| 5 | 1/1 | 返回列表 |
| 查看: 728 | 回復: 5 | ||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | ||
| 當前只顯示滿足指定條件的回帖,點擊這里查看本話題的所有回帖 | ||
wdren0623金蟲 (小有名氣)
研究僧
|
[求助]
將以下中文翻譯成英文,謝謝,急急急!
|
|
|
1、從而在浸漬的過程中未能充分負載在載體表面,使得Ni粒子量不足,未能達到應有的催化效果,活性下降。 2、主要是由于油相過多同時用于維系“水核”表面膜的CTAB過少,使得該微乳體系的穩定性變差,Ni粒子易于析出、團聚。當V值逐漸增大直至5:5時,由于油相偏少,體系中形成的“水核”較大,其中容納Nit粒子較多,碰撞程度加劇,從而增大了從體系中析出的Ni的體積,降低了Ni的催化效率。 3、V=1:7和2:8時,催化劑的催化活性和V=3:5差別不大,但在最佳活性點選擇性相對較低,因此選擇V=3:5為CTAB與正丁醇的最佳配比。 |
至尊木蟲 (著名寫手)

至尊木蟲 (著名寫手)
|
1、從而在浸漬的過程中未能充分負載在載體表面,使得Ni粒子量不足,未能達到應有的催化效果,活性下降。 Therefore during the extraction process, it failed to sufficiently coat the surface of the carrier, led to inadequate amount of N-particles (incorporated) to provide the catalytic activity that we had wished for 2、主要是由于油相過多同時用于維系“水核”表面膜的CTAB過少,使得該微乳體系的穩定性變差,Ni粒子易于析出、團聚。當V值逐漸增大直至5:5時,由于油相偏少,體系中形成的“水核”較大,其中容納Nit粒子較多,碰撞程度加劇,從而增大了從體系中析出的Ni的體積,降低了Ni的催化效率。 This is mainly because there was too much oil phase in the system and too few CTAB to sustain the water core structure, which compromised the stability of the microemulsion and N-particles tend to aggregate and become phase separated. When the V value was gradually increased to 5:5, the system started to form large water cores due to reduced oil phase, more N-particles were entrapped, which led to more fractions of N-particles leaked out as a result of increased collision amount the particles themselves, reduced the catalytic activity of the N-particles. 3、V=1:7和2:8時,催化劑的催化活性和V=3:5差別不大,但在最佳活性點選擇性相對較低,因此選擇V=3:5為CTAB與正丁醇的最佳配比。 3. When V=1:7 to 1:4 (應該用最小公約數,而不是2:8), the catalytic activity of the product( or catalyst) was not much different from that of V=3:5, however, the selectivity at the point the most catalytic activity was achieved was relatively poor, therefore the V=3:5 of CTAB:n-butanol was selected as the optimal ratio. |

金蟲 (小有名氣)
研究僧
至尊木蟲 (著名寫手)

| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 322求調劑 +3 | 宋明欣 2026-03-27 | 3/150 |
|
|---|---|---|---|---|
|
[考研] 求調劑 +4 | 零八# 2026-03-27 | 4/200 |
|
|
[考研] 一志愿南昌大學324求調劑 +3 | hanamiko 2026-03-27 | 3/150 |
|
|
[考研] 材料292調劑 +12 | 橘頌思美人 2026-03-23 | 12/600 |
|
|
[考研] 085601 材料工程 313分 求調劑 +5 | Ong3 2026-03-27 | 5/250 |
|
|
[考研] 一志愿吉大071010,316分求調劑 +3 | xgbiknn 2026-03-27 | 3/150 |
|
|
[考研] 調劑求收留 +7 | 果然有我 2026-03-26 | 7/350 |
|
|
[考研] 一志愿北化求調劑 +3 | Jsman 2026-03-22 | 3/150 |
|
|
[考研] 327求調劑 +7 | prayer13 2026-03-23 | 7/350 |
|
|
[考研] 0703化學求調劑 +3 | 丹青奶蓋 2026-03-26 | 5/250 |
|
|
[考研]
|
WWW西西弗斯 2026-03-24 | 8/400 |
|
|
[考研] 085600 材料與化工 329分求調劑 +9 | Mr. Z 2026-03-25 | 9/450 |
|
|
[考研] 0854電子信息求調劑 +7 | α____ 2026-03-22 | 9/450 |
|
|
[考研] 食品專碩 一志愿雙一流 328 +3 | xiaom99 2026-03-21 | 4/200 |
|
|
[考研] 求調劑 +7 | 十三加油 2026-03-21 | 7/350 |
|
|
[考研] 384求調劑 +3 | 子系博 2026-03-22 | 6/300 |
|
|
[考研] 生物學一志愿985,分?jǐn)?shù)349求調劑 +6 | zxts12 2026-03-21 | 9/450 |
|
|
[考研] 求調劑 +5 | Zhangbod 2026-03-21 | 7/350 |
|
|
[考研] 求助 +5 | 夢里的無言 2026-03-21 | 6/300 |
|
|
[考研] 085601調劑 358分 +3 | zzzzggh 2026-03-20 | 4/200 |
|