24小時熱門版塊排行榜

返回列表

轉身丶忘不掉

銅蟲 (小有名氣)

應助: 1 (幼兒園)
金幣: 31.7
帖子: 173
在線: 40.2小時
蟲號: 3065945
注冊: 2014-03-18
專業: 有機合成

[求助] 英語論文翻譯，求助！大神幫幫忙！

3.4. Porosity of PLGA/PHBV scaffold
Some parameters related to the scaffolds such as porosity,average volume, pore volume per gram and density were exhibited in Fig. 4. The porosities of three kinds of scaffold were slightly below the pre-set value. The porosity of pure PLGA scaffolds reached to 81.830±1.723%, which was close to that of PLGA/30% PHBV scaffolds (81.273±2.192%). When the PHBV microspheres content came to 50%, the porosity of the scaffolds still showed no statistical significant when compared with that of pure PLGA scaffolds. The result demonstrated that the PHBV microspheres had little influence on the porosity of PLGA scaffold. With the increase of PHBV microspheres, the density of scaffolds increased accordingly (from 0.17290±0.00461 of pure PLGA to 0.25160±0.03828 of PLGA/50% PHBV). At the same time, the pore volume per gram decreased with the increase of PHBV microspheres. The above two graphs coincided well with each other. Because of the augment of density, the volume of every gram of the scaffolds should have reduced.

回復此樓

» 猜你喜歡

26考研一志愿中國石油大學(華東)305分求調劑已經有4人回復
286求調劑已經有5人回復
材料與化工（0856）304求 B區 調劑已經有3人回復
268求調劑已經有8人回復
265求調劑已經有14人回復
350 本科985求調劑，求老登收留已經有3人回復
【考研調劑】化學專業 281分，一志愿四川大學，誠心求調劑已經有9人回復
初試 317 已經有3人回復
279分求調劑一志愿211 已經有15人回復
279求調劑已經有4人回復

1樓 2014-12-09 22:18:55

已閱關注TA 給TA發消息送TA紅花 TA的回帖

LifePursuit

木蟲之王 (文學泰斗)

翻譯EPI: 31
應助: 272 (大學生)
金幣: 70383.9
散金: 5156
紅花: 104
沙發: 17
帖子: 126009
在線: 2961.6小時
蟲號: 2406939
注冊: 2013-04-08
專業: 聚合物共混與復合材料

【答案】應助回帖

這個你不用給金幣了，因?yàn)槊菜瓢l(fā)現還有人求助這個翻譯，我已經幫忙翻譯了。現在貼在下面，供你參考。

3.4. PLGA/PHBV 支架材料的孔隙率
圖4展示了與支架材料相關的一些參數，如孔隙率、平均體積、克孔體積以及密度等。三種支架材料的孔隙率均略低于預設值。純PLGA支架材料的孔隙率達到81.830±1.723%，非常接近PLGA/30% PHBV支架材料的孔隙率（81.273±2.192%）。當PHBV微球含量達到50%時，支架材料的孔隙率與純PLGA支架材料的孔隙率相比仍然沒有顯著的統計學差異（這里，原文掉了一個詞difference，考慮上下文酌情翻譯出）。這一結果表明PHBV微球?qū)LGA支架材料孔隙率的影響甚微。隨著PHBV微球含量的增加，支架材料的密度相應增大（從純PLGA支架材料的0.17290±0.00461增大到PLGA/50% PHBV支架材料的0.25160±0.03828）。同時，克孔體積隨著PHBV微球含量的增加而降低。以上兩圖相互吻合得十分好。由于密度的增大，支架材料的克體積應該有所降低。

贊一下

回復此樓

2樓2014-12-14 19:37:38

已閱關注TA 給TA發消息送TA紅花 TA的回帖

相關版塊跳轉 我要訂閱樓主轉身丶忘不掉的主題更新