| 5 | 1/1 | 返回列表 |
| 查看: 669 | 回復: 2 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | ||
miaobobo510新蟲 (初入文壇)
|
[求助]
勞煩蟲友翻譯一下急需啊
|
|
|
A sol–gel process for the preparation of thick YAG:Ce3+ films has been developed. YAG:Ce3+ phosphor films with a typical yttrium aluminum garnet (YAG) photoluminescence (PL) profile were prepared successfully. Single phase YAG films with a maximum thickness of 2 lm were prepared in the present work. The refractive index of the YAG films prepared (1.85 @ 633 nm and 1.80 @ 1540 nm) was very close to that of YAG single crystal. It was confirmed that the PL efficiency of the prepared films was strongly related to the degree of YAG phase formation in the samples and the rate of YAG phase evolution strongly depended on the film thickness. To achieve high YAG:Ce3+ PL efficiency, a minimum 1.2 lm of thickness is necessary. It was also found that the optical quality of the YAG films decreased following the deposition and thermal annealing processes, probably as a result of the growth of YAG crystals inside. As an example of a compromise between high PL efficiency and good optical quality, prism coupling was achieved on a 30-layer planar waveguide sample annealed at 1000 C for 30 min. It was proved that this sample could support multiple waveguide modes at visible wavelengths and its propagation loss at 1540 nm was estimated at 4.2 dB/cm. The temperature quenching effect in the films of the present work was also measured, being the same as that of commercial YAG:Ce3+ phosphors with relatively high Ce concentration. The present technology is intended for YAG:Ce3+ phosphor films that may be applied on white LED and it may also be of benefit to any areas where YAG films may be of interest. |
銀蟲 (小有名氣)
| 一種制備厚YAG:Ce3+膜的溶膠-凝膠工藝被開發出來。 典型的釔鋁柘榴石熒光外形的YAG:Ce3+磷光膜被成功制備。目前介紹的工作制備了最大厚度2lm的單相釔鋁柘榴石。所制備的釔鋁柘榴石膜的折光率(1.85 @ 633 nm and 1.80 @ 1540 nm)非常接近于釔鋁柘榴石單晶體。我們制備的膜的發光效率被證實與樣品中釔鋁柘榴石的相形成和取決于膜厚度的釔鋁柘榴石的相演化率相密切相關。為了達到高YAG:Ce3+發光效率,最小厚度1.2lm是必要的。同時發現了釔鋁柘榴石膜的光學質量隨著沉積和熱處理過程而降低,可能是因?yàn)閮?nèi)部釔鋁柘榴石晶體的生長。作為一種在高發光效率和良好光學質量之間的折衷,在1000°C下煅燒了30分鐘的30層平面波導樣品中完成了鏡耦合。證明了這個樣品能夠支持在可見光波長下的多波導模型而且它在1540nm下的增殖損失被估計為4.2 dB/cm。在這項工作中,膜的溫度淬火效應也被測試,與相對高Ce濃度的商業YAG:Ce3+膜相同。目前的技術旨在可能用于白LED上YAG:Ce3+磷光膜,而且可能也有益于可能對釔鋁柘榴石膜感興趣的任何領域。 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 一志愿北京理工大學本科211材料工程294求調劑 +6 | mikasa的圍巾 2026-03-28 | 6/300 |
|
|---|---|---|---|---|
|
[碩博家園] 求調劑 330分 085600材料與化工 +3 | gqhhh 2026-03-22 | 3/150 |
|
|
[考研] 085600 材料與化工 329分求調劑 +10 | Mr. Z 2026-03-25 | 10/500 |
|
|
[考研] 322求調劑 +7 | 宋明欣 2026-03-27 | 7/350 |
|
|
[考研] 求調劑 +7 | 爭取九點睡 2026-03-28 | 8/400 |
|
|
[考研] 0703本科鄭州大學求調劑 +3 | nhj_ 2026-03-25 | 3/150 |
|
|
[考研] 291求調劑 +15 | hhhhxn.. 2026-03-23 | 21/1050 |
|
|
[考研]
|
孅華 2026-03-22 | 17/850 |
|
|
[考研] 265求調劑 +8 | 小木蟲085600 2026-03-27 | 8/400 |
|
|
[考研] 085600,材料與化工321分調劑 +4 | 大饞小子 2026-03-27 | 6/300 |
|
|
[考研] 求調劑,一志愿 南京航空航天大學大學 ,080500材料科學與工程學碩 +4 | @taotao 2026-03-26 | 5/250 |
|
|
[考研] 329求調劑 +7 | 鈕恩雪 2026-03-25 | 7/350 |
|
|
[考研]
|
鐘llll 2026-03-26 | 4/200 |
|
|
[考研] 321求調劑 +6 | Ymlll 2026-03-24 | 6/300 |
|
|
[考研] 【雙一流院校新能源、環境材料,材料加工與模擬招收大量調劑】 +4 | Higraduate 2026-03-22 | 8/400 |
|
|
[考研] 081700 調劑 267分 +11 | 迷人的哈哈 2026-03-23 | 11/550 |
|
|
[考研] 347求調劑 +4 | L when 2026-03-25 | 4/200 |
|
|
[考研] 0854電子信息求調劑 324 +4 | Promise-jyl 2026-03-23 | 4/200 |
|
|
[考研] B區考研調劑 +4 | yqdszhdap- 2026-03-22 | 5/250 |
|
|
[考研] 280分求調劑 一志愿085802 +4 | PUMPT 2026-03-22 | 7/350 |
|