| 5 | 1/1 | 返回列表 |
| 查看: 2591 | 回復: 5 | ||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | ||
qiaopeisheng銀蟲 (正式寫手)
|
[求助]
catalysis communications審稿意見回來了,被拒,大家看看還值得改投么? 已有4人參與
|
|
|
6月3號投了小cc,兩個月了審稿意見回來,一共三個審稿人,兩個拒掉一個大修,現在有點迷茫,不知道怎么辦了。 工作是關于紫外光催化的,Cu-TiO2的效應,表征到了單質銅的存在,還有顆粒效應。創新點有限,又是關于紫外光的,確實工作比較一般,拒掉也正常吧。意見里第一個非常嚴厲,第二個算是大修,第三個提了幾個意見然后拒掉了。大家看值得好好修改然后改投么? Reviewers' comments on your work have now been received. You will see that they have raised sufficient major issues with your paper such that I must reject it for publication in Catalysis Communications. For your guidance, I append the reviewers' comments below. Thank you for giving us the opportunity to consider your work. Yours sincerely, Angelika Brückner, PhD Editor Catalysis Communications Reviewers' comments: Reviewer #1: The paper describes the photocatalytic activity of Cu-modified mesoporous TiO2 materials for formaldehyde degradation to hydrogen. The authors pretend to have discovered novel photocatalytic materials, and argue about a possible size-dependency of the activity which maximizes at some Cu loading. In reality, several papers have already described what the authors report (for example: J. Yu, Y. Hai, M. Jaroniec. Journal of Colloid and Interface Science, 357 (2011) 223-228; and, even more importantly, Anna V. Korzhak Journal of Photochemistry and Photobiology A: Chemistry 198 (2008) 126-134). There is not one detail that can be considered novel, and the discovery that metallic Cu is the active phase is based on a quite doubtful ex-situ procedure (DDT protection, when it's known that DDT can reduce metallic cations if used in excess to form several metal-thiol species). There are doubts whether this paper can be published anywhere, since it reports things that have been described in the literature already. Reviewer #2: The authors have completed an interesting study of the Cu/TiO2 system in relation to photocatalytic H2 production from aqueous formaldehyde solutions. I believe that this manuscript could be considered for publication pending the following changes. 1) The english in the introduction section is loose and of a conversation style rather than a scientific style. For example, the first sentences should be modified to read "H2 is expected to be one of the most important energy carriers in the future. Currently, approximately 95% of H2 is produced from hydrocarbons and coal." 2) The authors need to give more information about the formaldehyde solution they are using. Was the 2 wt.% solution of formaldehyde obtained by dilution 37 wt.% formaldehyde (which also contains methanol as a stabiliser), or was it obtained by dissolving paraformaldehyde in water? 3) The reduction of Cu(II) to Cu metal occurs in the absence of TiO2. Regarding the synthesis of Cu/TiO2, what evidence is there that all Cu(II) in solution is deposited on the TiO2? The authors present Cu 2p XPS data. but no supporting quantification information about the relative surface abundances of Cu, Ti, O, C and S. Does the optimum 1 wt.% nominal loading actually correspond to a 1 wt.% actual loading. XPS or XRF Cu/Ti ratios would have been useful in this regard. 