408一志愿中科院277分，曾在中科院自動化所實習 +6 | Losir 2026-03-12 | 7/350 |
|
|
|
[考研] 一志愿211 0703方向310分求調劑 +3 | 努力奮斗112 2026-03-15 | 3/150 |
|
|
|
[考研] 327求調劑 +6 | 拾光任染 2026-03-15 | 11/550 |
|
|
|
[考研] 070305求調劑 +3 | mlpqaz03 2026-03-14 | 4/200 |
|
|
|
[考研] 本科南京大學一志愿川大藥學327 +3 | 麥田耕者 2026-03-14 | 3/150 |
|
|
|
[考研] 材料與化工 323 英一+數二+物化，一志愿：哈工大 本人本科雙一流 +4 | 自由的_飛翔 2026-03-13 | 5/250 |
|
|
|
[考研] 297一志愿上交085600求調劑 +5 | 指尖八千里 2026-03-14 | 5/250 |
|
|
|
[考研] 308 085701 四六級已過求調劑 +7 | 溫喬喬喬喬 2026-03-12 | 14/700 |
|
|
|
[考研] 329求調劑 +3 | miaodesi 2026-03-12 | 4/200 |
|
|
|
[考研] 材料工程調劑 +4 | 咪咪空空 2026-03-11 | 4/200 |
|
|
|
[考研] 求調劑 +7 | 18880831720 2026-03-11 | 7/350 |
|
|
|
[考研] 考研調劑 +4 | 芬達46 2026-03-12 | 4/200 |
|
|
|
[考研] 308求調劑 +3 | 是Lupa啊 2026-03-12 | 3/150 |
|
|
|
[考博] 福州大學楊黃浩課題組招收2026年專業學位博士研究生，2026.03.20截止 +3 | Xiangyu_ou 2026-03-12 | 3/150 |
|