| 6 | 1/1 | 返回列表 |
| 查看: 710 | 回復: 5 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
wdren0623金蟲 (小有名氣)
研究僧
|
[求助]
將以下中文翻譯成英文,謝謝,急急急!
|
|
|
1、從而在浸漬的過程中未能充分負載在載體表面,使得Ni粒子量不足,未能達到應有的催化效果,活性下降。 2、主要是由于油相過多同時用于維系“水核”表面膜的CTAB過少,使得該微乳體系的穩定性變差,Ni粒子易于析出、團聚。當V值逐漸增大直至5:5時,由于油相偏少,體系中形成的“水核”較大,其中容納Nit粒子較多,碰撞程度加劇,從而增大了從體系中析出的Ni的體積,降低了Ni的催化效率。 3、V=1:7和2:8時,催化劑的催化活性和V=3:5差別不大,但在最佳活性點選擇性相對較低,因此選擇V=3:5為CTAB與正丁醇的最佳配比。 |
至尊木蟲 (著名寫手)
|
1、從而在浸漬的過程中未能充分負載在載體表面,使得Ni粒子量不足,未能達到應有的催化效果,活性下降。 Therefore during the extraction process, it failed to sufficiently coat the surface of the carrier, led to inadequate amount of N-particles (incorporated) to provide the catalytic activity that we had wished for 2、主要是由于油相過多同時用于維系“水核”表面膜的CTAB過少,使得該微乳體系的穩定性變差,Ni粒子易于析出、團聚。當V值逐漸增大直至5:5時,由于油相偏少,體系中形成的“水核”較大,其中容納Nit粒子較多,碰撞程度加劇,從而增大了從體系中析出的Ni的體積,降低了Ni的催化效率。 This is mainly because there was too much oil phase in the system and too few CTAB to sustain the water core structure, which compromised the stability of the microemulsion and N-particles tend to aggregate and become phase separated. When the V value was gradually increased to 5:5, the system started to form large water cores due to reduced oil phase, more N-particles were entrapped, which led to more fractions of N-particles leaked out as a result of increased collision amount the particles themselves, reduced the catalytic activity of the N-particles. 3、V=1:7和2:8時,催化劑的催化活性和V=3:5差別不大,但在最佳活性點選擇性相對較低,因此選擇V=3:5為CTAB與正丁醇的最佳配比。 3. When V=1:7 to 1:4 (應該用最小公約數,而不是2:8), the catalytic activity of the product( or catalyst) was not much different from that of V=3:5, however, the selectivity at the point the most catalytic activity was achieved was relatively poor, therefore the V=3:5 of CTAB:n-butanol was selected as the optimal ratio. |

金蟲 (小有名氣)
研究僧
至尊木蟲 (著名寫手)

至尊木蟲 (著名寫手)

金蟲 (小有名氣)
研究僧
| 6 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 286分人工智能專業請求調劑愿意跨考! +3 | lemonzzn 2026-03-17 | 3/150 |
|
|---|---|---|---|---|
|
[考研] 材料學碩318求調劑 +5 | February_Feb 2026-03-19 | 5/250 |
|
|
[考研]
|
不想起名字112 2026-03-19 | 3/150 |
|
|
[考研] 0817 化學工程 299分求調劑 有科研經歷 有二區文章 +18 | rare12345 2026-03-18 | 18/900 |
|
|
[考研] 化學求調劑 +3 | 臨澤境llllll 2026-03-17 | 4/200 |
|
|
[考研] 本科鄭州大學物理學院,一志愿華科070200學碩,346求調劑 +4 | 我不是一根蔥 2026-03-18 | 4/200 |
|
|
[考研] 一志愿武理材料305分求調劑 +5 | 想上岸的鯉魚 2026-03-18 | 6/300 |
|
|
[考研] 化學工程321分求調劑 +15 | 大米飯! 2026-03-15 | 18/900 |
|
|
[考研] 0703化學求調劑 總分331 +3 | ZY-05 2026-03-13 | 3/150 |
|
|
[考研] 材料,紡織,生物(0856、0710),化學招生啦 +3 | Eember. 2026-03-17 | 9/450 |
|
|
[考研] 265求調劑 +3 | 梁梁校校 2026-03-17 | 3/150 |
|
|
[基金申請] 被我言中:新模板不強調格式了,假專家開始管格式了 +4 | beefly 2026-03-14 | 4/200 |
|
|
[考研] 268求調劑 +8 | 一定有學上- 2026-03-14 | 9/450 |
|
|
[考研] 一志愿南京大學,080500材料科學與工程,調劑 +4 | Jy? 2026-03-16 | 4/200 |
|
|
[考研] 283求調劑 +3 | 聽風就是雨; 2026-03-16 | 3/150 |
|
|
[考研] 304求調劑 +3 | 曼殊2266 2026-03-14 | 3/150 |
|
|
[考研] 0856求調劑 +3 | 劉夢微 2026-03-15 | 3/150 |
|
|
[考研] 085601材料工程315分求調劑 +3 | yang_0104 2026-03-15 | 3/150 |
|
|
[考研] 288求調劑 +4 | 奇點0314 2026-03-14 | 4/200 |
|
|
[考研] 290求調劑 +3 | ADT 2026-03-13 | 3/150 |
|