版塊導航: 正在加載中...

登錄注冊

應《網絡安全法》要求，自2017年10月1日起，未進行實名認證將不得使用互聯網跟帖服務。為保障您的帳號能夠正常使用，請盡快對帳號進行手機號驗證，感謝您的理解與支持！

24小時熱門版塊排行榜

返回列表

本帖產生 1 個翻譯EPI ，點擊這里進行查看

hellen7256

木蟲 (小有名氣)

應助: 0 (幼兒園)
金幣: 2980
散金: 3
帖子: 88
在線: 33.7小時
蟲號: 660055
注冊: 2008-11-22
專業: 無機非金屬類電介質與電解

[求助] 求助翻譯英文文獻，請大俠幫助啊。

Based on this work, the composition ratios of the geopolymers can be designed according to the NaA zeolite composition, and the expected zeolites can then be obtained through the use of appropriate hydrothermal treatment conditions [15-16]. In this study, we first prepared inorganic membranes of the Al2O3-2SiO2-Na2O geopolymers using a pre-forming process and then transformed this material into self-supporting NaA zeolite membranes using a hydrothermal procedure. These membranes were found to be different from traditional zeolite membranes, which are primarily supported by crystalline materials (NaA zeolite). Through the hydrothermal process, geopolymers can be transformed into zeolite crystals, as was demonstrated by the results from the XRD and SEM analyses. The transformation ratio of the NaA zeolite is approximately 81%, as determined through the concentration of residual Na ions in the water after the hydrothermal process [16].
The characterization of the membrane is essential for the evaluation of the quality of the synthesized membrane. In this study, the measured compressive strength of the Al2O3-2SiO2-Na2O geopolymer was 49.1 MPa. After the hydrothermal treatment procedure, the compressive strength of the specimen achieved values as high as 57.6 MPa, which can satisfy the requirements for traditional inorganic membranes. The microstructure of the self-supporting zeolite membranes was characterized through scanning electron microscopy (SEM) and N2 adsorption experiments (Table 1). Fig. 3 presents the SEM images of the geopolymer and the hydrothermal sample and reveals that the NaA zeolite crystals synthesized from the geopolymers were randomly grown to a size of 1 µm. Fig. 3a presents SEM images of the top surface of the as-prepared Al2O3-2SiO2-Na2O geopolymer, and Fig. 3b shows SEM images of the top surfaces of the self-supporting membranes after the hydrothermal process. The crystalline NaA zeolites in Fig. 3b are dense and exhibit good crystallinity. By comparing the top surface and the cross section of the hydrothermal sample (see Fig. 3d), the density and crystallinity of the top-surface region are obviously greater than those in the inner region. The loose inner structure of the self-supporting membranes is beneficial for increased flux, and the dense surface is beneficial for an improved separation effect [1, 11, 16].

回復此樓

» 猜你喜歡

287求調劑已經有5人回復
22408 344分求調劑一志愿華電計算機技術 已經有3人回復
289求調劑已經有3人回復
317求調劑已經有10人回復
廣西大學家禽遺傳育種課題組2026年碩士招生（接收計算機專業調劑）已經有3人回復
學校已經提交到NSFC，還能修改嗎？已經有8人回復
08工學調劑已經有5人回復
281求調劑（0805）已經有25人回復
085600材料與化工已經有6人回復
265求調劑已經有8人回復

1樓 2015-06-16 22:35:21

已閱回復此樓關注TA 給TA發消息送TA紅花 TA的回帖

baoshanqiu

至尊木蟲 (著名寫手)

翻譯EPI: 204
應助: 103 (高中生)
金幣: 15293.5
紅花: 41
帖子: 1611
在線: 431.6小時
蟲號: 3856202
注冊: 2015-05-08
性別: GG
專業: 胃腸道免疫相關疾病

【答案】應助回帖

★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
hellen7256: 金幣+35, 翻譯EPI+1, ★★★★★最佳答案 2015-06-17 21:43:23

以此研究為基礎，地質聚合物的組成比率可根據NaA沸石組成來設計，因此采用適當?shù)乃疁靥幚項l件[15-16]就可得到預期的沸石。本研究中，我們首先預形成過程制備了 Al2O3-2SiO2-Na2O地質聚合物的無機膜，再用水溫處理將這種材料轉化為自身支持的NaA 沸石膜。這些膜不同于傳統的沸石膜，它們主要由晶體材料（NaA 沸石）支持。經水溫處理，地質聚合物可以轉化為沸石晶體，如X射線衍射和掃描電鏡分析結果所示。由水溫處理后測定水中殘留的Na離子濃度[16]得知，NaA 沸石的轉化率大約為81%。
膜的特性對于評價合成膜的質量至關重要。本研究中，測得Al2O3-2SiO2-Na2O地質聚合物的耐壓強度是 49.1 MPa。水溫處理后，樣品的耐壓強度達到57.6 MPa，可以達到傳統的無機膜要求。用掃描電鏡（SEM）和N2吸附實驗研究了自身支持沸石膜的微結構（表1）。圖3為地質聚合物和水溫樣品的SEM影像，表明由地質聚合物合成的NaA 沸石晶體隨機的增長到1微米大小，圖3a 代表制備的 Al2O3-2SiO2-Na2O地質聚合物上表面SEM影像，圖3b 為水溫處理后自身支持膜上表面的SEM影像。圖3b中晶體NaA 沸石是致密的，顯示良好的晶體性。比較水溫樣品的上表面和橫切面（見圖3d),可見上表面區域的致密性和晶體性明顯要高于內部區域。自身支持膜疏松的內部結構有益于增加流量，而表面致密有益于提高分離效率[1,11,16].

贊一下(1人)

回復此樓

2樓2015-06-17 05:36:57

已閱回復此樓關注TA 給TA發消息送TA紅花 TA的回帖

相關版塊跳轉 我要訂閱樓主 hellen7256 的主題更新