| 5 | 1/1 | 返回列表 |
| 查看: 2926 | 回復: 18 | ||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | ||
小小鑫000鐵蟲 (小有名氣)
|
[求助]
用vasp優化Ni2團簇出現的問題! 已有1人參與
|
|
|
各位前輩,大家好: 最近用vasp優化Ni2團簇,將Ni2放到邊長為13的立方體盒子中,Ni,Ni 鍵長為2.42,KPOINTS,gamma下的kmesh不知道取多少, Automatic generation Gamma - - - 0.0 0.0 0.0 于是就分別取2到13進行KPOINTS的收斂性測試,取到9還正常,但沒有收斂,但從10開始,機器計算出現異常,如下:-------------------------------------------------------- JOBID: 46876.cn061 The job was started at Thu Mar 27 11:48:27 CST 2014 The job was running at cn012. k mesh = 10 x 10 x 10 running on 4 nodes distr: one band on 1 nodes, 4 groups vasp.5.2.12 26May11 complex POSCAR found type information on POSCAR Ni POSCAR found : 1 types and 2 ions LDA part: xc-table for Ceperly-Alder, standard interpolation POSCAR, INCAR and KPOINTS ok, starting setup FFT: planning ...( 1 ) WAVECAR not read -------------------------------------------------------------------------- mpirun noticed that process rank 0 with PID 16304 on node cn012 exited on signal 9 (Killed). -------------------------------------------------------------------------- real 1m4.034s user 0m14.805s sys 0m11.433s k mesh = 11 x 11 x 11 running on 4 nodes distr: one band on 1 nodes, 4 groups vasp.5.2.12 26May11 complex POSCAR found type information on POSCAR Ni POSCAR found : 1 types and 2 ions LDA part: xc-table for Ceperly-Alder, standard interpolation POSCAR, INCAR and KPOINTS ok, starting setup FFT: planning ...( 1 ) WAVECAR not read -------------------------------------------------------------------------- mpirun noticed that process rank 0 with PID 16324 on node cn012 exited on signal 9 (Killed). 。。。 這是怎么回事?望高手指導,感激不盡! |

木蟲 (正式寫手)
木蟲 (正式寫手)
鐵蟲 (小有名氣)

鐵蟲 (小有名氣)

| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|