| 6 | 1/1 | 返回列表 |
| 查看: 713 | 回復: 5 | |||
| 本帖產生 1 個 翻譯EPI ,點擊這里進行查看 | |||
wdren0623金蟲 (小有名氣)
研究僧
|
[求助]
將以下中文翻譯成英文,謝謝,急急急!
|
||
|
1、從而在浸漬的過程中未能充分負載在載體表面,使得Ni粒子量不足,未能達到應有的催化效果,活性下降。 2、主要是由于油相過多同時用于維系“水核”表面膜的CTAB過少,使得該微乳體系的穩定性變差,Ni粒子易于析出、團聚。當V值逐漸增大直至5:5時,由于油相偏少,體系中形成的“水核”較大,其中容納Nit粒子較多,碰撞程度加劇,從而增大了從體系中析出的Ni的體積,降低了Ni的催化效率。 3、V=1:7和2:8時,催化劑的催化活性和V=3:5差別不大,但在最佳活性點選擇性相對較低,因此選擇V=3:5為CTAB與正丁醇的最佳配比。 |
至尊木蟲 (著名寫手)
|
1、從而在浸漬的過程中未能充分負載在載體表面,使得Ni粒子量不足,未能達到應有的催化效果,活性下降。 Therefore during the extraction process, it failed to sufficiently coat the surface of the carrier, led to inadequate amount of N-particles (incorporated) to provide the catalytic activity that we had wished for 2、主要是由于油相過多同時用于維系“水核”表面膜的CTAB過少,使得該微乳體系的穩定性變差,Ni粒子易于析出、團聚。當V值逐漸增大直至5:5時,由于油相偏少,體系中形成的“水核”較大,其中容納Nit粒子較多,碰撞程度加劇,從而增大了從體系中析出的Ni的體積,降低了Ni的催化效率。 This is mainly because there was too much oil phase in the system and too few CTAB to sustain the water core structure, which compromised the stability of the microemulsion and N-particles tend to aggregate and become phase separated. When the V value was gradually increased to 5:5, the system started to form large water cores due to reduced oil phase, more N-particles were entrapped, which led to more fractions of N-particles leaked out as a result of increased collision amount the particles themselves, reduced the catalytic activity of the N-particles. 3、V=1:7和2:8時,催化劑的催化活性和V=3:5差別不大,但在最佳活性點選擇性相對較低,因此選擇V=3:5為CTAB與正丁醇的最佳配比。 3. When V=1:7 to 1:4 (應該用最小公約數,而不是2:8), the catalytic activity of the product( or catalyst) was not much different from that of V=3:5, however, the selectivity at the point the most catalytic activity was achieved was relatively poor, therefore the V=3:5 of CTAB:n-butanol was selected as the optimal ratio. |

金蟲 (小有名氣)
研究僧
至尊木蟲 (著名寫手)

至尊木蟲 (著名寫手)

金蟲 (小有名氣)
研究僧
| 6 | 1/1 | 返回列表 |
| 最具人氣熱帖推薦 [查看全部] | 作者 | 回/看 | 最后發表 | |
|---|---|---|---|---|
|
[考研] 一志愿吉林大學材料學碩321求調劑 +9 | Ymlll 2026-03-18 | 12/600 |
|
|---|---|---|---|---|
|
[考研] 286分人工智能專業請求調劑愿意跨考! +3 | lemonzzn 2026-03-17 | 3/150 |
|
|
[考研] 生物學調劑招人。! +3 | 山海天嵐 2026-03-17 | 4/200 |
|
|
[考研] 286求調劑 +6 | lemonzzn 2026-03-16 | 10/500 |
|
|
[考研] 一志愿中海洋材料工程專碩330分求調劑 +7 | 小材化本科 2026-03-18 | 7/350 |
|
|
[考研] 274求調劑 +6 | S.H1 2026-03-18 | 6/300 |
|
|
[考研] 一志愿華中科技大學,080502,354分求調劑 +4 | 守候夕陽CF 2026-03-18 | 4/200 |
|
|
[考研] 344求調劑 +6 | knight344 2026-03-16 | 7/350 |
|
|
[考研] 311求調劑 +6 | 26研0 2026-03-15 | 6/300 |
|
|
[考研] 070300化學319求調劑 +6 | 錦鯉0909 2026-03-17 | 6/300 |
|
|
[考研] 280求調劑 +6 | 咕嚕曉曉 2026-03-18 | 7/350 |
|
|
[考研] 環境工程調劑 +8 | 大可digkids 2026-03-16 | 8/400 |
|
|
[碩博家園] 湖北工業大學 生命科學與健康學院-課題組招收2026級食品/生物方向碩士 +3 | 1喜春8 2026-03-17 | 5/250 |
|
|
[考研] 考研化學學碩調劑,一志愿985 +4 | 張vvvv 2026-03-15 | 6/300 |
|
|
[考研] [導師推薦]西南科技大學國防/材料導師推薦 +3 | 尖角小荷 2026-03-16 | 6/300 |
|
|
[考研] 318求調劑 +3 | Yanyali 2026-03-15 | 3/150 |
|
|
[考研] 070303 總分349求調劑 +3 | LJY9966 2026-03-15 | 5/250 |
|
|
[考研] 0703 物理化學調劑 +3 | 我可以上岸的對?/a> 2026-03-13 | 5/250 |
|
|
[考研] 288求調劑 +4 | 奇點0314 2026-03-14 | 4/200 |
|
|
[考研] 一志愿哈工大材料324分求調劑 +5 | 閆旭東 2026-03-14 | 5/250 |
|