| 24小時熱門版塊排行榜 |
| 5 | 1/1 | 返回列表 |
| 查看: 978 | 回復: 4 | |||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | |||
明子眸銅蟲 (小有名氣)
|
[求助]
中譯英:請各位蟲友幫忙指點,小弟不勝感謝!
|
||
|
由圖可知,在SBF中浸泡1周后,涂層表面開始降解,表面粗糙,出現一些微孔。在SBF中浸泡2周后,涂層表面逐漸降解。3周后,涂層表面發現魚鱗骨狀組織。4周后,涂層表面進一步降解,出現大片的蜂窩狀微孔。5周后,涂層表面進一步降解,露出疏松的枝狀組織。6周后,涂層表面出現較大的孔洞。涂層中的微孔和孔洞有利于增加涂層與模擬體液的接觸面積,促進涂層的進一步降解。 我的譯文: It is seen that some micro-pores appear on surface of the coating which soaked in SBF for 1 week. After 2 weeks, the coating degraded gradually. After 3 weeks, some fish bone-like tissues are found on the surface of the coating. After 4 weeks, the coating degrade further. After 5 weeks, the coating is further degraded and exposed loose structure like dendrite. 6 weeks later, the surface of the coating appears some large holes. Microporous and holes can increase the contact area of the surface in SBF and promote degradation of the coating. 感覺很別扭,請各位蟲友幫忙分析一下!小弟不勝感謝 |

木蟲 (正式寫手)
|
做了一些修改,翻譯過程中有些信息出現丟失現象,還有就是時態問題,描述實驗結果時一般用一般現在時且在整個描述過程中時態保持一致。省略重復的詞義,但不能省略強調的部分。下面是修改好的版本。 It can be seen from the figure that some micro-holes appear on the coarse surface of the coating which soaked in SBF for 1 week. After 2 weeks, the coating degrades gradually. After 3 weeks, some fish bone-like tissues are found on the surface. After 4 weeks, the coating surface degrades further,large blocks of honeycomb-like micro-holes appear. After 5 weeks, the coating surface further degrades and expose loose structure like dendrite. 6 weeks later, some large holes appears on the surface of the coating. Microporous and holes are helpful to increase the contact area between the coating and the simulated liquid, and promote the further degradation of the coating. |

銅蟲 (小有名氣)

木蟲 (正式寫手)
|
It can be seen from the figure that some micro-holes appear on the coarse surface of the coating which soaked in SBF for 1 week;2 weeks later, the coating degrades gradually; 3 weeks, some fish bone-like tissues are found on the surface; 4 weeks, the coating surface degrades further,large blocks of honeycomb-like micro-holes appear; 5 weeks, the coating surface further degrades and expose loose structure like dendrite; 6 weeks, some large holes appear on the surface of the coating. Microporous and holes are helpful to increase the contact area between the coating and the simulated liquid, and promote the further degradation of the coating. 這樣是不是好一點 |

銅蟲 (小有名氣)

| 5 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|