| 7 | 1/1 | 返回列表 |
| 查看: 1706 | 回復: 6 | |||
[求助]
求給我翻譯一下呀、馬上就要交了。
|
|
以鋼桁梁橋為代表的桁架結構在各類工程設計中越來越多的被采用,連續鋼桁梁橋以其跨越能力強、自重小、制造方便、安裝速度快、施工工期短等優點成為建造大跨度橋梁時的首選方案。本設計為設計計算跨度為3*120m的下承式變截面雙線鐵路連續鋼桁梁橋。 本設計主要進行上部結構和制動墩的設計。首先進行上部結構設計,主桁節間長度定為12m,桁間距為11.2m,邊支點桁高14m,中支點桁高25m。主桁桿件選擇箱形截面、橫向連接采用工字形截面,擬定截面尺寸。然后利用有限元法建立橋梁結構模型并模擬橋梁結構可能受到的各種荷載,根據橋梁桁架在恒載加活載組合作用下的變形來設置預拱度。然后根據結構在最不利荷載組合作用下的內力值,對桿件進行受力檢算并設計節點板和進行節點板的檢算。最后進行橋墩的設計,選用重力式橋墩,設計制動墩的形式及截面尺寸,把桁架在支座處的反Sample TextSample TextSample Text力值和橋墩所受的各種附加力進行荷載組合,取最不利組合對制動墩進行檢算。 |

至尊木蟲 (文壇精英)
純純家族之長發MM
| Truss structure with steel truss bridge represented in various engineering design is more and more widely adopted, continuous steel truss bridge with its strong spanning ability, light weight, convenient manufacture, installation speed, short construction period and other advantages become the preferred solution to build large span bridge at. The design for the design and calculation of span of 3*120m under variable section of double-track railway continuous steel truss bridge.Design the design of the main structure and the braking pier. Firstly, the upper structure design, the main truss internode length is 12M, girder spacing of 11.2m, and high 14m in the fulcrum fulcrum truss, truss 25m. The main truss member selection box section, transverse connection adopts I-shaped cross-section, developed section size. And then establish the bridge structure model and various load simulation of bridge structure by using the finite element method, according to the deformation of bridge truss under constant load and live load under combined to set pre-camber. Then according to the internal forces of the structure under the most unfavorable combination of loads, stress calculation and design of gusset plate and gusset plate calculation of rod. Finally the bridge design, selection of gravity pier, form and the section size of the braking pier, the additional stress on the bearing truss by the Sample TextSample TextSample Text force value and the pier load combinations, the most unfavorable combination calculation of braking pier |

至尊木蟲 (文壇精英)
純純家族之長發MM
|
A steel truss bridge truss structure represented by the various types of engineering design is increasingly being adopted for its continuous steel truss bridge crossing ability, small weight, ease of manufacture, installation speed, short construction period, etc. become construction of large-span bridges the preferred solution. The design for the design calculations span of 3 * 120m of variable cross section under the deck wire Railway Continuous Steel Truss Bridge. The design is mainly for the upper structure and braking pier design. First, for the upper structure design, the length of the main truss section as 12m, truss spacing of 11.2m, side stringers pivot high 14m, high beam fulcrum 25m. Main truss rod selection box sections, connected by transverse-shaped cross-section, intended sectional dimensions. Then using the finite element method to build a bridge structure model and simulate the bridge structure may be subject to various loads, according to the bridge truss dead load plus live in deformation under load combinations to set camber. Then according to the structure in the most unfavorable load combination internal forces under the action of the force rod for inspecting calculation and design for gusset plate and gusset plate check calculation. Finally pier design, selection of gravity piers, pier design in the form of brake and cross-sectional dimension, the truss at the supports anti-Sample TextSample TextSample Text force value and the pier suffered various additional force load combinations, taking the most unfavorable combination pier for the brake check calculation. |

鐵桿木蟲 (著名寫手)



鐵桿木蟲 (小有名氣)

| 7 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 材料學碩318求調劑 +5 | February_Feb 2026-03-19 | 5/250 |
|
|---|---|---|---|---|
|
[考研] 一志愿中國海洋大學,生物學,301分,求調劑 +5 | 1孫悟空 2026-03-17 | 6/300 |
|
|
[考研] 307求調劑 +9 | 冷笙123 2026-03-17 | 9/450 |
|
|
[考研] 294求調劑材料與化工專碩 +14 | 陌の森林 2026-03-18 | 14/700 |
|
|
[考研] 0856調劑,是學校就去 +6 | sllhht 2026-03-19 | 7/350 |
|
|
[考研] 304求調劑 +3 | 曼殊2266 2026-03-18 | 3/150 |
|
|
[考研] 286求調劑 +6 | lemonzzn 2026-03-16 | 10/500 |
|
|
[考研] 317求調劑 +3 | 申子申申 2026-03-19 | 6/300 |
|
|
[考研] 346求調劑[0856] +3 | WayneLim327 2026-03-16 | 6/300 |
|
|
[考研] 0703化學 305求調劑 +4 | FY_yy 2026-03-14 | 4/200 |
|
|
[考研] 330求調劑 +3 | 小材化本科 2026-03-18 | 3/150 |
|
|
[考研] 材料專業求調劑 +5 | hanamiko 2026-03-18 | 5/250 |
|
|
[考研] 085600材料與化工 +5 | 安全上岸! 2026-03-16 | 5/250 |
|
|
[考研] 材料,紡織,生物(0856、0710),化學招生啦 +3 | Eember. 2026-03-17 | 9/450 |
|
|
[考研] 環境工程調劑 +8 | 大可digkids 2026-03-16 | 8/400 |
|
|
[考研] 277調劑 +5 | 自由煎餅果子 2026-03-16 | 6/300 |
|
|
[考研] 318求調劑 +3 | Yanyali 2026-03-15 | 3/150 |
|
|
[考研] 321求調劑 +5 | 大米飯! 2026-03-15 | 5/250 |
|
|
[考研] 中科大材料專碩319求調劑 +3 | 孟鑫材料 2026-03-13 | 3/150 |
|
|
[考研] 070303一志愿西北大學學碩310找調劑 +3 | d如愿上岸 2026-03-13 | 3/150 |
|