4) UV-Vis absorbance spectra would have been useful for probing the presence of Cu(II), Cu(I) or Cu(0) on the surface of TiO2. Much of the evidence in this paper to confirm the presence of Cu metal was performed in the presence of a capping agent, dodecanethiol. I would like to see XPS and TEM images for the or the Cu/TiO2 photocatalysts in the absence of the capping agent as a comparison, or to at least have some text describing that data. Overall, this is good work that needs a bit more fine tuning and elaboration before publication. If the authors are willing to consider and the address the above points, I think this paper will be acceptable for publication in CATCOM. Reviewer #3: The authors report about a H2 evolution reaction from aqueous formaldehyde over in-situ deposited copper nanoparticles onto mesoporous TiO2. Unfortunately, I cannot recommend the present manuscript for publishing in CATCOM due to the following reasons: 1. In my opinion, the reported results lack in innovative value, since such UV-light induced H2 generation over similar photocatalytic systems have been published earlier, also with focus on the Cu salt concentration and the resulting particle sizes (see e.g. P. Gomathisankar et al. "Enhanced photocatalytic hydrogen production from aqueous methanol solution using ZnO with simultaneous photodeposition of Cu", Int. J. Hydr. Ener. 38 (2013) 11840-11846 or Choi et al. "Hydrogen production from methanol/water decomposition in a liquid photosystem using the anatase structure of Cu loaded TiO2", Int. J. Hydr. Ener., 32 (2007) 3841-3848). Concerning the practical application, it would be interesting to test also the visible-light activity e.g. by use of optical filters as the Cu nanoparticles exhibit plasmonic absorption and might be used as visible-light photocatalyst as well (demonstrated in Gomathisankar et al.). 2. The manuscript is not well structured as within the first part of photoactivities the authors often refer to the structural properties of the catalysts described in the second part. Besides, English spelling and grammar should be improved as well. 3. The light absorption properties (UV-vis spectra) of the catalysts would be interesting as well, especially a comparison of the protected (DDT) and non-protected samples in order to demonstrate the effect of absorption changes under catalytic conditions. The data of at least one unprotected sample should also be added to the XRD and XPS results. In case of XPS, often lower binding energies are detected due to a fast reduction of Cu(II) by introduction of the sample into the high vacuum chamber (see Irie et al. "Visible light-sensitive Cu (II)-grafted TiO2 photocatalysts: activities and X-ray absorption fine structure analyses." The Journal of Physical Chemistry C 2009, 113 (24), 10761-10766). 4. At last, from my point of view one should focus on the main results, so that minor important facts such as the influence of anion are mentioned only in the supporting information. |
榮譽版主 (文壇精英)
木蟲 (職業作家)

版主 (職業作家)
努力的蟲子

| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 一志愿鄭州大學,080500學碩,總分317分求調劑 +8 | 舉個栗子oi 2026-03-24 | 9/450 |
|
|---|---|---|---|---|
|
[考研] 2026年華南師范大學歡迎化學,化工,生物,生醫工等專業優秀學子加入! +3 | llss0711 2026-03-28 | 6/300 |
|
|
[考研] 321求調劑 +7 | 璞玉~~ 2026-03-25 | 8/400 |
|
|
[考研] 289求調劑 +13 | 新時代材料 2026-03-27 | 13/650 |
|
|
[考研] 生物學學碩,一志愿湖南大學,初試成績338 +6 | YYYYYNNNNN 2026-03-26 | 7/350 |
|
|
[考研] 311(085601)求調劑 +4 | liziyeyeye 2026-03-28 | 4/200 |
|
|
[考研] 壓國家一區線,求導師收留,有恩必謝! +7 | 迷人的哈哈 2026-03-28 | 7/350 |
|
|
[考研] 320分,材料與化工專業,求調劑 +9 | 一定上岸aaa 2026-03-27 | 13/650 |
|
|
[考研] 0703化學求調劑 +9 | 奶油草莓. 2026-03-22 | 10/500 |
|
|
[考研] 085600 286分 材料求調劑 +7 | 麻辣魷魚 2026-03-27 | 8/400 |
|
|
[材料工程] 一志愿C9材料與化工專業總分300求調劑 +8 | 曼111 2026-03-24 | 9/450 |
|
|
[考研] 材料292調劑 +12 | 橘頌思美人 2026-03-23 | 12/600 |
|
|
[考研] 08開頭275求調劑 +4 | 拉誰不重要 2026-03-26 | 4/200 |
|
|
[考研] 085600,材料與化工321分調劑 +4 | 大饞小子 2026-03-27 | 6/300 |
|
|
[考研] 考研調劑 +9 | 小蠟新筆 2026-03-26 | 9/450 |
|
|
[考研] 材料求調劑 +5 | .m.. 2026-03-25 | 5/250 |
|
|
[考研] 286求調劑 +4 | lim0922 2026-03-26 | 4/200 |
|
|
[考研] 332求調劑 +6 | 032500 2026-03-25 | 6/300 |
|
|
[考研]
|
黃粱一夢千年 2026-03-24 | 3/150 |
|
|
[考研] 335求調劑 +4 | yuyu宇 2026-03-23 | 5/250 |
|